Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
SA-028-25
Some vehicles may have recall notifications remain on the center display even after a recall is performed. NOTE: When the warranty claim for the recall campaign is accepted at Mazda Japan, the recall notification will be automatically deleted via the Connected Service on the next day or later. This situation occurs if the Connected Service subscription has been cancelled while the recall notifications remain.
SA-027-25
The CX-70 and CX-90 have new and revised features that are different from previous models and may be difficult to understand. This Service Alert provides valuable information to support potential dealer and customer concerns.
SA-012-25a
Customers having MAZDA CONNECT concerns should have their vehicle repaired using the following repair procedure.
SA-017-25a
Frequently Asked Questions (FAQ) for Mazda Connected Services.
SA-023-25
Some customers may complain about any of the following: 1. Infotainment Center Display does not provide the Authorization Code (OTP) during the MyMazda App Connected Vehicle enrollment. 2. Remote function(s) inoperative. Engine Start / Stop Door Lock / Unlock Lights ON / OFF Climate Control 3. MAZDA CONNECT connected vehicle reception strength icon shows "X" or " ".
SA-024-25
Mazda Navigation Live Traffic information is available on the following 2 systems. SiriusXM® 3 Yr Traffic and Travel Link* Mazda Online Navigation* The table below provides Setting information for both systems. See APPLICABLE MODEL(S)/VINS above to determine how vehicles are equipped. NOTE: When selecting Navigation, data upload may take a few seconds. This is a normal function.
SA-025-25
Some vehicles may exhibit wiper blade contact with the A-pillar trim, with or without a chattering noise. This condition may be caused by worn or contaminated wiper blades. It can also be caused by bent wiper arms, or loose wiper arm retaining nuts due to improper handling. Improper handling occurs when pulling on or forcing the wiper arms. Technicians should be aware that while replacement of the wiper blade may resolve some cases, correction of bent components or repositioning of the wiper arms, particularly when the retaining nut is loose, requires additional steps to ensure proper alignment and function.
SA-022-25
Due to a manufacturing change, the CX-70/CX-90 transmission has undergone a transmission part design change when replacing the transmission assembly. Old design originally required a coolant line running to the top of the bell housing, the new design has omitted the hole and need for the coolant line. The new/superseded design can be used in place of the old/original design, and the coolant hose with fitting is no longer needed.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.