Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
9004275
KEY, Master If replacing the key/FOBIK on a WJ, KJ, TJ, or PT Cruiser, use the "AC" NIC level part number. The "AB" NIC level will not program to these platforms. For all other platforms, if the "AB" NIC level will not program to the vehicle, use the "AC" NIC level part and submit a part warranty.
08-049-20
Charging System, Battery Diagnostic Tools and Warranty This information only bulletin discusses using the correct test equipment for testing batteries and charging systems, and also warranty reimbursement when battery replacements are necessary.
31-003-19
Use of Salvage/Recycled Parts This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the use of recycled or salvage parts.
31-005-19
Use of Aftermarket Parts This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the use of aftermarket parts.
31-006-19
Repair Parts Used For Structural Repairs This bulletin involves discussing FCA US LLC position with regard to structural repair parts usage.
3100319
Use of Salvage/Recycled Parts This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the use of recycled or salvage parts.
3100519
Use of Aftermarket Parts This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the use of aftermarket parts.
3100619
Repair Parts Used For Structural Repairs This bulletin involves discussing FCA US LLC position with regard to structural repair parts usage.
68332810
Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar® Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 N·m [21 ft. lbs.].
R2118796A
Valve Body. These may cause over drive cycling.
0800600REV
SUBJECT REGARDING WIRE SPLICE REPAIRS. *SB
050798
VEHICLE VIBRATES / SHUDDERS WHEN THE BRAKES ARE APPLIED. *AK
250298
SUBJECT REGARDING I/M ( INSPECTION MAINTENANCE ) TESTING - OBD II "CARB" READINESS MONITOR INFORMATION. *YC
234398
THIS BULLETIN IS INTENDED TO ASSIST IN IDENTIFYING WATER LEAK ENTRY POINTS PAST THE DUAL CARGO DOOR SEALS BY HIGHLIGHTING AREAS WHERE LEAKS ARE LIKELY TO OCCUR BASED ON THE EXPERIENCE GAINED DURING THE DEVELOPMENT OF THE VEHICLE. *YC
234298
HISS OR WHISTLE TYPE WINDNOISE CAN BE HEARD COMING FROM THE A-PILLAR AREA. *YC
230498
CONDITIONS WITH SIDE AND / OR REAR CARGO DOOR OUTSIDE HANDLES ARE LOOSE. *AK
7841/7842
WRONG VEHICLE EMISSION CONTROL INFORMATION (VECI) LABEL MAY HAVE BEEN IN STALLED ON ABOVE LISTED VEHICLES. AS A RESULT, THE WRONG LABEL WILL CAUSE VEHICLE TO FAIL AN EMISSION TEST. *AK
081698
INFORMATION ON INSTALLATION OF RADIO TRANSMITTING EQUIPMENT. *AK
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.