Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
MC330224
After close inspection of the manufacturing process, there is a weld seam at the hollow shaft and crown wheel connection in the rear drive that is not to specification in a few rear drives. Depending on riding habit, this can lead to slipping and loss of propulsion over time.
B611305
The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle âÂÂdischarged batteryâ complaints.
B520121
?The front seat will not calibrate/initialize, and the stored faults cannot be deleted.
MC000222
BMW Motorrad is aware of a number of cases in which the screw connections of the Paralever link and/or the rear brake caliper have loosened in customer vehicles while driving.
B650414
According to the customer, the airbag warning light was on, but it may not be illuminated when the vehicle arrives in the workshop. 1. ACSM fault code "930A60 - Seat occupancy detection, front passenger; malfunction" is stored. The fault may or may not currently be present. Or 2. ACSM fault code "930A1C - Front passenger seat occupancy detection transmitting fault(moisture)" is stored. The fault may or may not currently be present.
M410121
The body seam on the rear upper left of the body may not have been completely sealed, causing a water leak.
M410122
The body seam on the rear upper left of the body may not have been completely sealed, causing a water leak.
M650122
The Sirius(r) Satellite Radio is inoperative.
M660122
The options in the Reversing Assist Camera menu are greyed out and cannot be adjusted.
B010122
BMW of North America, LLC (BMW NA) has entered into a nationwide settlement with the plaintiffs in the following class action: Isley, et al. v. BMW of North America, et al. The Court has granted final approval of the settlement. The Settlement Benefits are effective and available on and after February 9, 2022.
B640613
Customer may complain of reduced air flow when the air conditioning system is operated for an extended time, usually longer than 30 minutes.
MC610821
When diagnosing fault codes (0x3A13D7, 0x3A13D9), technicians erroneously condemn the electronic throttle grip, which analyses show is rarely the culprit.
B110120
On rare occasions during an engine oil service, the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing.
B513316
Water sloshing noises coming from the rear passenger compartment (left or right) while driving Water ingress in the luggage compartment, or in the rear passenger compartment- rear seat bench rear passenger compartment foot well rear passenger compartment side panel Failure of various control units installed in the area of the water removal channel
B610721
Groaning, scraping, or squeaking noise coming from the steering wheel area in the interior of the vehicle, when turning the steering wheel.
B840221
The discontinuation of 3G cellular communication for Combox, TCB 3G and ATM 3G (Telematics ControlModule) can no longer be supported by the cellular network provider starting February 2022. The decision to phase out 3G network technology was made at the discretion of the respective cellular carriers and lies beyond the control of BMW. Due to the phase-out, BMW Assist and ConnectedDrive services will no longer be supported after this date.
MC110521
During quality analysis, an issue was identified with a small group of sixteen (16) motorcycles that mayaffect crankshaft bearing wear.
B110321
B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available.
B340414
Diagnosis of Compound Brake System Complaints in M Vehicles: 1. Visible cracks are caused by high thermal stresses during rapid heating and cooling of the brake discs. Braking from high speed with cold brake components (less than 212 degrees F) increases the likelihood of cracks to form.
B121318
COMBUSTION CONTROL VALVE LIFT AT IDLE: The vehicle will run rough or hesitate when accelerating from a stationary position.
B340515
TICKING NOISE FROM THE FRONT AXLE WHEN CORNERING: The customer may complain of a metallic ticking noise from the front axle, when cornering, maneuvering, parking or pulling away from a parking space.
B513218
PAINT ON THE B-PILLAR IS SCRATCHED/DAMAGED: The paint finish of the door jamb (above the door striker) is scratched due to the inner door cavity window seal.
B310112
CRACKING NOISES FROM THE FRONTAXLE AREA WHILE TURNING THE WHEELS, WHEN STATION: Cracking noises are heard from the front axle area while maneuvering at low speeds (e.g., parking lot maneuvers) or when turning the steering wheel while stationary.
B010319
N63T REAR MONITORING OXYGEN SENSORS - LTD WTY EXTENSION TO 10 YEARS/120,000 MILES: Component-Specific Limited Warranty Extension For the eligible vehicles, BMW of North America, LLC (BMW NA) is extending the limited warranty for the vehicle's Rear Monitoring Oxygen (O2) Sensors (one shown) to: 10 years/120,000 miles as determined by the vehicle's original in-service date This component-specific limited warranty extension applies to defects in materials or workmanship.
B160319
NOISES FROM THE FUEL TANK AT IDLE: All vehicles except the F48 (X1): While driving slowly with low RPM or while idling a faint knocking or fluttering noise can be heard from inside the fuel tank with a low fuel level (approximately less than 2 gallons). The customer may describe this noise as a "helicopter noise" from the rear of the vehicle. F48 (X1) only: While driving slowly with low RPM or while idling a faint knocking or fluttering noise can be heard from inside the fuel tank when the tank is full. The customer may describe this noise as a "helicopter noise" from the rear of the vehicle. CAUSE Pressure fluctuations from the tank ventilation valve will cause the fuel tank filler pipe non-return valve to vibrate. In some cases, the vibration can be heard inside the vehicle.
B610419
VEHICLE DOES NOT START BATTERY TOTALLY DISCHARGED: The customer's vehicle does not start due to a totally discharged battery.
B650709
NAVIGATION SYSTEM - REPORTING MISSING OR INCORRECT ROADMAP DATA: Do not replace parts and do not program the vehicle. Roads can change by up to 15% every year. To ensure the best navigation experience, we do everything in our power to create the best maps. Your reports help us to detect changes in your area and keep future versions of our maps as accurate as possible. Therefore, a road map error or missing data must be reported directly to the map supplier.
B340517
TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: This Service Information Bulletin (Revision 3) replaces SI B34 05 17 dated September 2017. Ticking noise coming from front wheel while cornering without brakes applied noticeable at low speeds. The vehicle must be moving. See attached video V34 01 20 Note: For a similar noise heard when parking with the brakes applied refer to SIB 31 01 12. Microscopic movement of the contact interface between the inner brake disc and the wheel bearing flange on vehicles equipped with lightweight brake discs.
B513016
TAILGATE UNINTENTIONALLY OPENS: This Service Information Bulletin (Revision 4) replaces SI B51 30 16 dated March 2018. Trunk/tailgate may open when vehicle is locked Trunk/tailgate may open while the vehicle is in motion usually after stopping such as a traffic light etc. Vehicle key trunk/tailgate button may be accidentally pressed thus opening the tailgate.
B610520
CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: This Service Information Bulletin (Revision 1) replaces SI B61 05 20 dated February 2020. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
B652214
AUTOMATED ACTIVATION OF NAVIGATION SYSTEM DURING PDI/QC1: This Service Information Bulletin (Revision 2) replaces SI B65 22 14 dated October 2015. The INITIAL NAV enabling code no longer needs to be pre-ordered through the Parts department! When the vehicle is connected to the diagnostic system ISTA to perform PDI/QC1 the step to activate the navigation system (part of Delete Transport Mode) will automatically request the INITIAL NAV enabling code (VIN-specific) without pre-ordering the enabling code. This enabling code will be automatically delivered through ISTA and it then activates the navigation system.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.