Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
M610607
Service Bulletin/Repair Instructions
MINI electrical systems have continued to develop over the past few years. As a result, the demand on the batteries has increased. Breakdowns due to an empty battery or problems in the vehicles electrical system can have various causes, most of which are not due to the battery itself. For this reason, a battery replacement will permanently eliminate the problem only in the rarest of cases. The energy diagnosis test module helps to localize these causes. This document covers important information for the dealer on how to handle âÂÂdischarged batteryâ complaints. Without performing the energy diagnosis test plan, the root cause of a discharged battery cannot be identified. In order to properly repair the vehicle the first time, it is very important that the diagnostic test plan is performed to completion; with all results taken into consideration.
M240112
Service Bulletin/Repair Instructions
Programming a Replacement EGS Module with ISTA/P. Programming a replacement electronic transmission control module (EGS) with ISTA/P requires the manual entry of the correct target basic and programmed part numbers. Programming concept.
BMWJUL1316
Service Bulletin/Repair Instructions
MINI Water Pump Class Action Settlement
M320214
Service Bulletin/Repair Instructions
This Service Information bulletin supersedes SI 32 02 14 dated August 2014. SUBJECT Installation of Right-Hand Drive Steering Spindle in Left-Hand Drive Vehicle is No Longer Required. Left-hand drive steering spindles are currently available.
SIM-11-10-14
Service Bulletin/Repair Instructions
MINI: SOME VEHICLES HAVE TURBOCHARGER NOISE AND A LACK OR LOSS OF PERFORMANCE, DUE TO RESTRICTION OF TURBOCHARGER OIL SUPPLY, RESULTING IN OIL STARVATION AND SEIZING OF TURBOCHARGER ASSEMBLY. MODEL ALL. *PE
M010514
Service Bulletin/Repair Instructions
MINI CVT Replacement Parts Warranty Extension: Additional 12 Months with Up to 50,000 Accumulated Miles. A MINI vehicle's CVT assembly or component that was previously repaired and/or replaced by an authorized MINI dealer or BMW center may experience a subsequent failure.
SIM-11-01-12
Service Bulletin/Repair Instructions
MINI: ON CERTAIN MODEL VEHICLES, AN ENGINE OIL LEAK MAY OCCUR, DUE TO THE COMPROMISED OIL PUMP VOLUME CONTROL SOLENOID VALVE, FROM THE UNDERSIDE OF ENGINE. NO MODEL YEARS LISTED. *PE UPDATED 4/19/2013. *KB UPDATED 3/11/14. *PE
M120213
Service Bulletin/Repair Instructions
State Inspection and Emission (I/M) Test Fails Due to an Invalid VIN Number. The affected vehicle may fail to pass a State Inspection and Emission (I/M) test due to a noncompliant 17-digit vehicle identification number (VIN) stored in the DME (Digital Motor Electronic). The VIN read-out displayed on the state test printout does not match the actual VIN of the vehicle. If the DME was reprogrammed using the previously available BMW service equipment (e.g., Progman, GT1), it was possible that only the last 7 of the VIN were entered into the DME, and positions 4 through 10 may only contain default characters. For example: The state I/M tester or OBD scan tool may read out WBAAA00000A123456 instead of the correct full 17-digit VIN, WBAZZ03492A123456.
