Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
26-DS-001G TSB
Service Bulletin/Repair Instructions
Some GV70 (JK1, JK1A), GV80 (JX1) and G80 (RG3) vehicles may have a hum or whine noise condition from the rear differential at certain speeds. This bulletin describes the procedure to inspect the vehicle for the hum or whine noise and, if necessary, to tighten the rear differential lock nut to specification. If the hum or whine noise remains after tightening the lock nut, then this bulletin provides instructions to replace the rear differential or other driveline components as necessary.
26-01-003G-1 DCS
Service Campaign
Certain GV70 (JK1, JK1A), GV80 (JX1) and GV80 Coupe (JX1) vehicles may exhibit a loose windshield glass garnish seal. Technical Service Bulletin (TSB) 26-01-003G-1 provides instructions to remove the old garnish and install new parts.
26-01-003G-1 TSB
Service Campaign
Certain GV70 (JK1, JK1A), GV80 (JX1), and GV80 Coupe (JX1) vehicles may exhibit a loose windshield glass garnish seal. This bulletin provides instructions to remove the old garnish and install new parts.
26-01-035G DCS
Service Campaign
Some vehicles may exhibit a loss of connectivity or interruptions in the middle of using Connected Car Services (CCS) functions. This may be due to an occasional disconnection on Verizon's communication network. Technical Service Bulletin (TSB) 26-01-035G provides instructions to verify Connected Car Data Communication Unit (DCU) network connection and if needed, reset the DCU in Dealer Mode to resolve the connection.
26-01-035G TSB
Service Campaign
Some vehicles may exhibit a loss of connectivity or interruptions in the middle of using Connected Car Services (CCS) functions. This may be due to an occasional disconnection on Verizon’s communication network. Follow the procedures in this bulletin to verify Connected Car Data Communication Unit (DCU) network connection and if needed, reset the DCU in Dealer Mode to resolve the connection.
DTN DCS
Other
The National Highway Traffic Safety Administration (NHTSA) has issued an urgent safety advisory regarding dangerous, counterfeit driver‑side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN), that have been identified in U.S. vehicles following prior crashes, theft, or non‑certified airbag replacements. These inflators are not approved for use, may rupture during deployment, and have caused serious injuries and fatalities. Please see attached announcement, provided by NHTSA, for more details.
DTN DL
Other
The National Highway Traffic Safety Administration (NHTSA) has identified the presence of substandard and dangerous driver’s-side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN). These inflators were not supplied, approved, or authorized by the vehicle manufacturers and have primarily been found in vehicles that previously experienced a crash and underwent airbag replacement using non-genuine parts. These dangerous inflators have ruptured during deployment, posing a serious risk of injury or death due to metal fragments entering the vehicle cabin. To date, Hyundai is aware of three people who have died while driving a Hyundai vehicle with one of these substandard replacement airbag inflators that deployed in what likely would have been a survivable crash. NHTSA has issued a public advisory urging vehicle owners and service professionals to have vehicles inspected if there is reason to believe that a non-genuine replacement airbag may have been installed. Vehicles with salvage or rebuilt titles, prior airbag deployments, or unknown repair histories may present a higher risk. NHTSA strongly cautions against self-inspection by vehicle owners and recommends inspection by trained technicians.
26-AD-001G
Service Bulletin/Repair Instructions
Some 2020MY and newer vehicles equipped with a front view camera may illuminate certain warning lights and trigger DTC C272246 fault code for the front camera. In the following cases, the front camera auto-calibration range may be exceeded while driving: • If the front camera is not properly installed and is completely or partially detached. • In case of excessive changes affecting the vehicle's balance (e.g., loading excessively heavy cargo in a specific location of the vehicle, or significant under-inflation of the tires). • Specific road conditions affecting the vehicle's balance (e.g., excessive road crown) This TSB provides instructions on how to service the vehicle when the front camera related warning light(s) are triggered due to system out of calibration (DTC_C272246).
26-01-003G DCS
Service Campaign
Certain GV70 (JK1), GV80 (JX1) and GV80 Coupe (JX1) vehicles may exhibit a loose windshield glass garnish seal. Technical Service Bulletin (TSB) 26-01-003G provides instructions to remove the old garnish and install new parts.
26-01-003G TSB
Service Campaign
Certain GV70 (JK1), GV80 (JX1), and GV80 Coupe (JX1) vehicles may exhibit a loose windshield glass garnish seal. This bulletin provides instructions to remove the old garnish and install new parts.
25-BD-012H TSB
Service Bulletin/Repair Instructions
This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.
25-01-077G TSB
Service Campaign
Certain GV70 (JK1), GV80 (JX1), and GV80 Coupe (JX1) vehicles may exhibit a loose windshield glass garnish seal. This bulletin provides instructions to remove the old garnish and install new parts.
25-01-077G DCS
Service Campaign
Certain GV70 (JK1), GV80 (JX1) and GV80 Coupe (JX1) vehicles may exhibit a loose windshield glass garnish seal.