TB-26-70-01
Service Bulletin/Repair Instructions
Recovery cap retention, a method to bolster tension for the tow hook cover
Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
TB-26-70-01
Recovery cap retention, a method to bolster tension for the tow hook cover
SC-26-01-01
Alert to service centers that 12 volt is no longer stocked in the karma distribution center
TB-26-90-01
Alignment of headlamps service procedure
TB-24-12-01-.02
new component is available, instructions how to install are provided. this is an update to a bulletin from 2024 (TB-24-12-01)
SC-26-12-01
Update to procedure for oil sump removal & replacement
TB-26-78-02
New B-Pillar retention clips are available, which will be replaced on complaint
SC-26-78-01
A supplemental instruction to remove and reinstall the external rear view mirror caps
SC-90-26-01
New fasteners are available for better headlamps
SC-25-90-02
Install of recommended 12Volt battery maintainer
TB-25-94-01
over the air Software update to redirect the vehicle to the new server.
SC-25-05-01
Revised tool list for service providers
TB-25-76-01
Update Remedy for possible wind noise complaint and door effort on opening
RC-24-90-01
Headlamp Control Unit Replacement Safety Recall. software in the control module required an update from the component supplier. replacing the module with the required software corrects compliance for FMVSS 108 concern
TB-24-12-01
A new bracket is provided to reposition the Diagnostic Module TL for best performance in the vehicle.
SC-24-12-01
On complaint of relative Fuel tank isolation valve (“FTIV”) diagnostic trouble codes presented, this guide should aid the technician to better identify which component is to be replaced.
TB-24-16-01
On complaint this is offered to provide a software update (BL1070) over the air to remedy the complaint of a DTC and drive behavior.
SC-24-94-01
Describing the process to use the diagnostic tool and USB for manual baseline updates of vehicle software when needed.
TB-24-94-01
Remedy for infotainment module fan noise.
SC-24-90-01
Update to Workshop manual procedure and information for sound module location
CC-23-00-02
This bulletin will outline the process of what to expect and what to perform for a software update.
CC-23-00-01
Baseline Software update for specified models
CC-22-60-02
Knocking noise remedy, by verifying torque spec on some front end bolts
SC-20-90-04.01
Update to previous communication regarding vertical location of radar calibration mirror. Supplement to the Karma Sync Procedure for Radar Module Calibration
CC-21-00-01
Baseline 1050 software update
CC-21-70-01
a trim piece in the front fascia falls out of place easily (the recovery eye). this is a remedy to secure it better
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.