SB-129289
Service Bulletin/Repair Instructions
SUMMARY TO BE PROVIDED ON A FUTURE DATE.
Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
SB-129289
SUMMARY TO BE PROVIDED ON A FUTURE DATE.
REV87480
Air scoop retrofit kits.
D109338
Trailer module may fail.
POSTING 12-20
POSTING DISCUSSING THE TWO RECALLS POSTED ON TRANSPORT CANADA AND NHTSA CONCERNING THE FUEL VAPOR CANISTER VENT HOSE TO BE REPLACE OR RE-ROUTE AND FUEL CAP REPLACEMENT BECAUSE THE FUEL CAP MAY NOT FIT ONTO THE FUEL TANK FILTER NECK.
Article 10-25
Technical Service Tip (TST) addressing that on some SE5 engines a high pitched or whining noise may be heard under specific RPM only. After investigation the cause of this noise is from a thrust washer vibrating and spinning in the HCM. Inspection of the HCM housing for wear is proposed; it may need to be replaced.
SB-420611493
BRP: SOME ENGINES (SE5) HAVE A HIGH PITCHED OR WHINING NOISE, LEFT HAND SIDE, CAN BE HEARD UNDER SPECIFIC RPM. MODEL ROADSTER. NO YEARS. *PE
Article Radio 10
If a customer wants to change the radio pre-set channel number and is unable to do so, here is the reason this is happening.
Bulletin 2013-9
Service bulletin informing dealers that a new procedure has been developed to improve the replacement of the tandem master cylinder (TMC) without the necessity of bleeding the whole brake system.
Bulletin 2010-7(
Revision #1 of Warranty bulletin 2010-7 dated September 7, 2010. This safety recall addressed the problem that a situation may occur where you may need to exert a force greater than expected to initiate the turning of the steering handlebar of your vehicle in order to correct its trajectory. At this increased level of force the handlebar may be turned more than you had intended. If this occurs you may steer your vehicle out of lane which increases the possibility of a crash with other traffic or of a drive off the road. As of April 2, 2013, the return procedure has been updated.
ARTICLE 01-17
TECHNICAL SERVICE TIP (TST) ADDRESSING THE DETAILS OF THE RECALL FUEL CAP REPLACEMENT, WHERE THE FUEL CAP MAY NOT SEAL PROPERLY ONTO THE FUEL TANK FILTER NECK. FUEL VAPORS IN THE PRESENCE OF AN IGNITION SOURCE COULD RESULT IN A FIRE. BRP IS SENDING OUT REPLACEMENT FUEL CAPS TO ALL CANADIAN AND USA REGISTERED OWNERS.
RC-2010-0015
BRP: ON THE CAN-AM ROADSTER, THE FUEL CAP FAILS TO SEAL PROPERLY, ON FUEL TANK FILLER NECK, CAUSING FUEL VAPORS AND IN PRESENCE OF AN IGNITION SOURCE, MIGHT RESULT IN A FIRE AND NEEDS REPLACING. MODELS 2008-2012 CAN-AM SPYDER GS, RS, AND RT. *PE
Article 2010-12
Article discussing the safety campaign 2010-12 - Fuel Vapor Canister Vent hose inspection/replacement. In some circumstances, fuel vapors may exit the fuel vapor canister vent hose in the enclosed engine compartment. Fuel vapors in the presence of an ignition source could result in a fire. The proposed solution is to inspect the fuel vapor canister vent hose to determine if the proper hose is installed. replace and re-route the fuel vapor canister vent hose if required.
Article 2012-13
Article informing dealers of Safety Campaign 2012-13 - Fuel Cap replacement. The fuel cap may not seal properly the fuel tank filler neck. Fuel vapors in the presence of an ignition source could result in a fire.
Posting 12-13
Posting informing the community that some of them may have seen an alert from Transport Canada regarding a recall on certain Spyder models. (recall 2012-13)
SB-SE-5
BRP: THE SHIFT UP AND DOWN PADDLE FAILS TO WORK AND ADJUSTMENT IS NEEDED THAT MIGHT IMPROVE THE SITUATION ON CERTAIN MODEL MOTORCYCLES. MODEL SPYDER GS/RS. NO MODEL YEARS LISTED. *PE
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.