Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
167-T2606-1
TT-26-003 COE HV Battery Thermistor DTC P3001 - TC43 When servicing a COE Hybrid with the HV light on and code P3001 - TC43 set. Diagnosis has led to replacing the Battery ECU and/or the HV Battery. We have found that replacing the HV Battery Thermistor has resolved this concern in most cases. Certain 13MY – 20MY Hybrid Cab-Over equipped with a J05
167-T2406-1
After connecting to a truck using DX3, it may be necessary to review or create a DX Diagnostic Report for review.
167-T2406-2
This article will provide dealership technicians with information on how to open a tech assist case and discuss what is required when opening a Tech Assist Case.
167-T2301-2
DX3 VEHICLE SPEED AND CRUISE SETTINGS. TT-23-006
167-R1701-11
The engine ECU (Engine Control Unit) on all 2016MY-2018MY trucks contained in dealer inventory need to be reprogrammed prior to delivery. Subject vehicles contain an error in the DEF monitoring program. To eliminate this situation, it is necessary to reprogram the engine ECU with improved software prior to sale of the vehicle.
167-R1702-11
The engine ECU (Engine Control Unit) on all 2016MY-2018MY trucks contained in dealer inventory need to be reprogrammed prior to delivery. Subject vehicles contain an error in the DEF monitoring program. To eliminate this situation, it is necessary to reprogram the engine ECU with improved software prior to sale of the vehicle.
167-B1702-11
All 16MY-18MY units that have been sold and are in service today will be addressed with a future campaign once the proper agencies have been notified and approval is received.
167-T1702-05
TT-17-009 Beginning with 2017 model year, all Hino vehicles are equipped with a particulate matter (PM) sensor near the exhaust exit. A ceramic sensing element is used in the PM sensor and can be damaged or broken if the sensor is dropped or impact occurs to the head of the sensor. If removal or replacement of the PM sensor is necessary, care should be taken with both the old and new sensors to prevent any damage or additional damage to the sensor. For warranty consideration, the PM sensor MUST be returned in the original box and the plastic protective cap installed. 2017 and 2018 model year Conventional trucks and COE (Cab Over Engine) trucks.
167-B1621-12
SB-16-010 Correction of the inspection of the DPR filter.
167-T1514-12
TT-15-016 The purpose of this publication is to communicate the standard measuring positions on the Hino chassis. In some cases, the customer may report a visual chassis posture concern where the chassis appears to be leaning more towards the driver side or passenger side. The following publication can be referenced to obtain the manufacture?s measurement positions and specifications. Should the truck not meet the specifications, you should consider the following potential causes noted in the inspection guideline section below.
167-B1312-12
SB-13-009 This bulletin is to inform dealers and workshops of proper paint codes for all Hino models. ALL MODELS
HINO SB 12-003
INFORMATION OF REMOTE KEY REGISTRATION PROCEDURE FOR
167-T0706-12
07 - 006 VOLTAGE DROP TEST
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.