Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
SSM 54646
Service Bulletin/Repair Instructions
Some 2020-2024 Explorer/Police Interceptor Utility hybrid vehicles may exhibit a "Refuel Error See Manual" message in the instrument panel cluster (IPC) after installing a replacement fuel filler door assembly (7827936). This may be due to a concern with the replacement fuel filler door assembly. If diagnostics in the Workshop Manual (WSM), Section 501-14 Body > Handles, Locks, Latches and Entry Systems > lead to fuel filler door switch replacement, install a new fuel filler door assembly ordered from depot stock to correct this condition. Suspect parts have been cleared from parts depot inventory.
SSM 54783
Service Bulletin/Repair Instructions
Some 2021-2023 F-150 vehicles equipped with a 3.5L PowerBoost engine and 2020-2026 Explorer vehicles equipped with a 3.3L hybrid engine may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P0A1E stored in the powertrain control module (PCM). The vehicle may be unable to enter electric-only drive modes as expected during normal drive cycles. This may be due to the software within the belt integrated starter generator (BISG). For vehicles with this condition, follow Pinpoint Test G located in the Workshop Manual (WSM), Section 303-06D and repair the vehicle as necessary. Note that the BISG is on backorder status at the time of this publication and Ford is working to make parts available. Engineering is investigating this concern. Monitor PTS for updates.
SSM 54425
Service Bulletin/Repair Instructions
Some 2020-2026 Police Interceptor Utility hybrid vehicles may exhibit multiple warning messages, various drivability concerns and/or an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P061B stored in the powertrain control module (PCM). This may be due to the incorrect installation of additional police equipment. Equipment should only use the provided rear power access point and must not use the 12V cranking or 12V auxiliary batteries for power. The vehicle will go to sleep after the ignition key is removed and is not designed to power equipment when the vehicle is not running. If equipped, the Police Engine Idle feature can be used to allow the vehicle to securely remain idling and to power equipment. Refer to the Owners Manual.<br /><br /> If it is determined additional equipment has not been added to the 12V cranking or 12V auxiliary batteries, continue with normal Workshop Manual (WSM) diagnostics, Section 303-04C Engine > Fuel Charging and Controls > Diagnosis and Testing > Pinpoint Test QE.<br /><br /> For general upfitter installation guidelines, refer to:<br />