Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
tsb18-2190
Some 2011-2012 F-250/F-350 and 2011-2015 F-450/F-550 vehicles equipped with a 6.7L diesel engine built on or before 9-Dec-2014 may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) P2043, P205C and/or P205D. Follow the Service Procedure steps to correct the condition.
16-0066
Some 2012-2016 vehicles equipped with a touchscreen navigation system and the language set to Arabic may exhibit a blank screen. This may be the result of the ribbon cables not being fully seated inside the front display interface module (FDIM) or an improper software configuration of the FDIM.
TSB160066
Touchscreen navigation system - arabic language - blank screen
16B10
In some of the affected vehicles, the front control/display interface module (FCDIM) may have been unintentionally programmed for the European market instead of the North American market
16-0041
PICKUP - 6.7L DIESEL ENGINE - RUNS ROUGH DURING EXHAUST REGENERATION PROCESS - BUILT ON OR BEFORE 2/23/2016 ISSUE Some 2015-2016 F-Super Duty 250-450 Pickup vehicles equipped with a 6.7L diesel engine and built on or before 2/23/2016 may exhibit a runs rough/misfire condition only during the exhaust regeneration process. This condition typically occurs on light throttle tip in between 64-113 Km/h (40-70 MPH) and will not set diagnostic trouble codes (DTCs). The concern may be intermittent and a knocking noise may be present during the concern. SERVICE PROCEDURE 1. Reprogram the powertrain control module (PCM) to the latest calibration using Integrated Diagnostic System (IDS) release 99.03 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com 2. Did the customer indicate the message center displayed a Cleaning Exhaust Filter message prior to the concern? a. Yes - proceed to Step 3. b. No - proceed to Step 6. 3. Remove the left cylinder head. Refer to Workshop Manual (WSM), Section 303-01. 4. Replace all eight (8) exhaust valves and valve seals. Refer to WSM, Section 303-01. (Figure 1)
TSB160041
Pickup - 6.7L Diesel Engine - Runs rough during exhaust regeneration process - built on or before 02/23/2016
15-0158
SUMMARY TO BE PROVIDED ON A FUTURE DATE.
44863
FORD: NO SERVICE ACTION IS RECOMMENDED FOR THIS CONDITION. PLEASE USE AT YOUR DISCRETION. VARIOUS 2010-2015 VEHICLES MAY EXPERIENCE A TURBULENCE NOISE, SIMILAR TO AN HELICOPTER NOISE, AT HIGHWAY SPEEDS WHEN THE REAR DOOR WINDOW(S) OR SUNROOF ARE OPEN. *TA
44848
FORD: CERTAIN 2011-2015 FORD F-SUPER DUTY WITH 6.7 DIESEL ENGINES MAY EXPERIENCE A VIBRATION BUZZ NOISE FROM THE DIESEL FUEL CONDITIONING MODULE (DFCM) AND/OR MAY 10/1/1 PRESSURE FUEL LINES W/O DIAGNOSTIC TROUBLE CODE POOSA. *TA
44876
FORD: CERTAIN 2013-2015 F-SUPER DUTY VEHICLES EQUIPPED WITH A 6.7L DIESEL ENGINE MAY EXPERIENCE PROBLEMS EXITING THE FORCED IDLE STRATEGY IN COLD TEMPS BELOW FREEZING. *TA
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.