Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
23-BD-002H
This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.
21-AT-006H
Hyundai approves only the ATF, DCT gear oil and IVT gear oil specified in the vehicleâÂÂs ownerâÂÂs manual. ï· Use of other ATF may result in improper shift quality or other drivability conditions. ï· Use of other DCT and IVT gear oil may result in reduced durability. Hyundai does not approve the use of any aftermarket ATF or gear oil additives.
21-EM-004H
This bulletin provides the service procedure for engine connecting rod bearing clearance testing. Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required steps.
21-BR-002H
This bulletin provides best practice recommendations when performing brake service procedures.
21-EM-003H
This bulletin provides the inspection procedure and repair guidelines for certain vehicles listed below.
20-BR-002H
This bulletin describes the procedure to inspect and identify fluid which may appear around the brake caliper area.
20-SS-004H
This bulletin provides tire vibration service procedures, including how to optimize vehicle vibration performance. For all wheel/tire balance claims, the âTire Balance Data Sheetâ must be fully completed including imbalance and Road Force Variation (RFV) data. The Data Sheet can be found at the end of this bulletin.
20-BD-014H
This bulletin provides information regarding condensation related to moisture accumulation in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. The TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes, or during normal driving operation.
20-SS-002H(1)
This bulletin provides information on tire maintenance best practices and procedures for dealers and customers to maximize tire life and performance.
20-BD-007H-1
This bulletin describes the general guidelines to help disinfect and protect vehicle exterior/interior surfaces using recommended safe chemical products.
20-EE-003H
This bulletin provides information on identifying dealer stock vehicles with either: ⢠A Battery SOC alert - low Battery State of Charge (SOC) at or below 50%. ⢠A 30 Day alert - vehicle has not started and reported an SOC in 30 days.
20-AT-016H
The automatic transmission warranty repair policy authorizes in-dealership repairs of the following components for both OEM (new) and remanufactured automatic transmissions:
20-BD-007H
This bulletin describes the general guidelines to disinfect and protect vehicle interior surfaces using certain safe chemical products.
20-SS-001H
This bulletin describes the requirements for all wheel alignment and/or vehicle tracking claims and best practices when diagnosing and conducting alignment-related repairs for all models and model years.
20-BE-001H
This bulletin provides guidelines to inspect the USB, head unit, and multi-box for common connection conditions. 2. This bulletin presents guidelines to inspect for common Android Auto and Apple CarPlay connection conditions. 3. This bulletin provides physical differences between the USB 2.0 port and USB 3.0 port.
19-BE-011H-1
The Blind Spot Detection (BSD) or Blind-Spot Collision Warning (BCW) is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. The BSD/BCW detects vehicles within the blind spot zone and gives off an alarm (visual and audible). The two magnetic radar sensors provide these functions for BSD/BCW: ? Senses other vehicles in the BSD/BCW zone and turns on the BSD/BCW warning lamp for the driver. The warning lamp starts blinking, along with an audible sound, when the driver turns on the turn signal lamp to enter the lane where another vehicle is driving.
19-GI-006H
This bulletin provides instruction detailing the proper methodology for scanning and uploading captured GDS data files to the Techline Repository. Compliance with this bulletin ensures that the GDS data files are correctly transferred and matched with a Techline Case number.
5NP-S9D9P-10
THIS BULLETIN PROVIDES INFORMATION ON COMPONENTS, ATTRIBUTES, AND PRECAUTIONS OF THE 7-SPEED DRY-TYPE DUAL CLUTCH TRANSMISSION (DCT).
