Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
SSM 52335
Service Bulletin/Repair Instructions
For 2015-2024 Ford and Lincoln vehicles equipped with turbocharged engines and customer concern of an engine oil leak, refer to Workshop Manual (WSM), Section 303-00 for oil leak inspection and testing methods. Ford has evaluated turbochargers replaced for oil leak symptoms and although oil may collect on the external surface of a turbocharger, it is extremely rare for a turbocharger assembly to be the root cause of the oil leak. Careful inspection of the turbocharger oil feed and drain tubes should be performed along with the recommended WSM procedures as needed. Warranty claims for turbocharger replacement going forward will be assessed.
SSM 52314
Service Bulletin/Repair Instructions
During service and repair requiring removal and replacement of a crankshaft bolt and/or crankshaft damper, achieving proper torque of the crankshaft pulley bolt is critical. Incorrect torque may allow the bolt to loosen resulting in the timing gear breaking and engine damage. Replacement of the bolt is critical to the repair and accurately following the installation procedure in the Workshop Manual (WSM) Section, 303-01 is extremely important. The bolt torque procedure can be found in the crankshaft front seal removal and installation procedure or in the engine assembly procedure.
23L06
Service Bulletin/Repair Instructions
Certain 2013-2019 Model Year Explorer Police Interceptor Vehicles - Owner Guide Update
SSM 51536
Service Bulletin/Repair Instructions
For 2000-2024 Ford and Lincoln vehicles, swapping a module from a vehicle for diagnosis purposes is likely to cause errors and is not recommended. It is also not recommended to order a replacement module using a vehicle identification number (VIN) from a different vehicle. Most modules on these affected vehicles are VIN/vehicle specific and hardware variations between modules do exist. Swapping a module from a vehicle or ordering a module using a different vehicle/VIN can cause ineffective repairs and additional vehicle down time. Make sure all appropriate Workshop Manual (WSM) procedures are followed when diagnosing the condition prior to all module replacements and only order modules using the correct VIN.
SSM 51291
Service Bulletin/Repair Instructions
Some 2013-2019 Police Interceptor Utility vehicles, equipped with spotlights, require left and/or right windshield applique/moulding modification if these parts are replaced. Spotlight mounting holes are not present on new replacement windshield appliques/moldings and must be cut using a rotary tool or equivalent. Left and/or right windshield applique/moulding spotlight mounting hole templates are available on the Professional Technician Society (PTS) at Service Tips/Technical Communications and can be printed on an 11X17 inch sheet of paper. Refer to Workshop Manual, Section 501-08 for windshield applique/moulding replacement procedures.
SSM 50861
Service Bulletin/Repair Instructions
Some 2015-2016 vehicles equipped with 6F50/6F55 transmission and built on 2-Nov-2015 and through 1-Feb-2016 may exhibit no reverse, 3rd and 5th gear with diagnostic trouble codes (DTCs) P0715,P0717,P0756 and/or P2701. This may be caused by the direct clutch cylinder/tone wheel (7F283) inadvertently forcing the snap ring out of position resulting in damage to the direct clutch hub (7G384). Service part (7J250) complete rotating 3-5-R clutch module is now available. Refer to Workshop Manual (WSM), Section 307-01. For claiming, use causal part 7F283 and applicable labor operations in Section 7 of the Service Labor Time Standards (SLTS) manual.
SSM 50804
Service Bulletin/Repair Instructions
Some 2013-2023 Ford or Lincoln vehicles with modems activated through FordPass or LincolnWay may experience 12 volt battery drain symptoms when the customer uses non-Ford/Lincoln phone applications as an alternate channel to access vehicle commands such as door lock/unlock, remote start, vehicle location, etc. The battery drain may be caused by excessive calls for data through the vehicle network keeping it in an activated state. Recommend that the customer uninstall the app to ensure this is not contributing to battery symptoms experienced. Advise the customer that unaffiliated third-party app developers do not work directly with Ford to adhere to security, vehicle communication, and privacy requirements.
SSM 50379
Service Bulletin/Repair Instructions
Some 2011-2022 Explorer and 2020-2022 Aviator vehicles may experience an inoperative roof opening panel motor. If diagnostics lead to a motor replacement, visually inspect the original motor for signs of water intrusion. If found, determine source of water leak prior to replacing the motor. Refer to Workshop Manual (WSM), Section 501-17, Pinpoint Test A for 2011-2016 and Pinpoint Test B for 2017-2022 for identifying the source of the water leak.
SSM 50067
Service Bulletin/Repair Instructions
Some 2015-2021 Ford and Lincoln vehicles may exhibit an illuminated MIL with diagnostic trouble codes (DTC) P0011, P0012, P0014, P0015, P0016, P0017, P0018, P0019, P0021, P0022, P0024 and/or P0025. This may be due to small debris causing the VCT solenoid to stick. Before attempting any component diagnosis or replacement of the VCT solenoid, refer to Powertrain Control and Emissions Diagnosis (PC/ED) pinpoint test HK12 to cycle the affected VCT solenoid 10 times to attempt to clear the debris. For claiming, use causal part 6M280 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual.
SSM 49821
Service Bulletin/Repair Instructions
Some 2015-2021 Ford and Lincoln vehicles may exhibit an illuminated MIL with diagnostic trouble codes (DTC) P0011, P0012, P0014, P0015, P0016, P0017, P0018, P0019, P0021, P0022, P0024 and/or P0025. This may be due to small debris causing the VCT solenoid to stick. Before attempting any component diagnosis or replacement of the VCT solenoid, refer to Powertrain Control and Emissions Diagnosis (PC/ED) pinpoint test HK11 to cycle the affected VCT solenoid 10 times to attempt to clear the debris. For claiming, use causal part 6M280 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual.
