Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
ZSL-IB-007
McNeilus Truck and Manufacturing, Inc. has been notified by customers of an issue regarding the power steering system on the Volterra™ ZSL™side loader refuse collection vehicles. McNeilus Truck and Manufacturing, Inc. is working with the steering pump supplier to identify the root cause(s) and a corrective action. A future bulletin will be provided when a corrective action has been identified.
MISC_IB_085-A
McNeilus Truck and Manufacturing provides these instructions for the installation of new bushings for the service cleanout door for all Side Loader refuse vehicles. The new bushings can help provide a tighter seal on the door.
ZSL-IB-005
McNeilus Truck and Manufacturing provides updated Preventive Maintenance schedule and instructions for an initial (within 500 miles or 6 months of service) retorque of the front axle U-bolts to 500 ft.-lbs. and semi-annually or every 12,000 miles (whichever comes first) retorque of the U-bolts to 500 ft.-lbs. The vehicle’s service maintenance manual reflects the same update.
MISC-IB-085
McNeilus Truck and Manufacturing provides these instructions for the installation of new bushings for the service cleanout door for all Side Loader refuse vehicles. The new bushings can help provide a tighter seal on the door.
ZSL-IB-004
McNeilus Truck and Manufacturing provides instructions for installing an updated park brake valve pressure switch. The updated pressure switch has a higher pressure activation and reset values which reduces the delay experienced with the previous pressure switch and addresses an unintended door alarm.
ZSL-IB-003
McNeilus Truck and Manufacturing, Inc. provides the instructions for the inspection and retightening of the brake clutch end cap cover hardware on the Volterra™ ZSL™ grabber carriage.
MXR-TSB-032
McNeilus Truck and Manufacturing identified an issue with over-torqued bolts on the lower ladder platform. The bolts used to secure the lower ladders to the lower ladder platform were over-torqued causing the bolts to fail. New hardware needs to be installed in placed of the over-torqued bolts.
MXR-TSIB-036
McNeilus Truck and Manufacturing offers these instructions for changing the Record DVR settings on STONKAM® DVR system installed on some McNeilus Rear Discharge Mixers.
MXR-TSIB-035
Inspection and possible rework required on drum flange bolt torqueing specifications on certain Rear Discharge Mixer vehicles.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.