TSB-11-BR-002
HYUNDAI: ALL SONATA HYBRIDS. BRAKE BLEEDING PROCEDURE. *RM
0636006
EXHAUST GAS RECIRCULATION (EGR) SYSTEM DIAGNOSIS. *KB
133
PRE-CONDITIONS FOR READINESS MONITORS. *TT
0236030
OBD-II READINESS TEST DRIVE CYCLE. *TT
0290009
SUBJECT REGARDING DIAGNOSTIC GUIDE FOR CLIFFORD AND DEI SECURITY SYSTEM. *JG
117
INFORMATION ON EXHAUST GAS RECIRCULATION. *SLC
9936004
SUBJECT PERTAINING TO ( ELECTRICAL TROUBLESHOOTING MANUAL ) ETM CORRECTION FOR GROUND DISTRIBUTION . *TT
9836009
INFORMATION ON FUEL INJECTOR CONFIGURATION. *YC
9806-9836004
SHOP MANUAL ON DOHC SPARK PLUG WIRE ROUTING. *YC
9850002
SPECIFICATION ON REAR BRAKE DISC MINIMUM THICKNESS. *YC
9840003
VEHICLES MAY EXHIBIT A HARSH 3-2 DOWNSHIFT. *YC
9880007
INSTALLATION PROCEDURES ON WOOD INTERIOR TRIM. *YC
9880005
VEHICLES MAY EXPERIENCE A WIND NOISE IN THE AREA AROUND THE RIGHT
9890005
SUBJECT ON AIRBAG REPAIR KIT PART NUMBERS. *TT
97110120013
DESCRIPTION AND INFORMATION ON A NEW FRONT CASE. *YC
97110120014
PROVIDED PROCEDURES FOR THE INSTALLATION OF A BLOCK HEATER. *YC
97110160006
SERVICE PROCEDURE AND INSTALLATION OF THE TRUNK MOUNTED SPOILER. *YC
97110160007
INFORMATION ON TORSION BARS, GAS STRUTS AND CHMSL. *YC
97110199004
VARIOUS INFORMATION ON PROPER CARE FOR VEHICLE EXTERIORS AND CORRECTIVE STEPS FOR ENVIRONMENTAL DAMAGE. *YC
97100120012
SHOP MANUAL CORRECTION ON CYLINDER HEAD BOLT TORQUE SPECIFICATION. *YC
97100140032
INFORMATION REGARDING END CLUTCH RETAINER AND CLUTCH PLATE MODIFICATION. *YC
97090120009
INSTALLATION INSTRUCTIONS ON BLOCK HEATER. *YC
97090136003
SUBJECT PERTAINING TO THE CRANKSHAFT AND CAMSHAFT POSITION SENSOR LOCATION. *YC
97090140029
THROTTLE POSITION SENSOR AND IDLE SWITCH ADJUSTMENT PROCEDURE. *YC
9701998
RECALL 97V-026 - THE WINDSHIELD WIPER MOTOR THERMAL SWITCH CIRCUIT CONTACT POINTS MUST BE CLEANED ON CERTAIN HYUNDAI VEHICLES WHICH FALL INTO THE FOLLOWING PRODUTION RANGES TO CORRECT A POSSIBLE INTERMITTENT INTERRUPTION OF WIPER OPERATION- A WIPER MOTOR SERVICE KIT (PART #00305-CMP00-30) WILL BE SENT TO EACH DEALERSHIP CONTAINING THE SUPPLIES REQUIRED TO PERFORM THIS PROCEDURE- EACH KIT CAN SERVICE UP TO TEN (10) VEHICLES- ADDITIONAL KITS CAN BE ORDERED FROM YOUR FACING PDC- MODEL/PRODUCTION DATE RANGE: ACCENT 3/04/96 THROUGH 10/18/96- ELANTRA (SADAN & WAGON) 11/20/95 THROUGH 10/18/96- SONATA 12/18/95 THROUGH 10/18/96- TIBURON THROUGH 10/18/96- 97V-026. *JD
9730002
IDLE SPEED CONTROL ACTUATOR (SHOP MANUAL CORRECTION). *TW
9790002
ATM 3RD TO 4TH GEAR UPSHIFT DELAY DURING CRUISE CONTROL OPERATION. *TW
9790005
AUDIO SYSTEM CONNECTOR REPLACEMENT. *TW
9720002
THE CYLINDER HEAD TORQUE SEQUENCE FOR IN-LINE 4 CYLINDER ENGINES NOTED IN THE LISTED SHOP MANUALS IS INCORRECT. *JD
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.