MC230204
Service Bulletin/Repair Instructions
Ball End Working Loose on Gearshift Lever.
Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
MC230204
Ball End Working Loose on Gearshift Lever.
MC000521
One of the following situations can occur when connecting to BN2000 motorcycles: 1. The installed control units cannot be found when reading out with ISTA. 2. Control units initially communicate after connecting to the vehicle, but communication later stops.
MC51142327
Leaks have been reported in fork legs. The cause is reported be from oil lubricating film with accompanying dirt/grease ring is incorrectly interpreted to be a leaking fork leg. Investigations have shown that the part is not defective.
SIB-63-02-01
BMW: PROCEDURE FOR DETERMINING AND REPLACING INCANDESCENT AND HALOGEN LIGHT BULBS UNDER WARRANTY. *RM
SIB-16-02-09
BMW VEHICLES: FUEL LEVEL SENSOR REPAIRS. WHERE IT IS NECESSARY TO REPLACE THE RIGHT OR THE LEFT SIDE FUEL LEVEL SENSOR DUE TO A FAILURE, THE ENTIRE PUMP AND HOUSING OR DELIVERY UNIT (SUCTION JET ASSEMBLY) DO NOT NEED TO BE REPLACED AS WELL. IN SOME CASES, EPC DOES NOT SHOW THAT THE REPAIR KIT IS AVAILABLE SEPARATELY IN THE ILLUSTRATION, BUT IT IS AVAILABLE IN THE PARTS DESCRIPTION. ALL MODELS. NO MODEL YEARS LISTED. *PE
TSB-17-001-09
BMW MOTORCYCLE: THE COOLANT INLET HOSE IS NOT COMPLIANT WITH THE APPLICABLE BMW SPECIFICATIONS. ENGINE OPERATION CAN CAUSE THE INLET HOSE TO WIDEN AND BECOME CORRESPONDINGLY SHORTER; OVERTIME THIS CONTRACTION IN LENGTH CAN CAUSE THE HOSE TO WORK BACK OFF THE WATER PUMP NOZZLE FOR ENOUGH TO ALLOW COOLANT TO ESCAPE. NO MODEL YEARS LISTED. *PE
SB-00-021-07
BMW MOTORCYCLE: ENGINE FUELS CONTAINING ETHANOL. BMW MOTORRAD HAS NO OBJECTION TO THE USE OF SI ENGINE FUELS CONTAINING UP TO A MAXIMUM OF 10% ETHANOL AND IMPOSES NO WARRANTY RESTRICTIONS. ETHANOL MIXTURES IN PROPORTIONS HIGHER THAN 10% CAN HAVE AN ADVERSE EFFECT ON PERFORMANCE AND CAN RESULT IN DAMAGE TO COMPONENTS THAT COME INTO CONTRACT WITH FUEL. NO WARRANTY CLAIMS WHATSOEVER FOR DAMAGE CAUSED IN THIS WAY WILL BE ACCEPTED. NO MODEL YEARS LISTED. *PE
3300204
TORQUE SPECIFICATIONS ECCENTRIC CLAMP CONNECTION. BMW F 650 CS. PRODUCTION STARTING NOVEMBER 2003. *TT
2700203
WEAR OF SHOCK ABSORBING ELEMENTS IN REAR BELT DRIVE, F650 CS. *TT
1800203059
MUFFLER SLIPPING OFF THE SILENT BLOCK MOUNTING BRACKET. *TT
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.