Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
KSB-220630
This process describes the repair of In-Wall slide systems that have become inoperable on one or both sides. It has been determined the vehicles in this KSB population may have been manufactured with an In-Wall Slide-Out System that may have a damaged guide shoe in the slide mechanism.
KSB-210122
Revision of KSB-210122. It has been determined the units in this KSB population may develop sidewall cracks at both front slideouts. Only units that develop a crack will require this repair, if the sidewall is not cracked, no repair is needed.
KSB-210122 V2
It has been determined the units in this KSB population may develop sidewall cracks at both front slideouts. Only units that develop a crack will require this repair, if the sidewall is not cracked, no repair is needed.
KSB-221025 V3
Revised repair instructions for KSB-221025 - This process describes how to inspect and add an End of Line Resistor (EOL) to the In-Command system that may be exhibiting erratic readings on HVAC and/or lose communication with components. It has been determined the vehicles in this KSB population may have been manufactured without the EOL resistor in the âÂÂGatewayâ located in the Roof A/C.
KSB-221025
The information and instructions in a Keystone Service Bulletin (KSB) are intended to inform RV dealership Service Managers/Technicians of situations that may occur with some Recreational vehicles so dealership personnel can perform proper and efficient service. KSBâs are intended to be used by trained RV technicians with the knowledge, tools and equipment to do the job properly and safely, not âdo-it-yourselfersâ. Information is not presented as a repair guaranteed to be covered by warranty. Keystoneâs P & P (Policy & Procedures) must be followed for any requested warranty work. Do not assume this repair is covered by warranty. Not every unit listed requires a repair. This process describes how to inspect and add an End of Line Resistor (EOL) to the In-Command system that may be exhibiting erratic readings on HVAC and/or lose communication with components. It has been determined the vehicles in this KSB population may have been manufactured without the EOL resistor in the âGatewayâ located in the Roof A/C.
22-422
It has been determined that certain Alpine or Avalanche units with a factory installed inverter may have insufficient sized wiring causing the inverter to shut down and show a low voltage code.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.