Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
IB13-R-001G
This bulletin outlines the procedures for using the Alpine Exchange Program (the "Exchange Program"). The Exchange Program must be used when any Alpine radio or other component covered by this bulletin is repaired under warranty and may also be used for radio and component repairs not covered under warranty. Contact Alpine directly for pricing and payment methods applicable to radio and component repairs not covered under warranty.
WB13-X-001B
Isuzu Commercial Truck of America, Inc. (ICTA) is providing the following procedural recommendations to improve dealer efficiency when submitting Parts Warranty claims. We strongly recommend dealers follow these procedures in order to avoid delays in Parts Warranty claim payments and/or claim chargeback. This bulletin was revised to add a Parts Warranty Form
WB13-X-001A
Isuzu Commercial Truck of America, Inc. (ICTA) is providing the following procedural recommendations to improve dealer efficiency when submitting Parts Warranty claims. We strongly recommend dealers follow these procedures in order to avoid delays in Parts Warranty claim payments and/or claim chargeback.
IB09-X-002B
The following is a list of the Isuzu-recommended Threebond product part numbers identified in the various Isuzu Workshop Manuals and bulletins. If a Threebond product is unavailable, we recommend that you utilize the chart below to find equivalent of similar products (when available) from Loctite and Permatex.
IB09-X-004C
The Isuzu Commercial Truck of America (ICTA) Service Technical Assistance Center (TAC) provides diagnostic support to Isuzu dealer technicians repairing Isuzu vehicles in and out of vehicle warranty. A TAC case number will be issued solely for information tracking purposes and future contact reference.
SB-12-J-005
ISUZU (CHEVROLET/GMC): TRUCKS WITH DIESEL ENGINE WOULD HAVE IDLE VIBRATION, TROUBLE STARTING, ENGINE NOT REVVING UP, AND A LACK OF POWER DUE TO POSSIBLE OPERATION CONDITION OF SUCTION CONTROL VALVE (SCV)/FUEL RAIL PRESSURE (FRP) REGULATOR BEING INTERMITTENT. MODELS 2004-2010 CHEVROLET/GMC C, T, W SERIES AND ISUZU F, H, N SERIES. *PE
SB-08-J-003-A
IZUZU: THIS TSB IS FOR VEHICLES EQUIPPED WITH 7800 IZUZU DIESEL ENGINES. THERE IS A PROCESS FOR GETTING HORSEPOWER/TORQUE UPGRADES. *RM UPDATED 3/9/12. *PE UPDATED 7/27/12. *PE
SB-08-J-003
CHEVROLET, GMC AND ISUZU TRUCKS: LACK OF POWER, ENGINE WILL NOT REV UP, IDLE VIBRATION, ENGINE STARTING CONCERNS, DTCS P1093, P0087, P1087, P0088 AND/OR P1088 SET (DIAGNOSE AND REPLACE SUCTION CONTROL VALVE (SCV) (FUEL PRESSURE REGULATOR (FPR), IF NECESSARY). *PE UPDATED 2/13/09. *PE UPDATED 4/5/10. *PE UPDATED 11/2/11. *PE
CB-10-X-001
ISUZU SERVICE CAMPAIGN: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. THE EMISSIONS LABEL WAS INSTALLED INCORRECTLY SO IT CANNOT BE SEEN. 2005-2007 H SERIES. *RM
070604021
LACK OF POWER, ENGINE WILL NOT REV-UP, IDLE VIBRATION, ENGINE STARTING CONCERNS, DTC;S P1093, P0087, P1087, P0088 AND/OR P1088 SET (DIAGNOSE AND REPLACE SUCTION CONTROL VALVE (SCV) (FUEL PRESSURE REGULATOR (FPR)), IF NECESSARY) *NJ
070522001
BRAKE LIGHT SWITCH INOPERATIVE, BRAKE WARNING BUZZER SOUNDING AND BRAKE WARNING LIGHT ON, DTC'S C0164, C0272 SET. (REMOVE AND SPLICE WIRE/REMOVE CHMSL FUSE/REPLACE STOP LAMP SWITCH). *KB
050857004
WATER INTRUSION INTO CAB (INSPECT/REPLACE ROOF MARKER LAMP LENS/BOLTS). *AK
050861008
REVISED BODY MOUNT REPLACEMENT - FRONT AND BODY MOUNT REPLACEMENT - REAR. *TT
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.