B320526
Service Bulletin/Repair Instructions
“Cracking” noise might be heard when turning the steering wheel from lock to lock. See attached video V3202 26 EPS noise.
Vehicle report
2024 BMW I7
Service bulletins
39 bulletinsTechnical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
B340124
Service Campaign
After replacement of the Integrated Braking system (IB)/Power Brake the total distance covered might belower than when handed over to the workshop for the repair.
B640925
Service Campaign
A faulty electric auxiliary heater may have been installed in the certain vehicles. This could result in thefailure of the electric auxiliary heater, utilized for the vehicle interior.
B310426
Service Bulletin/Repair Instructions
SITUATION When turning the steering wheel fully to the steering end stops, a ”groaning” noise can be perceived at the respective steering stop. The noise occurs at higher ambient temperatures from approx. 68°F.
B610626
Service Bulletin/Repair Instructions
Charging sessions cannot be started or they are interrupted while using a Level 2 AC high-power charging station, or with a Level 3 DC charging station. Charging may start normally but can interrupt after some time. Level 2 (240 V) Flex Charger and Wall box may also be affected. The red or white LED is displayed on the high-voltage charging socket; however, no associated fault codes are stored.
B310324
Service Bulletin/Repair Instructions
When rolling forward or backwards with the steering at full lock (left or right) without the brake applied, a “groan”-type noise may be heard from the front axle. The noise is most noticeable after load reversal. The noise can be heard beginning at the 7 second time stamp.
B120523
Service Bulletin/Repair Instructions
The customer states there is a Drivetrain Malfunction message displayed in the instrument cluster. In addition, the following fault memory entries are saved in the CCU (Combined Charging Unit) 0317F2 - High-voltage system, insulation fault detected: when switch contactors are closed. 0317F1 - High-voltage system, insulation resistance below warning threshold: when switch contactors are closed. The fault memory entries (isolation faults) can occur both individually and in combination and must be traced back to the eDrive motor based on the ISTA test procedure. If ISTA test procedure lists possible cause of fault as; A metal chip is found behind the brush module (between the brush module and the end shield of the electrical machine). Repair required. Refer to service solution no. 20000794435083 in Aftersales Information Research (AIR). Follow information in the Procedure section below.
B170124
Service Bulletin/Repair Instructions
There is coolant leaking from under the car Low heater output Possible Check Control message “Drive, you can continue driving” (ID49) Possible fault codes stored in these BEV vehicles: 224163 – Electric auxiliary heater for the high-voltage battery unit: Undervoltage or internal communication fault 8049AA - Coolant level sensor, expansion tank: Coolant level low or short circuit to ground or line disconnection 80124F – Electric auxiliary heater: Communication in electric auxiliary heater faulty 224F60 - Coolant level sensor, expansion tank: Coolant level low or short circuit to ground or line disconnection 224111 - Cooling system for power electronics: Coolant loss detected 224107 - Cooling system for high-voltage battery unit, component protection: Detection of coolant loss
B061526
Other
High Voltage Connection Return
B410525
Service Bulletin/Repair Instructions
While attempting to fuel/charge the vehicle,the fuel/charge door will not open.
B063625
Other
Hydrobearing Return
B640625
Service Campaign
A faulty electric auxiliary heater may have been installed in the certain vehicles. This could result in the failure of the electric auxiliary heater.
B320225
Service Campaign
Parts of the steering shaft universal joint may have been joined together without having beengreased. As a result, there can be audible squeaking and cracking noises. In some cases, moresteering force is required.
B350123
Service Bulletin/Repair Instructions
When the brake pedal is pressed/ released, a creaking noise may be heard from the pedal area for the Integrated Brake System (IB). This noise may be present with the vehicle stationary and the engine running.
B610124
Service Bulletin/Repair Instructions
When driving over rough surfaces, a low-frequency rattling noise can be heard inside the vehicle's cabin. The noise typically sounds as though it is coming from the front right footwell area.
B641124
Service Campaign
Quality checks have determined that the coolant changeover valve may develop a coolant leak undervery low outside temperatures (significantly lower than 32º F (0 C)).
B340324
Service Campaign
Improved diagnostic software for the brake system.
B611824
Service Campaign
A manufacturing defect in high-voltage cells of the high-voltage battery can result in electrolyte leakage which might result in a conductive connection with surrounding components. Depending on the contact resistance, a yellow or red Check Control message will then be displayed; it is permitted for you to continue driving, but this will result in a charging interruption during charging.
B611424
Service Campaign
The rear high-voltage cable for the electric drive unit can chafe causing a Check Control message “Drive faulty”.
