Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
962528
Service Bulletin/Repair Instructions
BRAKES - AIR COMPRESSOR/AIR PUMP SUPPORT BRACKET BROKEN - VEHICLES WITH 7.0L ENGINE - ENGINE - 7.0L - ACCESSORY DRIVE BELT ROLL - NOISE - RATTLE - AIR BRAKE COMPRESSOR/AIR PUMP SUPPORT BRACKET CRACKED- VEHICLES WITH 7.0L ENGINE. *TW
BC0313961101
Service Bulletin/Repair Instructions
CHECK ENGINE LIGHT, CODE P030X, WITH NO DRIVEABILITY COMPLAINT. *TW
BC0602961101
Service Bulletin/Repair Instructions
INSTRUCTIONS ON SECURING SPARE TIRE TO UNDERBODY OF VEHICLE. *TW
BC0693961023
Service Bulletin/Repair Instructions
INVESTIGATING 7.3L IRREGULAR IDLE. *TT
BC0844961008
Service Bulletin/Repair Instructions
E4OD TRANS MAY EMIT A TICK/RATTLE NOISE WHEN DRIVING AT LIGHT LOADS IN 1ST GEAR AT 1100 TO 1800 RPM RPM. *TT
BC0883961004
Service Bulletin/Repair Instructions
VEHICLES MAY EXHIBIT AN EXHAUST LEAK &/OR NOISE DUE TO WARPED EXHAUST MANIFOLDS. *TT
BC5191961001
Service Bulletin/Repair Instructions
FOR CONCERNS OF STALLING, REFLASH PCM W/ 1996 CALIBRATION (R11 LEVEL). *TT
BC5195961001
Service Bulletin/Repair Instructions
FIRESTONE P235 TIRES MAY EXHIBIT A HIGH FREQUENCY VIBRATION AT 65-75 MPH. *TT
BC5201961001
Service Bulletin/Repair Instructions
INVESTIGATING 7.3L IRREGULAR IDLE. *TT
BC9688961001
Service Bulletin/Repair Instructions
INFORMATION FOR WHEN DIAGNOSING CONCERNS W/ FACTORY INSTALLED CELLULAR PHONES. *TT
BC0230960102
Service Bulletin/Repair Instructions
HEADLAMP OR WHEEL ALIGNMENT REQUIRED BECAUSE OF SPECIAL BODIES ADDED TO INCOMPLETE VEHICLES (E/F SERIES CHASSIS CABS) OR BECAUSE OF SPECIAL EQUIPMENT INSTALLATION (MODIFICATION CONVERSION) AFTER THE VEHICLE LEAVES THE ASSEMBLY PLANT IS NOT REIMBURSEABLE.
BC0285960102
Service Bulletin/Repair Instructions
5.8L, C-6 TRANSMISSION, TRANS FLUID OVERFILL. TRANS MAY NOT ENGAGE OR MAY SLIP IF FLUID LEVEL IS ADJUSTED. THIS IS FROM INCORRECT FLUID FILLER TUBE ASSY (7A228). BEFORE ADJUSTING FLUID LEVEL, CHECK FOR CORRECT FLUID FILLER TUBE ASSY (7A228). REMOVE FLUID LEVEL INDICATOR (7A020) & TUBE. INSERT INDICATOR IN TUBE. MEASURE FROM BOTTOM OF FILLER TUBE TO BOTTOM OF INDICATOR. IF IT EXCEEDS 80 MM (3 1/8 IN) REPLACE FILLER TUBE WITH F6TZ-7A228-G.