21B14-S1
Service Bulletin/Repair Instructions
Certain 2013 through 2017 Model Year Explorer and Police Interceptor Utility Vehicles that are Registered or Sold in Certain States/Provinces; Rear Toe Link Ball Joint Inspection This program is a proactive investigation by Ford Motor Company to obtain field data and parts for testing. Ford is voluntarily conducting this program to inspect the toe link ball joint and, if necessary, replace both rear toe links and wheel knuckles on vehicles always registered and always residing in the Nashville, Houston, Miami, Dallas, Atlanta, Phoenix, Winnipeg, and Calgary areas. The replacement toe links and knuckles being installed contain no enhancements and are identical to the parts being removed. It is very important that any parts obtained from this program be returned to Ford for this study.
21B14
Service Bulletin/Repair Instructions
Certain 2013 through 2017 Model Year Explorer and Police Interceptor Utility Vehicles that are Registered or Sold in Certain States/Provinces Rear Toe Link Ball Joint Inspection This program is a proactive investigation by Ford Motor Company to obtain field data and parts for testing. Ford is voluntarily conducting this program to inspect the toe link ball joint and, if necessary, replace both rear toe links and wheel knuckles on vehicles always registered and always residing in the Nashville (and Calgary) area. The replacement toe links and knuckles being installed contain no enhancements and are identical to the parts being removed. It is very important that any parts obtained from this program be returned to Ford for this study
SSM 49210
Service Bulletin/Repair Instructions
Some 2009-2020 Ford and Lincoln vehicles equipped with turbochargers may exhibit an oil leak from the turbocharger oil supply or return tubes, O-rings or 6.7L pedestal gasket. Although oil may collect on the turbocharger, it is very rare for a turbocharger to leak oil. To isolate the source of the leak, refer to Workshop Manual (WSM), Section 303-00 General Information > Diagnosis and Testing > Engine > Engine Oil Leaks - Fluorescent Oil Additive Method procedure. When an oil leak is present at a turbocharger oil supply or drain tube, remove the affected oil tube and inspect for damage, and replace the O-ring seals, pedestal gasket or oil tube as required. Refer to WSM, Section 303-04. For claiming, use the affected oil tube or pedestal gasket as the causal part and applicable labor operations in Sections 6 and 9 of the Service Labor Time Standards (SLTS) Manual.
19M01 S1
Service Bulletin/Repair Instructions
Certain 2013-2019 Model Year Police Interceptor Utility Vehicles Equipped with a 3.7L Engine Catalytic Converter Extended Coverage This program extends the warranty coverage of the catalytic converters to 11 years of service or 120,000 miles from the warranty start date of the vehicle, whichever occurs first
TSB 20-2233
Service Bulletin/Repair Instructions
This article supersedes TSB 19-2026 to update the vehicle model years affected. Some 2000 and newer Ford/Lincoln/Mercury vehicles equipped with aluminum body panels may exhibit corrosion concerns appearing as bubbled and/or peeling paint with or without accompanying white dust. Panel replacement is recommended.
SSM 48876
Service Bulletin/Repair Instructions
For 2013-2019 Ford Explorer vehicles that require rear wheel knuckle and bushing assembly repairs, dealers are advised to follow Workshop Manual (WSM) Procedures and use service parts recommended by Ford only. Ford has received reports of toe link failures after the installation of non-OEM cross-axial ball joints (aka bushings) in the rear wheel knuckle, and if service of the rear wheel knuckle and bushing assembly is required, the recommended repair is to replace the affected 5B758/9 as an assembly only. Refer to WSM, Section 204-02, and the Ford Service Parts Catalog as needed.
SSM 48821
Service Bulletin/Repair Instructions
For 2013-2019 Ford Explorer vehicles that require rear wheel knuckle and bushing assembly repairs, dealers are advised to follow Workshop Manual (WSM) Procedures and use service parts recommended by Ford only. Ford has received reports of toe link failures after the installation of non-OEM cross-axial ball joints in the rear wheel knuckle, and if service of the rear wheel knuckle and bushing assembly is required, the recommended repair is to replace the affected 5B758/9 assembly. Refer to WSM, Section 204-02, and the Ford Service Parts Catalog as needed.
18B19-S1
Service Bulletin/Repair Instructions
Certain 2013-2017 Model Year Police Interceptor Utility Vehicles - Exhaust Odor and Carbon Monoxide Complaints. Certain 2017 Model Year Continental Livery Vehicles - Exterior Door Handle Replacement
17B25-S5
Service Bulletin/Repair Instructions
Certain 2013-2017 Model Year Police Interceptor Utility Vehicles - Exhaust Odor and Carbon Monoxide Complaints
17G01-S2
Service Bulletin/Repair Instructions
Certain 2013-2017 Model Year Police Interceptor Utility Vehicles - Rear Suspension Toe Link Replacement
17G01-S1
Service Bulletin/Repair Instructions
Certain 2013-2016 Model Year Police Interceptor Utility Vehicles - Rear Suspension Toe Link Replacement
16B10
Service Bulletin/Repair Instructions
In some of the affected vehicles, the front control/display interface module (FCDIM) may have been unintentionally programmed for the European market instead of the North American market