B611624
Service Campaign
The rear high-voltage cable for the electric drive unit can chafe causing a Check Control message “Drive faulty’”
B611724
Service Campaign
Vehicle may experience Ethernet BUS communication issues between the Head Unit (HU-H5) and the rearDoor Operating Modules (BMTs). This could result in failures in any of the following functions: Media operation Radio control Telephone control MyModes selection Wireless Charging (wireless charging tray)
B520224
Service Bulletin/Repair Instructions
Customer states they started to receive Check Control messages for the driver’s seat at the end of eachdriving cycle: One or more of the following check control messages (CCM) were present at that time: CCM 434 Seat calibration required. CCM 108 Driver restraint system. Eventually multiple restarts after they first noticed the CCM the seat stopped functioning, the air bag warninglamp illuminated in the instrument cluster, and they received a new Check Control message: CCM 97 Restraint system. There are now 6 DTC faults stored: ACSM6 Air Bag module 930D86 - Function restraint system driver restricted. C95432 - seat module Driver (seat memory), message status backrest locking standardization required. C95434 - seat module Driver (seat memory), message status backrest locking standardizationrecommended. FAS_I20 Driver's Seat module 8029F5 - initialization seat: limited seat adjustment due to missing calibration 802A03 - Functions seat adjustment FAS limited available. 802A05 - ÜKB: Shut-off ÜKB because of missing calibration. Also, one or both of the following check control messages (CCM) may currently be present: CCM 108 “Driver restraint system” CCM 109 “Passenger restraint system” The seat initialization and memory has been lost. Or Repeat failure of seat initialization after completing the test module via ISTA.
B330124
Service Bulletin/Repair Instructions
The vehicle will no longer move when put into gear. There may also be loud noise coming from the HEAT*(electric drivetrain)/Rear axles. *German acronym for Highly integrated electric drivetrain topology- Hochintegrierte Elektrifizierte Antriebs-Topologie
B370124
Service Bulletin/Repair Instructions
While driving at low speeds (15-40 mph) on flat road surfaces, a knocking noise from the front axle may beheard during steering wheel movements.
B640624
Service Campaign
Quality checks have determined that the coolant changeover valve may develop a coolant leak under very low outside temperatures (significantly lower than 32º F (0 C)).
B640124
Service Bulletin/Repair Instructions
A drumming noise is heard when the air conditioning system is operating.
B640224
Service Bulletin/Repair Instructions
DELIVERY STOP: COOLANT CHANGEOVER VALVE
B613233
Service Bulletin/Repair Instructions
A small flap of sound insulation material may come into contact with some of the 12 V B+ cables at the remote B+ charging point terminal (general location at arrow) along the engine compartmentâÂÂs passenger side inner fender well.
B640524
Service Bulletin/Repair Instructions
When the interior temperature of the vehicle is between 5 F (-15 C) and 23 F (-5 ), the defroster function is limited; and the interior doesnâÃÂÃÂt heat up quickly enough.
B610624
Service Bulletin/Repair Instructions
This Informational Bulletin is intended as a guided work-through process to address customer charging complaints. The step-by-step guide will help walk you through the âÂÂbasicâ procedure to test the charger/infrastructure when the vehicle does not charge, either at a: Home charger AC Level 1/Level 2 - Flexible Fast Charger/hard wired Wallbox, or a Public AC Level 2, or DC Level 3 - Fast Charging Station Note: All PHEV and BEV vehicles may be affected.
B640424
Service Bulletin/Repair Instructions
1. The center air vent on the left (a) is closed. All other air vents on the left side then only blow cold air intothe passenger area. OR 2. Both center (b) air vents are closed. All other air vents then only blow cold air into the passenger area. OR 3. The center air vent on the right (c) is closed. All other air vents on the right side then only blow cold airinto the passenger area.
B610724
Service Bulletin/Repair Instructions
This Informational Bulletin is intended as a guided work through process to address BEV/PHEV charging issues. The step-by-step guide will help walk you through the correct âÃÂÃÂbasicâÃÂàsteps that should be followed when addressing and diagnosing battery electric vehicles (BEV) and plug in hybrid vehicles (PHEV) charging issues.
B310224
Service Bulletin/Repair Instructions
A knocking, âÃÂÃÂthumpâÃÂÃÂ-type noise may be heard from the front axle during straight-ahead driving on uneven road surfaces at low speed, e.g., below 40 mph.
B660324
Service Bulletin/Repair Instructions
A quality check showed that the Remote-Control Parking token was not activated in the current software for the vehicles affected.
B610324
Service Bulletin/Repair Instructions
Gen 5 BEV/PHEV vehicles may set the Combined Charging Unit (CCU) in programming abort due to nocommunication to the HV charge socket electronics.
B611305
Service Bulletin/Repair Instructions
The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle âÂÂdischarged batteryâ complaints.
B340423
Service Bulletin/Repair Instructions
BMW AG has issued a Delivery Stop (effective December 20, 2023) on certain Model Year 2023 - 2024BMW vehicles that were produced between July 4, 2022, and October 26, 2023.
B613323
Service Bulletin/Repair Instructions
BMW AG has issued a Delivery Stop (effective December 19, 2023) on certain Model Year 2023 BMW vehicles that were produced between February 10, 2023, and June 23, 2023.
B612523
Service Bulletin/Repair Instructions
The purpose of this Service Bulletin (SIB) is informational regarding DC (direct current) charging complaints on Gen 5 Battery Electric Vehicles (BEV). It serves as a supporting argument and is intended to help distinguish between a standard designed function or component operation from an actual system fault in a DC charging customer complaint (i.e., âÂÂDC Not charging or âÂÂDC charging too slowâÂÂ. Helpful âÂÂTips and Tricksâ have been included on each topic within the document that can be used as reference to aid in the diagnosis or in understanding the system. The situation involves several possible causes: 1. Limitation of charging power by the charging station or charging app configuration. 2. Decreasing charging power at a very high state of charge (SoC). 3. Too frequent DC charging attempts within a short period of time. 4. The high-voltage battery is not at the ideal temperature. 5. Ageing of the high-voltage battery.
Reading this report
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.