Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
MISC-IB-084-A
McNeilus Truck and Manufacturing requires an inspection and replacement, if needed, to ensure the Bob Tail® Huck® bolts are fully swaged with correct thread exposure on the rear pivot cross member body mounts. Revision A updates the replacement bolt length to 90mm
MISC-IB-084
McNeilus Truck and Manufacturing requires an inspection and replacement, if needed, to ensure the Bob Tail® Huck® bolts are fully swaged with correct thread exposure on the rear pivot cross member body mounts.
MISC-TSIB-081
According to an amended ruling in the visual inspection labeling requirement in Federal Motor Vehicle Safety Standard (FMVSS) No. 304, the periodic inspection interval for compressed natural gas (CNG) fuel containers has been modified to âat least every 12 months.â McNeilus Truck and Manufacturing will support this change by updating safety decals and installing these new decals when a vehicle is inspected by McNeilus CNG technicians, and by answering questions regarding this periodic inspection interval update and how McNeilus will support it.
MISC-TSIB-079
McNeilus Truck and Manufacturing provides these instructions for installing a hydraulic reservoir cork gasket. The installation of this gasket will repair leaks coming from the gasket between the in-tank filter and the reservoir.
MISC-TSIB-075-A
The following information describes how to purge air and release stored hydraulic energy from a hydraulic system. All manual override features are intended for emergency use, not for continuous-duty operation.
FEL-WI-017-A
McNeilus Truck and Manufacturing offers these instructions for repairing the lugs on the Front Loader Meridian tailgate.
FEL-WI-018-A
McNeilus Truck and Manufacturing offers these instructions for repairing the lugs on the Front Loader Meridian and Front Loader Atlantic CNG tailgates.
MISC-TSIB-078
McNeilus Truck and Manufacturing offers these instructions for ejector cylinder bypass testing.
MISC-TSIB-077
McNeilus Truck and Manufacturing offers these instructions for the installation of a new streetside cover panel with thumb latch on the doors and a new curbside cover panel with doors (having doors on panel is a new feature for the curbside cover panel) on compressed national gas (CNG) tailgate units. By installing these new cover panels, technicians will easily be able to gain access to inspect the CNG tanks by using thumb latches on the streetside and the new doors on the curbside of the unit.
FEL-TSIB-057
On the Meridian Front Loader, during performance issues such as slow functions, packing light loads, inability to lift heavy cans, it is recommended to inspect the O-rings on the sequencing valves. The sequencing valve O-rings may be experiencing premature failure and may begin to be unable to maintain its seal. These instructions discuss when and how to inspect the O-ring to determine if the O-ring is failing.
TSIB-056
These instructions are for installing tailgate lock cylinders on the Meridian (78) and Atlantic Series® (29) front end loaders. Replacing the tailgate lock cylinders may help reduce issues of the tailgate not locking and not unlocking. The existing cylinder has a 2.625? OD, while the new cylinder has a 2.875? OD.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.