24L05
Other
Certain 2011-2022 Model Year Super Duty Vehicles Equipped with 6.7L Engine - Emission Control Information Label Update for Qualified Vehicles
Vehicle report
2016 FORD redundant F-250
Service bulletins
9 bulletinsTechnical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
17M04-S2
Service Bulletin/Repair Instructions
Certain 2014-2016 Model Year F-250 ? F-550 and 2016 Model Year F-650 - F-750 Vehicles, With 6.7L Diesel Engine - Crankcase Ventilation Oil Separator Assembly
SSM 46085
Service Bulletin/Repair Instructions
The Powertrain Control/Emissions Diagnosis (PC/ED) manual has been revised for diagnosing electronic throttle bodies (ETBs). The ETC_ACT and ETC_DSD PIDs should not used to diagnose possible ETB concerns. The IDS has a limited refresh rate when reading these PIDs and cannot display quickly enough to validate a concern. The PCM automatically monitors these inputs more accurately and will set diagnostic trouble codes (DTCs) when appropriate. Using these PIDs for diagnostics will lead to inaccurate results and improper ETB replacements. If a concern is intermittent and no DTCs are present, refer to historical DTCs and the PC/ED, Section 3 No DTCs Present Index chart for further information.
TSB160066
Service Bulletin/Repair Instructions
Touchscreen navigation system - arabic language - blank screen
16B10
Service Bulletin/Repair Instructions
In some of the affected vehicles, the front control/display interface module (FCDIM) may have been unintentionally programmed for the European market instead of the North American market
16-0041
Service Bulletin/Repair Instructions
PICKUP - 6.7L DIESEL ENGINE - RUNS ROUGH DURING EXHAUST REGENERATION PROCESS - BUILT ON OR BEFORE 2/23/2016 ISSUE Some 2015-2016 F-Super Duty 250-450 Pickup vehicles equipped with a 6.7L diesel engine and built on or before 2/23/2016 may exhibit a runs rough/misfire condition only during the exhaust regeneration process. This condition typically occurs on light throttle tip in between 64-113 Km/h (40-70 MPH) and will not set diagnostic trouble codes (DTCs). The concern may be intermittent and a knocking noise may be present during the concern. SERVICE PROCEDURE 1. Reprogram the powertrain control module (PCM) to the latest calibration using Integrated Diagnostic System (IDS) release 99.03 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com 2. Did the customer indicate the message center displayed a Cleaning Exhaust Filter message prior to the concern? a. Yes - proceed to Step 3. b. No - proceed to Step 6. 3. Remove the left cylinder head. Refer to Workshop Manual (WSM), Section 303-01. 4. Replace all eight (8) exhaust valves and valve seals. Refer to WSM, Section 303-01. (Figure 1)
TSB160041
Service Bulletin/Repair Instructions
Pickup - 6.7L Diesel Engine - Runs rough during exhaust regeneration process - built on or before 02/23/2016
PC-01.12.2016
Service Bulletin/Repair Instructions
In monitoring our technical service inquiries and technical service bulletins from Ford, there is the potential for moderate to severe steering wheel oscillation (wobble) to occur. After extensive testing and outside feedback, the following details have been established to correct or prevent steering wheel oscillation occurrences in lifted 05-16 Ford Super Duty 4wd pickups.
15-0158
Service Bulletin/Repair Instructions
SUMMARY TO BE PROVIDED ON A FUTURE DATE.
Reading this report
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.