Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
IB13-R-001G
This bulletin outlines the procedures for using the Alpine Exchange Program (the "Exchange Program"). The Exchange Program must be used when any Alpine radio or other component covered by this bulletin is repaired under warranty and may also be used for radio and component repairs not covered under warranty. Contact Alpine directly for pricing and payment methods applicable to radio and component repairs not covered under warranty.
WB13-X-001B
Isuzu Commercial Truck of America, Inc. (ICTA) is providing the following procedural recommendations to improve dealer efficiency when submitting Parts Warranty claims. We strongly recommend dealers follow these procedures in order to avoid delays in Parts Warranty claim payments and/or claim chargeback. This bulletin was revised to add a Parts Warranty Form
WB13-X-001A
Isuzu Commercial Truck of America, Inc. (ICTA) is providing the following procedural recommendations to improve dealer efficiency when submitting Parts Warranty claims. We strongly recommend dealers follow these procedures in order to avoid delays in Parts Warranty claim payments and/or claim chargeback.
IB09-X-002B
The following is a list of the Isuzu-recommended Threebond product part numbers identified in the various Isuzu Workshop Manuals and bulletins. If a Threebond product is unavailable, we recommend that you utilize the chart below to find equivalent of similar products (when available) from Loctite and Permatex.
IB09-X-004C
The Isuzu Commercial Truck of America (ICTA) Service Technical Assistance Center (TAC) provides diagnostic support to Isuzu dealer technicians repairing Isuzu vehicles in and out of vehicle warranty. A TAC case number will be issued solely for information tracking purposes and future contact reference.
0709002
REAR BRAKE ROTORS. *KB
0211S001
DOOR CHECK ARM POPPING SOUND. *JG
SB0104S001
SOME ENGINES MAY OCASSIONALLY EXPERIENCE IDLE FLUCTUATION AND / OR THE MALFUNCTION INDICATOR LAMP WILL ILLUMINATE BECAUSE AN ACCELERATOR POSITION SENSOR (APS) DIAGNOSTIC TROUBLE CODE P1271, P1273, P1275, P1280, OR P1285 IS SET. *TT
SB0111S006
SOME VEHICLES BUILT PRIOR TO VIN BREAKPOINT 14327313 MAY EXPERIENCE MUD FLAP INTERFERENCE CAUSING A RUBBING SOUND WHEN MAKING A TURN. *TT
IB0101S002
SUBJECT REGARDING HEC ENGINE TIMING BELT SCRAPPING. *TT
IB0109S001
SUBJECT REGARDING DRUM BRAKE ADJUSTMENT PROCEDURE. *TT
IB0104S004
SERVICE INFORMATION STATING THAT IF IGNITION COIL #6 IS INCORRECTLY INSTALLED IN ANY OF THE #1 THROUGH #5 CYLINDERS, IT MAY CAUSE THE MALFUNCTION INDICATOR LAMP TO COME ON AND SET THE P0300 ENGINE MISFIRE CODE. *TT
IB0104S002
SUBJECT REGARDING P0337 CRANKSHAFT POSITION SENSOR CIRCUIT LOW INPUT CORRECTION. *TT
IB0110S001
INFORMATION REGARDING SECTOR SHAFT ALIGNMENT ON THE STEERING RACK ASSEMBLY. *TT
IB0104S001
SERVICE INFORMATION REGARDING DIAGNOSTIC TROUBLE CODE P1340 ION SENSING MODULE CYLINDER ID FAULT.
SB0111S003
SOME OWNERS MAY COMMENT ON LOUD DOOR CHECK ARM POPPING SOUND WHEN OPENING AND CLOSING THE DOOR. *TT
IB0004S005
THIS BULLETIN PROVIDES INFORMATION ON THE P1640 AND P1650 OUTPUT DRIVE CODES WHICH REFER TO OUTPUT DRIVER CIRCUIT CONDITIONS RELATED TO THE PCM. *TT
IB0004S008
SOME VEHICLES MAY RANDOMLY SET A PCM CODE P0502 IN A DECELERATION MODE USUALLY WITH 0% THROTTLE. THE MALFUNCTION INDICATOR LIGHT WILL ONLY SET AFTER THE FAULT HAS BEEN DETECTED FOR TWO CONSECUTIVE KEY CYCLES. *TT
IB0004S009
SOME VEHICLES THAT HAVE RECENTLY HAD THE ENGINE REPLACED WITH A LONG BLOCK WILL SET CODE P1336 FOR TOOTH ERROR CORRECTION. *TT
IB0012S003
INFORMATION BULLETIN REGARDING RODEO AND AMIGO / RODEO SPORT HVAC OPERATION UPDATE FOR VEHICLES WITH FACTORY INSTALLED AIR CONDITIONING ONLY. *TT
IB0004S003
SERVICE INFORMATION PERTAINING TO ACCELERATOR POSITION SENSOR ADJUSTMENT ON VEHICLES WITH ELECTRONIC THROTTLE EQUIPPED WITH V6 ENGINES. *TT
IB0011S003
SERVICE INFORMATION REGARDING HEADLIGHT AIMING PROCEDURE. *TT
SB0006S003
VEHICLES PRODUCED PRIOR TO VIN BREAKPOINT 5Y4331226 MAY EXHIBIT A CONDITION WHERE EXCESSIVE PAINT THICKNESS OR UNEVEN MOUNTING SURFACE ON CERTAIN REAR SUSPENSION COMPONENTS MAY CAUSE CERTAIN BOLTS AND NUTS TO LOOSEN. *TT
IB00S008
THIS BULLETIN MENTIONS THAT THE SAFETY CRASH CAGE BRACKET USED ON VEHICLES WILL NOT ALLOW THE INSTALLATION OF 1999 RUNNING BOARDS. THERE ARE NEWLY DESIGNED RUNNING BOARDS FOR MODELYEAR 2000 VEHICLES. *TT
IB00S001
INFORMATION BULLETIN INTRODUCING THE NEW ION SENSE IGNITION (ISI) FOR MODEL YEAR 2000 VEHICLES. *TT
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.