Vehicle report

2025 JEEP CHEROKEE

Service bulletins

12 bulletins

Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.

114080

Service Bulletin/Repair Instructions

HANDLE BRACKET - EXTERIOR DOOR & BRACKET - DOOR HANDLE

9100880

Service Bulletin/Repair Instructions

Cluster Assembly When the technician connects to the vehicle via Witech, they observe Stored and/or Pending DTC in the IPC for KM49, LB, KM74 Programs. The instrument cluster should not be replaced based solely on the presence of stored or pending DTCs in the IPC. Replacement should only be considered if the stored or pending DTC becomes active during the troubleshooting and diagnostic process.

113824

Service Bulletin/Repair Instructions

GEAR - RACK AND PINION

108458

Service Bulletin/Repair Instructions

DETECTOR - EVAPORATIVE SYSTEM INTEGRITY MODULE

108461

Service Bulletin/Repair Instructions

DETECTOR - EVAPORATIVE SYSTEM INTEGRITY MODULE

S2408000031 REV.A

Service Bulletin/Repair Instructions

Vehicle is Not Charging When Connected to a Level One or Two Charger or a Public Charging Station

9100599

Service Bulletin/Repair Instructions

Underhood start/stop safety The customer may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following Diagnostic Trouble Code (DTC): - P152E Engine -Hood Switch 2 Circuit High. - DTC P152F Customers may also experience: - Start/Stop system warning light. - Start/Stop inoperable. - Remote start inoperable. Diagnosis: - Using a Scan Tool (wiTECH) with the appropriate Diagnostic Procedures available in DealerCONNECT/Service Library, verify all related systems are functioning as designed. If DTCs or symptom conditions, other than the one listed are present, record the issues on the repair order and repair as necessary before proceeding further with this bulletin. - If any vehicle exhibits any of the symptoms listed above in the customer symptom section, perform the Repair Procedure. - Special Tools/Equipment: wiTECH or equivalent. Repair Procedure: 1. Open the hood and locate the hood switch 2. Push in on the two locking tabs and pull them out. 3. Disconnect the wire connector from the switch. 4. Connect the wires to the same hood switch. 5. Push the switch back into the hold until both lock tab are engaged. 6. Clear all DTCs that may have been set in any module during this repair procedure. 7. In case the P152F/P152E DTCs persist, repeat the procedure with a new/spare/known good switch and repeat steps 5 and 6. 8. Replace switch installed during previous step for the original switch of the vehicle. If DTCs P152F/P152E are not present, leave the original switch installed and do not document the change of the switch in the repair process/narrative.

102934

Service Bulletin/Repair Instructions

THROTTLE BODY

101095

Service Bulletin/Repair Instructions

Bracket - Fender Mounting

S2424000006

Service Bulletin/Repair Instructions

Drivers Side Left Rear Floor Ducts No Air Flow

S2408000088

Service Bulletin/Repair Instructions

Radio (ETM) Is Setting Active DTC B15A1-00 Media Port Connection

S2308000120 REV.B

Service Bulletin/Repair Instructions

Rain Sensing Auto Wipers and Auto on Head Lamps Inoperative

Reading this report

Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.