112842
Service Bulletin/Repair Instructions
BOLT - HEX FLANGE HEAD
Vehicle report
2025 ALFA ROMEO STELVIO
Service bulletins
26 bulletinsTechnical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
2623000037 REV.A
Service Bulletin/Repair Instructions
Condensation Or Water Infiltration In Headlights, Daytime Running Lights (DRL), Turn Signals, Fog Lights, Taillights. Rev A
S2623000037
Service Bulletin/Repair Instructions
Condensation Or Water Infiltration In Headlights, Daytime Running Lights (DRL), Turn Signals, Fog Lights, Taillights.
01-001-26
Service Bulletin/Repair Instructions
Oil Change Monitor Displaying Prematurely Customers may experience the following: ● The oil change light illuminated on the dash shortly after taking delivery of the vehicle within 6,437 Km (4,000 miles) This bulletin involves resetting the oil life monitor and if necessary changing the engine oil and filter.
S2621000003 REV.A
Service Bulletin/Repair Instructions
The vehicle will exhibit a service transmission/check engine warning indicator for the following transmission models: 845RE, 8HP45, 850RE, 8HP50, 8HP70, 8HP75, 8HP75-PHEV, 8HP75-LCV, 8HP90, 8HP95. Transmissions may exhibit the following diagnostic codes: P07E4, P1DB2, P0716, P1B14, P0733, P1D90, P1DB7, P1B13.
23-005-26
Service Bulletin/Repair Instructions
Windshield Wiper Blade Maintenance Customers may experience one or more of the following: SYMPTOM: ● Wiper blades that chatter/streak/jump/skip/smear or make noise while traveling across the windshield. . No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of FCA US LLC.
S2607000003
Service Bulletin/Repair Instructions
GMET4 DOHC Water Pump Coolant Leak Inspection
08-394-25 REV. A
Service Bulletin/Repair Instructions
Telematics Box Module (TBM) Backup Battery Replacement When DTC B1E21 Is Present Technicians may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set the following Diagnostic Trouble Code (DTC): ● B1E21-96 - Backup Battery Component Internal Failure.
9100734
Service Bulletin/Repair Instructions
If the DTC B1E21-96: Backup Battery-Component Internal Failure is active and customer states Popup message will show at the radio: "Battery of Uconnect Box requires service. SOS call and related functions may be unavailable. Please visit an authorized dealer." PLEASE do not Replace the TBM module, only replace TBM Internal Battery (inside Telematics Box Module) and order PN68493347
08-394-25
Service Bulletin/Repair Instructions
Telematics Box Module (TBM) Backup Battery Replacement When DTC B1E21 Is Present echnicians may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set the following Diagnostic Trouble Code (DTC): ● B1E21-96 - Backup Battery Component Internal Failure
108687
Service Bulletin/Repair Instructions
Radio- Multi Media
108688
Service Bulletin/Repair Instructions
Radio- Multi Media
S2508000101
Service Bulletin/Repair Instructions
Intermittent Uconnect Box Requires Service Message. TBM Setting Stored Or Pending DTCs B22A9, B1560, B1561, B1562
23-008-25 REV. A
Service Bulletin/Repair Instructions
Exterior Front Lamps Condensation Clearing Procedure *Some customers may report that on occasion vehicle exterior front lamps (headlamps, fog lamps, grille lamps, logo lamps or signature lamps) assemblies are fogged with a light layer of condensation on the inside of the lenses*
02-002-25 REV. A
Service Bulletin/Repair Instructions
Shock And Strut Diagnosis And Replacement Guidelines Leaking, noisy, or weak shocks or struts.
31-001-25 REV. B
Service Bulletin/Repair Instructions
Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates.
31-001-25 REV. A
Service Bulletin/Repair Instructions
Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates.
31-001-25
Service Bulletin/Repair Instructions
Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates
23-006-25 REV. B
Service Bulletin/Repair Instructions
Windshield Wiper Blade Maintenance Customers may experience one or more of the following: ● Wiper blades that chatter/streak/jump/skip/smear or make noise while traveling across the windshield.
02-002-25
Service Bulletin/Repair Instructions
Shock And Strut Diagnosis And Replacement Guidelines Leaking, noisy, or weak shocks or struts.
