Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
TSB 26-2406
Service Bulletin/Repair Instructions
Some of the vehicles listed in the Model statement above may exhibit at least one of the following conditions: Poor shift quality Illuminated powertrain malfunction (wrench) indicator with diagnostic trouble codes (DTCs) P2704 and P0771 stored in the powertrain control module (PCM)/transmission control module (TCM) This may be due to sticking valves in the main control valve body and/or damaged E clutch friction plates and/or E clutch steel plates. Additional model information: 6.7L Diesel Engine 7.3L Gas Engine 10R140 Automatic Transmission
SSM 54976
Service Bulletin/Repair Instructions
Some 2023-2026 F-53 Motorhome Chassis/F-59 Commercial Stripped Chassis and 2024-2026 F-650/F-750/E-Series vehicles equipped with a 6R140 transmission may be limited to 5th gear and reverse gear only. Additionally, the driver will be able to shift back to park. Diagnostic trouble codes (DTC) P2701, P2704, P0757, and/or P0733 may be stored in the powertrain control module (PCM). This may be due to PCM software being unable to command the transmission solenoid clutch actuators when the battery has a low state of charge (SOC) and/or the vehicle has been jump started. To restore proper transmission functionality, charge the battery as stated in the Workshop Manual (WSM), Section 414-01 Charging System > General Information. Cycle the ignition on then off and leave the vehicle off for 5 minutes to confirm the condition is no longer present. To prevent this issue from reoccurring, refer to the Owner's Manual > Storing Your Vehicle > Preparing Your Vehicle for Storage > 12V Battery. Replacement of transmission components will not resolve this condition. Inform the customer that the condition has no impact on tr
SSM 54899
Service Bulletin/Repair Instructions
Some 2023-2026 F-53 Motorhome Chassis/F-59 Commercial Stripped Chassis and 2024-2026 F-650/F-750/E-Series vehicles equipped with a 6R140 transmission may be limited to 5th gear and reverse gear only. Additionally, the driver will be able to shift back to park. Diagnostic trouble codes (DTC) P2701, P2704, P0757, and/or P0733 may be stored in the powertrain control module (PCM). This may be due to PCM software being unable to command the transmission solenoid clutch actuators when the battery has a low state of charge (SOC) and/or the vehicle has been jump started. To restore proper transmission functionality, charge the battery as stated in the Workshop Manual (WSM), Section 414-01 Charging System > General Information. Cycle the ignition on then off and leave the vehicle off for 5 minutes to confirm the condition is no longer present. To prevent this issue from reoccurring, refer to the Owner's Manual > Storing Your Vehicle > Preparing Your Vehicle for Storage > 12V Battery. Replacement of transmission components will not resolve this condition.
SSM 54592
Service Bulletin/Repair Instructions
For 20172026 vehicles equipped with a 10R transmission, a revision to the Road Testing Vehicle procedure has been made in the WSM, located in Section 307-01 > Diagnosis and Testing. This updated procedure improves the diagnosis of customer reported transmission concerns and aids in locating the proper root cause. During diagnosis and testing, details regarding whether the condition is more prevalent when the vehicle is hot or cold, throttle percentage at the time of occurrence, vehicle speed, the specific shift involved, and whether the issue occurs during transmission engagements (N>R, N>D, R>D, or D>R) should be noted. Engineering requests including these detailed operating conditions that will significantly assist with root cause analysis. Diagnosis, testing, and repair should use established labor times outside this article.
SSM 54559
Service Bulletin/Repair Instructions
Some 2026 F-Super Duty and F-650/F-750 vehicles equipped with a 10R140 automatic transmission may exhibit fluid leakage from the transmission fluid pan area. Prior to performing any repairs, thoroughly clean the transmission fluid pan area to ensure accurate identification of the leak source. Before replacing the transmission fluid pan or gasket, verify the torque of the fluid pan bolts and stud bolts. If the torque is incorrect, tighten the pan bolts and stud bolts to the specified torque following the proper torque sequence in Workshop Manual (WSM), Section 307-01. After tightening, verify that the leak has been repaired. If the pan bolts and stud bolts are already torqued correctly, proceed with standard leak diagnosis. Should the diagnosis indicate that pan replacement is required, mark the area of the pan where the leak is present. This information will assist engineering with root cause analysis. For claiming, use causal part 7A194 and labor operation 7000E.
25B65
Other
Certain 2024-2026 Model Year F-650 - F-750 Medium-Duty Trucks equipped with 7.3L engine and 6R140 Transmission Reprogram the Powertrain Control Module
SSM 54338
Service Bulletin/Repair Instructions
Some 2021-2025 F-150 vehicles equipped with a 5.0L/5.2L engine, 2021-2025 F-Super Duty/F-53 Motorhome/F59 Commercial Stripped Chassis vehicles equipped with a 6.8L/7.3L engine and 2021-2026 E-Series/F-650/F-750 vehicles equipped with a 7.3L engine may exhibit a rattle/scraping noise upon startup that may remain after the engine is running. This may be due to the starter motor drive gear not retracting after starting. To correct this condition, inspect the starter motor drive gear and shaft. If the starter motor drive gear slides back and forth by hand and/or shows signs of scoring or damage, replace the starter motor following Workshop Manual (WSM), Section 303-06 Starting System > Removal and Installation > Starter.
TSB 25-2515
Service Bulletin/Repair Instructions
Some of the vehicles listed in the Model statement above may exhibit an incorrectly illuminated MIL with DTC P0384 stored in the powertrain control module (PCM). This may be due to the calibration in the PCM. This condition does not affect vehicle drivability or durability.
SSM 54190
Other
If the vehicle is built with minor feature code "(IEPAA) - LESS CELLPHONE INTERFACE SYSTM", the vehicle is not misbuilt. Do not submit a claim for this condition. To confirm a vehicle is built with a certain minor feature code, review the build information by double-clicking the vehicle identification number (VIN) in the upper left corner in the Professional Technician System (PTS).