Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
23-BD-002H
This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.
21-EM-004H
This bulletin provides the service procedure for engine connecting rod bearing clearance testing. Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required steps.
21-BR-002H
This bulletin provides best practice recommendations when performing brake service procedures.
21-EM-003H
This bulletin provides the inspection procedure and repair guidelines for certain vehicles listed below.
20-BR-002H
This bulletin describes the procedure to inspect and identify fluid which may appear around the brake caliper area.
20-SS-004H
This bulletin provides tire vibration service procedures, including how to optimize vehicle vibration performance. For all wheel/tire balance claims, the âTire Balance Data Sheetâ must be fully completed including imbalance and Road Force Variation (RFV) data. The Data Sheet can be found at the end of this bulletin.
20-BD-014H
This bulletin provides information regarding condensation related to moisture accumulation in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. The TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes, or during normal driving operation.
20-SS-002H(1)
This bulletin provides information on tire maintenance best practices and procedures for dealers and customers to maximize tire life and performance.
20-BD-007H-1
This bulletin describes the general guidelines to help disinfect and protect vehicle exterior/interior surfaces using recommended safe chemical products.
20-EE-003H
This bulletin provides information on identifying dealer stock vehicles with either: ⢠A Battery SOC alert - low Battery State of Charge (SOC) at or below 50%. ⢠A 30 Day alert - vehicle has not started and reported an SOC in 30 days.
20-AT-016H
The automatic transmission warranty repair policy authorizes in-dealership repairs of the following components for both OEM (new) and remanufactured automatic transmissions:
20-BD-007H
This bulletin describes the general guidelines to disinfect and protect vehicle interior surfaces using certain safe chemical products.
20-SS-001H
This bulletin describes the requirements for all wheel alignment and/or vehicle tracking claims and best practices when diagnosing and conducting alignment-related repairs for all models and model years.
20-BE-001H
This bulletin provides guidelines to inspect the USB, head unit, and multi-box for common connection conditions. 2. This bulletin presents guidelines to inspect for common Android Auto and Apple CarPlay connection conditions. 3. This bulletin provides physical differences between the USB 2.0 port and USB 3.0 port.
19-BE-011H-1
The Blind Spot Detection (BSD) or Blind-Spot Collision Warning (BCW) is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. The BSD/BCW detects vehicles within the blind spot zone and gives off an alarm (visual and audible). The two magnetic radar sensors provide these functions for BSD/BCW: ? Senses other vehicles in the BSD/BCW zone and turns on the BSD/BCW warning lamp for the driver. The warning lamp starts blinking, along with an audible sound, when the driver turns on the turn signal lamp to enter the lane where another vehicle is driving.
19-GI-006H
This bulletin provides instruction detailing the proper methodology for scanning and uploading captured GDS data files to the Techline Repository. Compliance with this bulletin ensures that the GDS data files are correctly transferred and matched with a Techline Case number.
0540018
AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODES LIST. *TT
151
AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODES LIST. *TT
0804
REPLACEMENT CIGARETTE LIGHTER. *NM
0340007
ATA SOLENOID DIAGNOSTIC TROUBLE CODES P0740, P0741, P0742, P0743, P0745, P0747, P0748, P0750, P0752, P0753, P0755, P0757, P0758, P0760, P0765. *TT *MJ
0340022
AUTOMATIC TRANSAXLE PULSE GENERATOR DIAGNOSTIC TROUBLE CODES P0717 & P0722. 2004 ACCENT INCLUDED. *TT
135
OXYGEN SENSORS. *SC
0236028
