Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
ATI&09102021906
Service Bulletin/Repair Instructions
Dealer Message - American Honda Motor Co., Inc. (AHM) is searching for certain 2019-2021 Passports with a customer complaint of the rear view camera inop. To better understand the cause of this condition, AHM would like to inspect the vehicle prior to you attempting a repair of any kind.
KSB-200305
Service Bulletin/Repair Instructions
Attached are the updated repair instructions for KSB-200305. The information and instructions in a Keystone Service Bulletin (KSB) are intended to inform RV dealership Service Managers/Technicians of situations that may occur with some Recreational vehicles so dealership personnel can perform proper and efficient service. KSBâs are intended to be used by trained RV technicians with the knowledge, tools and equipment to do the job properly and safely, not âdo-it-yourselfersâ. Information is not presented as a repair guaranteed to be covered by warranty. Keystoneâs P & P (Policy & Procedures) must be followed for any requested warranty work. Do not assume this repair is covered by warranty. This process describes how to replace a Furrion Antenna head with a Winegard 360 for Over The Air (OTA) channels.
KSB-191007
Service Bulletin/Repair Instructions
Letter to dealers for KSB-191007. This process describes the repair where under certain temperature conditions the Norco slide cable system gearbox may leak oil/grease on the slide roof membrane. The KSB describes how to install a drip pan to prevent damage to the roof membrane, and make repairs if necessary.
18-318
Service Bulletin/Repair Instructions
This is the REVISED repair instructions for advisory 18-318. It has been determined that certain Atwood furnace models may have wiring that can come in contact with the exhaust vent tube causing the furnace to shut down in a safe manner.