Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
09-025-21-3824
This service bulletin provides information regarding the proper use of the driverâÂÂs floor mat to avoid any potential interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided with proper usage.
01-005-21-3778
The Mazda DCA-8000PM is required for all warranty battery testing. If the Mazda DCA-8000PM is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this Service Bulletin to test Mazda vehicle batteries and to generate a Warranty Code.
01-006-21-3779
This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure.
09-002-21-3770
In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer
09-003-20-3671
In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealerâÂÂs responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. ï· Mazda vehicles are manufactured with tamper-proof speedometers. ï· When a speedometer is replaced, the new speedometer will read zero (0) miles. ï· This procedure is extremely important to accurately represent actual vehicle mileage. ï· Prior to speedometer removal, complete the information required on the âÂÂSpeedometer Replacement LabelâÂÂ. Labels can only be ordered through Mazda eStore. ï· In an effort to achieve a higher level of Customer Experience and retain the value of MazdaâÂÂs vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMOâÂÂs services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.
0901216
Paint damage Mazda pocket paint guide
0900716
Speedometer replacement procedure
0400502
INADVERTENT DISABLING OF BRAKE SHIFT INTERLOCK. *TT
01299
SUBJECT REGARDING PAINT DAMAGE - IRON PARTICLES / INDUSTRIAL FALLOUT / ACID RAIN. *TT
01599
INFORMATION REGARDING PISTON STANDARDIZATION FOR VEHICLES WITHIN CERTAIN VIN RANGES. *TT
00598
SUBJECT REGARDING MALFUNCTION INDICATOR LIGHT (MIL) ILLUMINATION W/DTC P0421. *YC
01598
SUBJECT REGARDING MALFUNCTION INDICATOR LIGHT (MIL) ILLUMINATION W/DTC P1407. *YC
00198
CONDITIONS WITH STEERING WHEEL SLIGHTLY OFF CENTER. *YC
00298
SUBJECT REGARDING MALFUNCTION INDICATOR LIGHT (MIL) ILLUMINATION WITH DTC ( S ) P0300 THROUGH P0306. *YC
97102300397
SUBJECT PERTAINING TO MTX OVERHAUL INFORMATION. *YC
97102300797
VEHICLE EXPERIENCING A OIL LEAK AT VALVE COVER. *YC
97102302097
PRE-PAINTING PREPARATIONS FOR FRONT AND REAR BUMPERS. *YC
008/97
USE OF A/C TRACER DYE. *TW
004/97T
ELECTRICAL CONNECTOR AND TERMINAL REPLACEMENT PART AVAILABILITY. *TW
007/97T
PARTS REPLACEMENT AFTER AIRBAG DEPLOYMENT. *TW
001/97G
MAINTENANCE FREE BATTERY - DIAGNOSTIC AND CHARGING PROCEDURE. *TW
001/97
TAPPING NOISE WHEN ENGINE IS COLD. *TW
001/97R
STABILIZER BAR BUSHING REPLACEMENT PROCEDURE. *TW
002/97K
DIAGNOSTIC TROUBLE CODE P0741 TORQUE CONVERTER - CLUTCH SYSTEM PERFORMANCE. *TW
002/97M
CLUNK NOISE/VIBRATION DURING ACCELERATION ON LEFT TURNS. *TW
003/97G
WIPER MOTOR INOPERATIVE - CIRCUIT BREAKER ACTIVATION. *TW
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.