Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
TSIB 21-01
This Technical Service Information Bulletin (TSIB) describes an update from Meritor for the bolt torque application requirements on hub-to-rotor bolts for the front, drive and tag axles, on specific coaches equipped with Meritor EX225 disc brakes, on either Conventional, PreSet or Unitized Wheel-End hubs.
SB 3118
This Service Bulletin informs affected owners of 1997-2013 E4500 and 2001-2015 J4500 model coaches equipped with Rear Axle Steering (RAS) system of the importance of maintaining tag axle caster, and provides the procedure to adjust the caster, if necessary.
SB 396
This Service Bulletin informs customers that MCI was notified by Cummins Inc. that it has released Campaign C1344 that addresses a calibration change, which Cummins advises will improve the engine and aftertreatment reliability on Cummins ISX engines in model year 2011-2013 MCI D model coaches, model year 2011-2013 MCI E4500 model coaches and model year 2011-2013 MCI J4500 model coaches. This program is being performed only by Cummins Service Network and its authorized dealers, therefore, all parts and labor required for this program will be provided by Cummins.
SB 3077
This Service Bulletin informs affected customers that MCI was notified by Shaw Development that the diesel exhaust fluid (DEF) tank cap requires routine cleaning to prevent the potential for crystallization build up at the vent, which may result in potential vacuum issues which could result in collapsing of the tank walls on MCI D model coaches, MCI E4500 model coaches and MCI J4500 model coaches.
SB 393
This Service Bulletin informs affected customers that MCI was notified by Cummins Inc. that it has issued campaign C1241 that addresses a calibration issue, which results in the engine brakes being energized with 24 volts rather than the required 12 volts on Cummins ISX engines in model year 2011-2012 MCI D model coaches, model year 2011-2012 MCI E4500 model coaches, and model year 2011-2012 MCI J4500 model coaches. This program is being performed only by Cummins Service Network and its authorized dealers, therefore, all parts and labor required for this program will be provided by Cummins.
SB 3074
This Service Bulletin informs affected customers of the procedures to replace the existing 2007 EPA Cummins engine harness p-clip, in the event that loom damage or chafing has occurred on model year 2008-2011 MCI E4500 model coaches and model year 2007-2011 MCI J4500 model coaches, and that MCI has a parts kit available for purchase.
SB 389
This Service Bulletin informs affected customers that the retention nut utilized on the Leece Neville alternator pulley installation is not maintaining the proper torque which may result in alternator bearing failure on model year 2011-2012 MCI D model coaches, 2011-2012 MCI E4500 model coaches, and 2011-2012 MCI J4500 model coaches, and that MCI will remedy the affected coaches at no cost to the customers.
SB-390
MOTOR COACH INC: DRIVE AXLE SUSPENSION SUPPORT STRUCTURE MAY ACCUMULATE WATER CAUSING SUPPORT STRUCTURE DAMAGE DUE TO EXPANSION, IN FREEZING TEMPERATURES, WHILE COACH IS BEING OPERATED. MODELS E4500, J4500. NO MODEL YEARS LISTED. *PE UPDATED 12/10/12. *PE
SB-383-B
MCI: ADDITIONAL LOAD PLACED ON ENGINE'S INTERNAL GEARS, RESULTING IN VIBRATION TRANSMITTED TO STEERING WHEEL CAUSED BY AIR COMPRESSOR CUTTING IN, AT LOW SPEED, AND A DEMAND FOR POWER STEERING. *PE
SB-386
MCI: ON SOME COACHES, DUE TO AN ABSENCE OF WASHER, THE FAN CLUTCH BRACKET BUSHING MAY WALK OUT OF BRACKET AND ALLOW CLUTCH MISALIGNMENT AND BELT FAILURE. *PE
SB-374
MCI: THE MANUFACTURING PROCESS OF FAN CLUTCH COOLING RING FINS MAY CAUSE COACHES TO EXPERIENCE MISSING PORTIONS AND/OR STRESS CRACKS. NO MODEL YEARS LISTED. *PE
SB-376
MCI: DUE TO FAILURE OF DIODE, WHICH CAUSED DESIGNATED FUSE TO BLOW, THE BOOST PUMP (CODE A22) FAIL TO OPERATE PROPERLY. NO MODEL YEARS LISTED. *PE
SB-367
MOTOR COACH INDUSTRIES: ON SOME COACHES, WATER MAY MIGRATE ONTO/INTO THE TRANSMISSION AND/OR THE FILL TUBE, THROUGH THE BREATHER VENT THAT IS LOCATED ON TOP OF TRANSMISSION. NO MODEL YEARS LISTED. *PE
SB-368
MOTOR COACH INDUSTRIES: BULLETIN INFORMATION ON SOME MOTOR COACHES, AT A HIGH TEMPERATURE THRESHOLD THAT THE DRIVE AXLE WHEEL HUB COVER WOULD BECOME DETACHED DURING THE OPERATION OF THE MOTOR COACH. NO MODEL YEARS LISTED. *PE
SB-357
MOTOR COACH INDUDSTRIES: INFORMATION ON REPLACING THE COOLANT PUMP THAT MAY HAVE A PROBLEM. *RM
354
MOTOR COACH INDUSTRIES SERVICE CAMPAIGN: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. THERE MAY BE A HARSH DOWNSHIFT, RPM FLARE, OR THE TRANSMISSION MAY LOCK. *RM
SB-3043
MCI: TAG UNLOAD VALVE ASSEMBLY. EFFECTIVE WITH UNIT NUMBER 65614, MCI HAS MADE DESIGN CHANGES TO THE TAG UNLOAD VALVE ASSEMBLY INSTALLATION ON SOME MODEL COACHES. THE LONGER LIFE VALVES WILL IMPROVE THE DURABILITY OF THE TAG UNLOAD VALVE ASSEMBLY. MODELS E4500/J4500 SERIES. NO MODEL YEARS LISTED. *PE
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.