Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
26-BD-003H TSB
Some Santa Cruz (NXT) vehicles may have a tonneau cover that does not latch or unlatch, does not retract properly, and/or has a v-gap that is present when closed. This may be due to a broken or missing clip on the underside of the tonneau cover. This bulletin provides instructions to inspect and, if necessary, repair the tonneau cover function using the Tonneau Cover Repair Kit or by replacing the tonneau handle and latch assembly.
26-AT-005H TSB
This bulletin provides information related to a Transmission Control Unit (TCU) software update for some vehicles equipped with an 8-speed wet dual clutch transmission (8WDCT). The software update revises the touch point learning variation, improving drivability and judder symptoms. Some 8WDCTs (indicated by a new part number) received an updated clutch spring. The correct TCU software update must be matched with the correct corresponding 8WDCT hardware, otherwise, drivability concerns may occur. This service procedure should be performed prior to any 8WDCT replacements done for drivability/judder concerns.
26-AT-003H TSB
Some Santa Fe (MX5A) and Santa Cruz (NXT) vehicles may exhibit a low idle or excessive vibration while in Drive or Reverse, or DTC P050600 (Idle Air Control System – RPM Lower than Expected) caused by the one-way clutch sprags being misaligned. This bulletin provides instructions to remove the automatic transmission and replace the torque converter.
26-01-044H TSB
Certain Santa Cruz (NXT) vehicles may experience Over-the-Air (OTA) update failures due to outdated Central Communication Unit (CCU) software. This bulletin provides instructions to perform a software update for the CCU.
DTN DCS
The National Highway Traffic Safety Administration (NHTSA) has issued an urgent safety advisory regarding dangerous, counterfeit driver‑side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN), that have been identified in U.S. vehicles following prior crashes, theft, or non‑certified airbag replacements. These inflators are not approved for use, may rupture during deployment, and have caused serious injuries and fatalities. Please see attached announcement, provided by NHTSA, for more details.
DTN DL
The National Highway Traffic Safety Administration (NHTSA) has identified the presence of substandard and dangerous driver’s-side airbag inflators manufactured by Jilin Province Detiannuo Automobile Safety System Co., Ltd. (DTN). These inflators were not supplied, approved, or authorized by the vehicle manufacturers and have primarily been found in vehicles that previously experienced a crash and underwent airbag replacement using non-genuine parts. These dangerous inflators have ruptured during deployment, posing a serious risk of injury or death due to metal fragments entering the vehicle cabin. To date, Hyundai is aware of three people who have died while driving a Hyundai vehicle with one of these substandard replacement airbag inflators that deployed in what likely would have been a survivable crash. NHTSA has issued a public advisory urging vehicle owners and service professionals to have vehicles inspected if there is reason to believe that a non-genuine replacement airbag may have been installed. Vehicles with salvage or rebuilt titles, prior airbag deployments, or unknown repair histories may present a higher risk. NHTSA strongly cautions against self-inspection by vehicle owners and recommends inspection by trained technicians.
26-01-035H TSB
Some vehicles may exhibit a loss of connectivity or interruptions in the middle of using Bluelink functions. This may be due to an occasional disconnection on Verizon’s communication network. Follow the procedures in this bulletin to verify Bluelink Data Communication Unit (DCU) network connection and if needed, reset the DCU in Dealer Mode to resolve the connection.
26-AD-001H TSB
Some 2019MY and newer vehicles equipped with a front view camera may illuminate certain warning lights and trigger DTC C272246 fault code for the front camera. In the following cases, the front camera auto-calibration range may be exceeded while driving: • If the front camera is not properly installed and is completely or partially detached. • In case of excessive changes affecting the vehicle's balance (e.g., loading excessively heavy cargo in a specific location of the vehicle, or significant under-inflation of the tires). • Specific road conditions affecting the vehicle's balance (e.g., excessive road crown) This TSB provides instructions on how to service the vehicle when the front camera related warning light(s) are triggered due to system out of calibration (DTC_C272246).
25-BD-011H-1 TSB
Some Santa Cruz (NXT) vehicles may have a tonneau cover that does not latch or unlatch, retract properly, and/or have a v-gap is present when closed. This may be due to a broken or missing clip on the underside of the tonneau cover. This bulletin provides instructions to inspect and, if necessary, repair the tonneau cover function using the Tonneau Cover Repair Kit or replacing the tonneau handle & latch assembly.
25-01-079H-1 DCS
Certain Santa Cruz (NXT) vehicles may exhibit a Data Communication Unit (DCU) software error due to the internal timer initialization logic not being implemented. The DCU module may shut down telematics services after one year. Technical Service Bulletin (TSB) 25-01-079H-1 provides instructions to perform a software update for the DCU module.
25-01-079H-1 TSB
Certain Santa Cruz (NXT) vehicles may exhibit a Data Communication Unit (DCU) software error due to the internal timer initialization logic not being implemented. The DCU module may shut down telematics services after one year. This bulletin provides instructions to perform a software update for the DCU module.
25-BD-012H TSB
This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.
25-01-079H DCS
Certain Santa Cruz (NXT) vehicles may exhibit a Data Communication Unit (DCU) software error due to the internal timer initialization logic not being implemented. The DCU module may shut down telematics services after one year. Technical Service Bulletin (TSB) 25-01-079H provides instructions to perform a software update for the DCU module. This update can also be conducted via OTA. The customer can complete on his/her own if he/she has an active subscription to Hyundai Bluelink. A visit to the dealership is not required. Deployment of the OTA to Bluelink customers is planned starting the week of 11/03/25.
25-01-079H TSB
Certain Santa Cruz (NXT) vehicles may exhibit a Data Communication Unit (DCU) software error due to the internal timer initialization logic not being implemented. The DCU module may shut down telematics services after one year. This bulletin provides instructions to perform a software update for the DCU module.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.