Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
M1684
Service Bulletin/Repair Instructions
SERVICE BULLETIN M1684: MARKET SPECIFIC BATTERY INTRODUCTION. PURPOSE: Initial Release. This bulletin informs dealers of the availability of new batteries for new Original Equipment (OE) vehicle production and in the Parts and Accessories (P&A) catalog. Availability of the new Absorbed Glass Mat (AGM) batteries will vary by market and will be transitioning over the next few months. NOTE: The ring terminal screws are not compatible between Leoch and East Penn batteries. The new batteries will include new ring terminal screws, which must be used. The ring terminal screws from the old battery need to be discarded.
M1490
Service Bulletin/Repair Instructions
SERVICE BULLETIN M1490 (V 24.8.8): DIGITAL TECHNICIAN II - UPDATES AND RELEASE NOTES. PURPOSE: This bulletin informs dealers that Harley-Davidson has made a software update to Digital Technician II (DT II). DIGITAL TECHNICIAN II (PART NUMBER: HD-48650). Version 24.8.8. Release Date: Week of August 5, 2024. New Features for Harley-Davidson vehicles: Advanced Module Replace for 2021 and later Revolution Max; 2023 and later CVO Touring; and 2024 Street Glide (FLHX), Road Glide (FLTRX). New Features for LiveWire vehicles: Updated calibrations for 2024 S2DM EV1/ EV6; 2024 S2MH EV1; and 2024 S2DM, S2MH. Changes: Added Hand Control Module (HCM) (Part No. 71500522A and 71500536A) for reflash support.
PAB1158
Service Bulletin/Repair Instructions
GENUINE MOTOR PARTS AND MOTOR ACCESSORIES BULLETIN PAB1158: OIL FILTER PACKAGING AND CASE QUANTITY UPDATE. PURPOSE: To inform dealerships that Harley-Davidson has made updates to oil filters including new part numbers, packaging design, and bulk case quantity changes.
M1123
Service Bulletin/Repair Instructions
SERVICE BULLETIN M1123: 49 STATE/CANADA RECALL 0603 - CARBURETOR JET NEEDLE REPLACEMENT. PURPOSE: Revision. As recently advised in the May 29 Dealer Communications, Harley-Davidson has learned that certain 2002 carburetor equipped Dyna and Softail model motorcycles do not meet portions of Canadian, U.S. and California air quality regulations. In the interest of regulatory compliance, as well as customer satisfaction, Harley-Davidson has elected to initiate a voluntary recall (Noncompliance Recall Code 0603) to replace the carburetor jet needle in all affected motorcycles.
1HDM5V2A05
Service Bulletin/Repair Instructions
TECH ARTICLE TA0023: TA0023: Crankshaft Rod Bearing. Purpose: Technicians have been falsely identifying connecting rod bearings as failed due to a perception of resistance as the rods are rotated. The clearance of the Twin Cam and Milwaukee-Eight® crank pin bearings are maintained to a very tight range. This optimizes performance and maintains low mechanical noise in operation. The connecting rod bore can also distort slightly in operation due to stress relaxation. As a result, bearing clearance decreases due to the contact zone broadening and the load being distributed over more rollers. The combination of a bore being slightly out of round and reduced bearing clearance can result in varying degrees of resistance through the range of motion. Axial clearance is also tightly controlled for proper alignment. For these reasons, zones of resistance can be found when the connecting rods are rotated by hand through their range of motion. Resistance during rod motion, by itself, is not an indication of a performance or durability concern.