9100471
Service Bulletin/Repair Instructions
CANISTER Vapor -If an issue is detected with the Evaporative System Integrity Module (ESIM) Detector and not the Vapor Canister, only replace the ESIM Detector. -Before replacing the Vapor Canister due to Hard to Fill condition, replicate the condition at the Gas Station. If the condition is replicated, then check: 1) for kinked or pinched Clean Air Hose between the ESIM and the EVAP Air Filter; 2) for plugged EVAP Air Filter; 3) for kinked or pinched Vapor Hose between the Fuel Tank and the Vapor Canister. If the EVAP Filter is restricted, the replace the Filter. -Check if the Vapor Canister is flooded with fuel or the Recirculation Line has fuel. If fuel is found in the Vapor Canister or the Recirculation Line, then drop the Fuel Tank, remove the FDM Lock Ring to check if the internal Vapor Line is properly connected to the FDM Port. If the Vapor Line is not connected, then drain the fuel from the internal Vapor Line and properly connect to the FDM. Replace the Vapor Canister and the ESIM.
9100468
Service Bulletin/Repair Instructions
FUEL VAPOR CANISTER FILTER EVAP Fuel Filters are to be checked for restriction / blockage on a regular schedule as indicated in the Owner s Manual. If the Filter is restricted or blocked then replace the part. For customers that drive light duty trucks in extreme dusty and dirty road conditions, please reference information only TSB 25-009-24 for an available MOPAR Dual EVAP Filter kit that is customer paid.
9100469
Service Bulletin/Repair Instructions
VAPOR CANISTER If an issue is detected with the EVAPORATIVE SYSTEM INTEGRITY MODULE DETECTOR and not the VAPOR CANISTER, only replace the EVAPORATIVE SYSTEM INTEGRITY MODULE DETECTOR.
01-002-24
Service Bulletin/Repair Instructions
Oil Change Monitor Displaying Prematurely Customers may experience the following: ● The oil change light illuminated on the dash shortly after taking delivery of the vehicle within 6,437 Km (4,000 miles). This bulletin involves resetting the oil life monitor and if necessary changing the engine oil and filter.
31-001-24
Service Bulletin/Repair Instructions
Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates. NOTE: Verify current warranty policy to determine if digital imaging pre-authorization is required or pre-approval is required from the Regional Office; depending on market. This bulletin involves inspecting and if necessary removing corrosion and refinishing the suspect aluminum panels on the vehicle, hood, door, fenders, hinges, swing gates or liftgate panels.
9100351
Service Bulletin/Repair Instructions
Medium Range Radar Alfa Giulia and Stelvio - FRONT RADAR -Temporary misalignment (DASM) Forward Collision Warning (FCW) System - Light on instrumental panel control cluster Adaptive Cruise Control (ACC) System - Light on instrumental panel We inform you that if the collision radar warning light is temporarily on and the temporary inhibition of the FCW (Forward Collision Warning) and the ACC (Adaptive Cruise Control) are both temporarily inhibited, the vehicle is conforming. If conditions are such that the radar cannot detect obstacles correctly, the system is temporarily deactivated and a dedicated message is displayed on IPC (Instrument Panel Control Cluster). Temporary deactivation is caused by automatic radar learning under particular conditions: Change in vehicle weight distributed unevenly. Change in vehicle geometry. Roads with limited presence of radar references (guard rails, road signs, other vehicles on the carriage way, etc.). Severe weather conditions (snow fall or heavy rain). Highly reflective conditions (e.g., tunnels with reflective tiles, or ice or snow, or sites with road work). Obstruction of radar due to presence of mud, dirt or ice on bumper or radar surface and/or cover. Please note that the problem solves itself and one or more of the following DTCs may be stored: ACC C1417-78: Horizontal misalignment of sensor - Incorrect alignment or adjustment ACC C1418-78: Vertical misalignment of sensor - Incorrect alignment or adjustment ACC C1409-97: Blinded radar sensor - Obstructed or blocked component This is not a fault but rather a message alerting the driver that the FCW and possibly ACC (if activated) functions are temporarily inhibited. Please be advised that if the customer complains of temporary or sporadic illumination of the anti-collision warning light with the AEB system subsequently returning to full functionality, the vehicle is conforming and no radar adjustment is required. If the message is displayed frequently, even in the absence of weather conditions such as snow, rain,mud, or other types of obstruction, check and clean the radar surface directly by manually removing the aesthetic cover plate.
Reading this report
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.