Vehicle report

2017 ALTEC ST SPRAY TRUCK

Compare every ALTEC ST SPRAY TRUCK yearNHTSA and EPA records

Service bulletins

2 bulletins

Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.

SIL 826

Service Bulletin/Repair Instructions

Altec has discovered that certain ST500 and ST600 units built from July 2017 to October 2019 do not have a load rating placard on the outer tubes of the hitch. Overloading the tubes could damage the bumper and/or hitch. Altec requires a placard kit to be installed on each affected unit within 90 days of receipt of this SIL. The placard kit required depends on the unit model. Install the kit upon receipt. This installation is covered under the Altec Warranty Policy and can be performed by Altec, the customer, or the customerâs warranty provider. Altec will perform the work for free at an Altec facility. If the customer or the customerâs warranty provider performs the installation, a warranty claim must be submitted to be reimbursed for the cost of the parts and/or labor.

SIL 781

Service Bulletin/Repair Instructions

The receiver hitch capacity and warning placards were not installed on the affected units. Use of the hitch at loads higher than the design ratings due to the lack of these placards can overload the receiver tube, resulting in damage to the receiver tube and/or the bumper. The Receiver Hitch Placards Kit is included with the SIL. Altec requires this kit to be installed by the next preventive maintenance interval.

Reading this report

Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.