Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
167-T1910-01
This design change of the idler gear case and idler gear bolt is to address the idler gear bolt loosening under abnormal loading from fuel supply pump and the gear train. The redesigned idler gear case and idler gear bolt are designed to increase their robustness and prevent the idler gear bolt from loosening.
167-B1811-01
SB-18-030 Air Spring Shield
167-R1808-02
CAB OVER ENGINE (COE) ECU, DCU AND VCS SOFTWARE UPDATE
167-P1602-12
13-008 Injection Pump Drive Case. Please note the following part number changes to the Injection Pump Bearing Case. Not replacing the correct replacement parts WILL result in major engine damage. The Hino Ordering system has been modified to make the below changes into a kit that consist of the correct parts when ordering the kit ID number. The below information illustrates the kit components per engine and date ranges.
167-T1520-12
TT-15-024 During engine performance diagnostics, comparative readings from a like engine can be useful. Below are data points from a known good engine to use for comparisons.
TT-15-024
2005-07 Conventional Light Duty Truck (LDT) with a J05E engine. During engine performance diagnostics, comparative readings from a like engine can be useful data points from a known good engine to use for comparisons (refer data in PDF documents).
167-T1514-12
TT-15-016 The purpose of this publication is to communicate the standard measuring positions on the Hino chassis. In some cases, the customer may report a visual chassis posture concern where the chassis appears to be leaning more towards the driver side or passenger side. The following publication can be referenced to obtain the manufacture?s measurement positions and specifications. Should the truck not meet the specifications, you should consider the following potential causes noted in the inspection guideline section below.
167-B1523-12
SB-15-026 A subject vehicle may exhibit an engine oil leak or engine coolant leaking externally from the engine head gasket sealing area on the exhaust manifold side of the engine. An improved head gasket has been made available as a service part and should be used if replacement of the head gasket is necessary. Improvement of the head gasket includes the addition of rubber seals around the engine oil and engine coolant port holes.
167-B1312-12
SB-13-009 This bulletin is to inform dealers and workshops of proper paint codes for all Hino models. ALL MODELS
167-B1509-12
SB-15-009 This bulletin provides the corrective action for a fluid overflow condition from the main housing breather at startup in cold ambient temperatures at or below +5F (-15C).
167-B1415-12
SB-14-003 The following is to inform you of the revision of the inspection procedure for the DTC?s P0340 and P0341. You are kindly requested to attach this service data to the relevant pages of the workshop manuals for maintenance and to use for servicing.
08-004
ECU File Downloading, Reprogramming and INF File Uploading via HinoNet
08-001
DAVCO FUEL FILTER CHANGE AND PRIMING PROCEDURE
167-P0805-12
PTB 08-08 2005-2008 Quick Reference Guide Correction to Page 60
167-P0802-12
PTB 03-08 Spring Assemblies.
167-P0803-12
PTB 01-08 Complete Engine Assembly Part Numbers
SB 07-007
The document is to inform the dealers of the release of Hino Diagnostic eXplorer (HINO DX) Ver. 1.2.0 as described below.
167-T0707-12
07 - 008 DX REPORT ? EXPORTING, SAVING AND PRINTING FROM PAST WORK INFORMATION
167-P0702-12
Revised Warranty Process ? Denso Fuel Pumps & Injector Nozzles Exchange Denso Fuel Pumps & Injector Nozzles. Effective immediately, fuel pumps and injector nozzles replaced under warranty are to be purchased from the Memphis PDC. It is no longer necessary to order warranty replacement pumps and nozzles from Denso.
167-T0706-12
07 - 006 VOLTAGE DROP TEST
07-005
The ECM receives a brake light signal, which deactivates the accelerator pedal
167-P0701-12
Introduction of Exchange Turbocharger Program. Hino Trucks is pleased to announce the introduction of the Turbocharger Exchange Program for its 2005 ? 2008 Model Year trucks. Effective June 21, 2007, the following turbocharger part numbers will become new exchange products: 2005 ? 2008 Model Year trucks.
167-T0705-12
07 - 005 No Throttle Response (brake light switch)
07-004
ABS warning light is on. Code 3-1 thru 3-4.
167-T0704-12
07 - 004 ABS Wheel Sensor (active fault 3-1 thru 3-4)
06-012
Rear Axle gear ratio change or change in tire size
167-T0708-12
06 - 012 SPEEDOMETER PULSE ADAPTER CONVERSION FORM
Lock Assembly Ki
Lock Assembly Kit (Keyed Alike)
167-P0703-12
TB-001-07 Hino uses both Davco and Racor fuel/water separators on its vehicles. To determine the correct filter you must know which one is on the vehicle. The Davco is shown on the left. The Racor is shown on the right and has a primer button.
167-P0704-12
TB-04-07 An engineering change in connecting rods was made from a stud with nuts to fasten the cap, to a bolt only to fasten the cap. The connecting rods with the stud and nuts are no longer available. The two different styles are interchangeable however the bearings are not. The bearing ?tang? was relocated as well as a difference in the width.
06-010
Restricted fuel system causing low power. 1. Fuel lines plugged or restricted 2. Fuel filter plugged
06-011
Fuel diluting engine oil
167-T0605-12
06 - 010 LOW POWER (fuel restriction)
167-T0606-12
06-011 HIGH PRESSURE FUEL PUMP FRONT SEAL FAILURE
06-008
No throttle response on 2007 air brake chassis with automatic transmissions when selector placed in drive. No cruise control on 2007 air brake chassis with manual transmissions.
06-009
Chassis experienced premature brake failure after a brake job was performed which included brake caliper replacement.
167-T0603-12
06 - 008 ABS EXTENSION HARNESS No throttle response on 2007 air brake chassis with automatic transmissions when selector placed in drive. No cruise control on 2007 air brake chassis with manual transmissions.
Reman Alternator
Remanufactured Alternators and Starters for Conventional Trucks
006-06
Cut Key Ordering Process
06-001
RUNNING OUT OF FUEL, DUAL TANKS NOT EQUALIZING
167-T0601-12
06-001 RUNNING OUT OF FUEL, DUAL TANKS NOT EQUALIZING
05-011
This document is to inform dealers and workshops of the correction to Workshop Manuals for J08 engines listed below.
SB 05-010
This document is to inform dealers of the correction to Worshop Manuals for the J08E engines.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.