OBD-II READINESS TEST DRIVE CYCLE. *TT
0240016
SUBJECT REGARDING AUTOMATIC TRANSAXLE OIL LEAKING FROM OIL PAN GASKET. *JG
0290009
SUBJECT REGARDING DIAGNOSTIC GUIDE FOR CLIFFORD AND DEI SECURITY SYSTEM. *JG
0240010
SUBJECT ON AUTOMATIC TRANSAXLE HARSH OR DELAYED PARK REVERSE OR PARK DRIVE ENGAGEMENT. *YH
0240012
SUBJECT REGARDING AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODES LIST. *YH
0250002
SUBJECT REGARDING FRONT BRAKE CALIPER RATTLE NOISE REPAIR KIT. *TT
01400061
AUTOMATIC TRANSAXLE PULSE GENERATOR DIAGNOSTIC TROUBLE CODES P0717 AND P0722 - REVISED. *JG
0101006
SUBJECT REGARDING TIBURON SEAT BELT D-RING GUIDE STOPPER. *YD
010101
INFORMATION ON PERFORMING A TEST DRIVE FOR TRANSAXLE SHIFT QUALITY. *TT
0040005
SOME TRANSAXLES PRODUCED PRIOR TO 05/15/99 MAY EXPERIENCE AN OIL LEAK IN THE BELLHOUSING BEHIND THE TORQUE CONVERTER. *TT
0001004
SUBJECT REGARDING FUEL TANK PRESSURE CHECK CAMPAIGN 037 FOR VEHICLES EXHIBITING EXCESSIVE VACUUM FORMATION IN THE FUEL TANK. *ET
9936010
SUBJECT REGARDING CRANKSHAFT POSITION SENSOR REPLACEMENT PROCEDURE. *TT
9940005
SUBJECT REGARDING DOUBLE CONE SYNCHRONIZER. *TT
9940008
SOME VEHICLES MAY EXPERIENCE AN OIL LEAK BEHIND THE TORQUE CONVERTER. *TT
9940004
SUBJECT REGARDING AUTOMATIC TRANSAXLE DIAGNOSTIC TROUBLE CODE P1613/1614. *TT
9940002
VEHICLES MAY EXHIBIT A SLIGHT SHIFT FLARE DURING THE UPSHIFT FROM 2ND TO 3RD GEAR. *TT
9840013
SUBJECT PERTAINING TO IMPROVED 2-1 DOWNSHIFT AT LOW SPEEDS. *YC
9840007
TECHNICAL SERVICE BULLETIN ON CLUTCH COVER ASSEMBLY. *YC
9850002
SPECIFICATION ON REAR BRAKE DISC MINIMUM THICKNESS. *YC
9807-9880009
CORROSION MAY FORM AROUND THE EDGE OF THE SUNROOF LID PANEL LIP DUE TO INADEQUATE SEALING OF THE WEATHERSTRIP AGAINST THE SUNROOF LID PANEL ON SOME VEHICLES. *YC
9809006
INFORMATION ON THE OXYGEN SENSOR OFFSET VOLTAGE CHANGE. *YC
9820001
A PROCEDURE FOR THE INSTALLATION OF A BLOCK HEATER. *YC
97110160007
INFORMATION ON TORSION BARS, GAS STRUTS AND CHMSL. *YC
97110199004
VARIOUS INFORMATION ON PROPER CARE FOR VEHICLE EXTERIORS AND CORRECTIVE STEPS FOR ENVIRONMENTAL DAMAGE. *YC
97100190014
INFORMATION ON POWER WINDOW LOCK SWITCH OPERATION. *YC
970901400131
MODIFIED TRANSAXLE CONTROL MODULES. *YC
97080140026
INFORMATION ON A NEW DOUBLE CONE SYNCHRONIZER. *YC
97080190013
INFORMATION AND PROCEDURES ON PROJECTOR BEAM HEADLIGHT ADJUSTMENT. *YC
9740010
CONDITIONS WITH A SLIGHT SHIFT "FLARE" DURING THE 2ND TO 3RD GEAR UPSHIFT. *TT
97040012
MANUAL TRANSAXLE POPPET VALVE DESIGN CHANGE. *TW
9740013
MODIFIED TRANSAXLE CONTROL MODULES. *TW
9701998
RECALL 97V-026 - THE WINDSHIELD WIPER MOTOR THERMAL SWITCH CIRCUIT CONTACT POINTS MUST BE CLEANED ON CERTAIN HYUNDAI VEHICLES WHICH FALL INTO THE FOLLOWING PRODUTION RANGES TO CORRECT A POSSIBLE INTERMITTENT INTERRUPTION OF WIPER OPERATION- A WIPER MOTOR SERVICE KIT (PART #00305-CMP00-30) WILL BE SENT TO EACH DEALERSHIP CONTAINING THE SUPPLIES REQUIRED TO PERFORM THIS PROCEDURE- EACH KIT CAN SERVICE UP TO TEN (10) VEHICLES- ADDITIONAL KITS CAN BE ORDERED FROM YOUR FACING PDC- MODEL/PRODUCTION DATE RANGE: ACCENT 3/04/96 THROUGH 10/18/96- ELANTRA (SADAN & WAGON) 11/20/95 THROUGH 10/18/96- SONATA 12/18/95 THROUGH 10/18/96- TIBURON THROUGH 10/18/96- 97V-026. *JD
9709001
HDS ADAPTER CABLE HY02 INSTALLATION PROCEDURE. *TW
9760002
DOOR WEATHERSTRIP REMOVAL AND INSTALLATION PROCEDURE. *TW
9760003
TIBURON/ACCENT REAR SPOILER CENTER HIGH MOUNTED STOP LAMP. *TW
9790002
ATM 3RD TO 4TH GEAR UPSHIFT DELAY DURING CRUISE CONTROL OPERATION. *TW
9790005
AUDIO SYSTEM CONNECTOR REPLACEMENT. *TW
9790006
THE REAR WIPER MOTOR IN THE 1997 TIBURON MAY STALL IN HEAVY LOAD CONDITIONS. *TW
9797001
TIBURON A/C SWITCH STICKING. *TW
9720002
THE CYLINDER HEAD TORQUE SEQUENCE FOR IN-LINE 4 CYLINDER ENGINES NOTED IN THE LISTED SHOP MANUALS IS INCORRECT. *JD
9740002
SHIFT CONDITION CAUSED BY SHORT CIRCUIT IN INHIBITOR SWITCH. *TW
9760001
PROCEDURE FOR SUNROOF ASSEMBLY REMOVAL AND INSTALLATION. *JD
9650009
BRAKE BOOOSTER CHECK VALVE (SHOP MANUAL CORRECTION). *TW
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.