SI-M-12-02-10
Service Bulletin/Repair Instructions
MINI (BMW): SERVICE ENGINE SOON (MIL) LAMP IS ILLUMINATED; THE ENGINE RUNS ROUGH WITH ANY MISFIRE FAULTS STORED IN THE DME-2771, 2772, 2773, 2775, 2776, 2777, 2779, 277A, 277B, 277D, 277E, 277F-COMBUSTION MISFIRE, CYLINDER 1..4. *PE UPDATED 3/4/11. *PE UPDATED 4/20/11. *PE UPDATED 8/10/11. *PE UPDATED 9/13/11. *PE UPDATED 10/23/12. *PE
SIM-11-03-12
Service Bulletin/Repair Instructions
MINI: WHEN RESEALING ENGINE OIL PAN, ENGINE OIL PAN GASKET REPLACEMENT SHOULD NO LONGER BE USED DUE TO CAUSING SEALING FLANGE BECOMING DEFORMED. MODELS R55, R56, R59, R60, R57, AND R58. NO MODEL YEARS LISTED. *PE
SIM-12-07-12
Service Bulletin/Repair Instructions
MINI: THERE IS A SOFTWARE ERROR CAUSING THE SERVICE ENGINE SOON LIGHT TO BE ILLUMINATED THAT IS RELATED TO VALVETRONIC DIAGNOSTICS. MODELS R55, R56, R58, R57, R60, R59. NO MODEL YEARS LISTED. *PE
SI-M51-02-12
Service Bulletin/Repair Instructions
MINI: INSTALLATION OF A HEAT SHIELD FOR THE BONNET INTAKE AIR GRILL. *KB
SI-M61-01-12
Service Bulletin/Repair Instructions
MINI: AFTER DRIVE-AWAY LOCKING ACTIVATES, IT IS NOT POSSIBLE TO UNLOCK THE BOOT. *KB
SIM-65-06-11
Service Bulletin/Repair Instructions
BMW: THE AIRBAG WARNING LIGHT IS ON WITH A FAULT STORED. THE WIRING UNDER THE SEAT MAY BE PINCHED OR DAMAGED. *RM
SIM-17-01-10
Service Bulletin/Repair Instructions
BMW: ENGINE TOO HOT MESSAGE IS DISPLAYED WITH STORED TROUBLE CODES. THE WATER PUMP DOESNT POWER UP. *RM
SIM-11-07-08
Service Bulletin/Repair Instructions
BMW: DESCRIPTION AND SPECIFICATIONS OF CRANKCASE VENTILATION SYSTEM. *RM
SIM-13-06-10
Service Bulletin/Repair Instructions
MINI: TEILECLEARING FOR N14/N18 ENGINE DRIVABILITY AND FUEL SYSTEM. ENHANCED TECHNICAL SUPPORT (TEILECLEARING) PROCESS HAS BEEN DEVELOPED TO HELP IDENTIFY THE ROOT CAUSES OFCUSTOMER COMPLAINTS RELATING TO THE N14/N18 DRIVABILITY AND FUEL SYSTEM *E.G., LONG CRANK, LOSS OF POWER, SES LAMP ON, ETC.). THIS PROCESS CAN ALSO HELP EXPEDITE THE DEFECT ERADICATION PROCESS, ONCE THE ROOT CAUSE HAS BEEN DETERMINED. NO MODEL YEARS LISTED. *PE
SIM -01-04-10
Service Bulletin/Repair Instructions
BMW: SERVICE ENGINE SOON LIGHT MAY BE ON WITH STORED TROUBLE CODES AND REDUCED ENGINE POWER. THE HIGH PRESSURE FUEL PUMP MALFUNCTIONS. *RM
SI-M-11-01-09
Service Bulletin/Repair Instructions
MINI: WHEN REPLACING THE CYLINDER HEAD COVER ON A VEHICLE EQUIPPED WITH THE NEW N14 ENGINE, THE COVER WILL LOOK DIFFERENT IN APPEARANCE. THE REPLACEMENT COVER IS NOW EQUIPPED WITH A CRANKCASE VENTILATION SYSTEM PRESSURE RELIEF VALVE. NO MODEL YEARS LISTED. *PE
SI-M-13-01-08
Service Bulletin/Repair Instructions
MINI: FUEL ODOR FROM THE ENGINE COMPARTMENT. THE HIGH PRESSURE PUMP (HDP) AND/OR THE LOW PRESSURE SUPPLY HOSE CONNECTION CAN ALLOW FUEL SEEPAGE, RESULTING IN THE FUEL ODOR. *PE
SI M36-01-08
Service Bulletin/Repair Instructions
THE TIRE WARNING ILLUMINATED DUE TO LOW AMBIENT TEMPERATURE. MODELS R52 (COOPER AND COOPER S) FROM 9/07 AND R56 (COOPER AND COOPER S) FROM 8/07. *PE