Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
511640B
Service Bulletin/Repair Instructions
According to General Motors Recall 23V247: "These vehicles are equipped with an unused circuit that a final-stage manufacturer may elect to use to install an optional rear HVAC system. If the final-stage manufacturer leaves the circuit's connectors or cut wires unsealed, exposure to moisture or contamination may, over time, cause corrosion. This could result in high current draw through the circuit at the vehicles' lower left side B-pillar. Unintended release of excessive heat from the circuit may pose a risk of a vehicle fire and increase the risk of injury."
1-2013-0109_V1
Service Bulletin/Repair Instructions
THIS INSTUCTION OUTLINES THE PROCEDURE TO ADJUST THE DOOR OPEN SWITCH.
2016-0006
Service Bulletin/Repair Instructions
THIS COMMUNICATION OUTLINES THE PROCEDURE TO RECONFIGURE PIN LOCATIONS IN THE HARNESS BLACK PLUG TO ALLOW THE POWER DOOR ADD PROGRAM 4.00 TO OPERATE CORRECTLY.
1-2015-0126-TY_V
Service Bulletin/Repair Instructions
THIS TSB OUTLINES THE PROCEDURE TO MODIFY THE MOTOR/RAMP ASSEMBLY INSTALLATION DUE TO A MOTOR CHANGE.
1-2015-1124-_V1
Service Bulletin/Repair Instructions
THIS INSTRUCTION OUTLINES THE PROCEDURE FOR THE DOOR TRACK REMOVAL, MODIFICATION, AND RE-ASSEMBLY/INSTALLATION TO INCREASE THE DOOR OPENING/TRAVEL.
1-2015-0716_V1
Service Bulletin/Repair Instructions
THIS TSB OUTLINES THE PROCEDURE TO REPAIR THE RAMP PLATE.
1-2015-0528_VI
Service Bulletin/Repair Instructions
THIS INSTRUCTION OUTLINES THE PROCEDURE TO ADJUST THE MANUAL RAMP.
1-2015-0401_V1
Service Bulletin/Repair Instructions
THIS TSB OUTLINES THE PROCEDURE FOR THE LOWER DOOR HARNESS MODIFICATION TO THE AMERIVAN PRODUCTS WITH POWER OR MANUAL SLIDING DOORS.
1-2014-1218-TY_V
Service Bulletin/Repair Instructions
THIS INSTRUCTION OUTLINES THE PROCEDURE TO ADJUST THE RAMP STOW POSITION.
1-2014-1218_V1
Service Bulletin/Repair Instructions
THIS INSTRUCTION OUTLINES THE PROCEDURE TO ADJUST THE RAMP STOW POSITION.
1-2014-0708_V1
Service Bulletin/Repair Instructions
THIS TSB OUTLINES THE PROCEDURE TO INSTALL THE SIDE STEP.
1-2014-0611_V1
Service Bulletin/Repair Instructions
THIS COMMUNICATION NOTIFIES THE DEALER/CUSTOMER THAT THE IOD FUSE HAS BEEN REMOVED TO LIMIT THE AMOUNT OF PARASITIC DRAW ON THE BATTERY. THIS COMMUNICATION INSTRUCTS THE DEALER/CUSTOMER TO RECONNECT THE IOD FUSE IN THE TIPM BEFORE OPERATING THE VEHICLE.
1-2013-0708-TY_V
Service Bulletin/Repair Instructions
THIS INSTRUCTION OUTLINES THE PROCEDURE TO REMOVE THE PASSENGER SIDE SEAT AND RAMP ASSEMBLIES FOR REPAIR/REPLACEMENT OF THE RAMP ASSEMBLY.
1-2013-0606_V1
Service Bulletin/Repair Instructions
THIS INSTRUCTION OUTLINES THE PROCEDURE TO ADJUST THE RAMP ASSEMBLY ON THE 14-INCH DROP FLOOR .
1-2013-0507-TY_V
Service Bulletin/Repair Instructions
THIS TSB OUTLINES THE PROCEDURE NECESSARY TO COMPLETE THE STEP LIGHT WIRING WHEN INSTALLATING THE STEP LIGHT TO THE VEHICLE EXTERIOR STEP ASSEMBLY.
1-2011-0930_V1
Service Bulletin/Repair Instructions
THIS TSB OUTLINES THE PROCEDURE TO MODIFY THE LOWER DOOR ARM CABLE MOUNT BRACKET TO ALLOW INCREASED DOOR TRAVEL, PROVIDING A LARGER OPENING FOR MOBILITY AID ACCESS.