ITS61267
Service Bulletin/Repair Instructions
Instructions to replace current k-member with an upgraded casting design.
Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
ITS61267
Instructions to replace current k-member with an upgraded casting design.
TSIB 25-01
Thermo-King has issued a Service Bulletin (SB866-1) related to the clutch bearing maintenance on their QS616 HVAC screw compressor. New Flyer is issuing this Technical Service Information Bulletin to notify New Flyer XD60, XN60 and XDE60 bus operators about this Thermo-King Service Bulletin.
ITS61063
Instructions to Service to remove bypassed engine calibration from ECM and replace DEF sensor as required.
ITS61187
Instructions to Service to incorporate a PLC Update to prevent interlock activation when CAN speed messages are absent.
ITS60288
This Instruction to Service (ITS) decribes the inspection procedure required to inspect the upper bulkhead brakets for cracks, on the articulation joint of a sixty foot bus.
ITS59266
Technical Instruction describing how to mechanically fasten the Engergy Guide System (EGS) support brackets to the existing upper bulkhead structure at the articulation joint.
ITS58843
This is a technical service instruction describing how to weld/repair cracks as required at Diesel Exhaust Fluid (DEF) tank bracket, and add reinforcement bracket at DEF tank bracket area.
SMB-182
This Service Manual Bulletin Identifies a New Requirement for Bolt Replacement in the Artic Joint Support Frame Installed on your New Flyer Vehicle.
SMB180
This Service Manual Bulletin Provides Updated Preventive Maintenace Interval for the Crankcase Breather Tube Element on Buses Equipped with a Cummins Diesel ISL 07 or ISL 09 Engine.
PMB049
This Parts Manual Bulletin provides new part number information for the moveable arm kit for the Kongsberg brake and accelerator assembly on specifically equipped vehicles.
SMB178
This Service Manual Bulletin provides new OEM (Kongsberg) PM inspection requirements and new installation procedure for the adjustable floor pedal moveable arm on specifically equipped vehicles.
ITS6683
This Maintenance Instruction Describes How to Install New Articulation Joint Panel Cosmetic Caps.
SMB177
This Service Manual Bulletin provides new inspection and replacement requirements for the coolant hoses located above the SDS enclosure on specifically equipped buses.
SMB176
This Service Manual Bulletin provides new information on how to check for proper chain tension, as measured by the chain deflection, while performing the ramp mechanism initial adjustments. This bulletin only applies to vehicles with New Flyer designed ramps.
ITS6467
This Maintenance Instruction Describes How to Add Re-enforcement Brackets to the Existing Air Accessory Tank Mounting Bracket.
PMB048
This Parts Manual bulletin provides information on the part numbers of the engine lift brackets
SMB173
This bulletin provides PM inspection requirements for the K-menber on the fuel tank support structure
ITS6572
This Maintenance Instruction describes an inspection of ZF center axle hub/rotor bolt torque.
SMB170
This Service Manual Bulletin provides a correction for the information regarding the replacement of the DEF tank suction filter.
SMB168
Service Manula Bulletin provides revised OEM information on the exhaust, after treatment System and DEF tank.
ITS6348
TECHNICAL INSTRUCTION TO MODIFY ARTICULATION JOINT BELLOWS ASSEMBLY CLEARANCE.
ITS6236
TECHNICAL INSTRUCTION TO ADD PRESSURE PROTECTION VALVE AT THE SPRING/PARKING BRAKE EMERGENCY RELEASE TANK.
ITS6368
TECHNICAL INSTRUCTION TO REWIRE THE VOLTAGE REGULATOR POWER SUPPLY FROM THE BATTERY SIDE TO THE LOAD SIDE OF THE BATTERY DISCONNECT SWITCH.
ITS6406
TECHNICAL INSTRUCTION TO CORRECT INSTALLATION OF STEERING GEARBOX MOUNTING PLATE.
ITS6221
TECHNICAL INSTRUCTION TO REMOVE AND REWORK ARTICULATION JOINT BELLOWS ASSEMBLY ON SPECIFICALLY EQUIPPED VEHICLES
ITS6234
TECHNICAL INSTRUCTION TO INSPECT FRONT MASK SUPPORT BRACKET BOND AND REPAIR IF REQUIRED ON SPECIFICALLY EQUIPPED VEHICLES
ITS6254
TECHNICAL INSTRUCTION TO RECONFIGURE VOLTAGE SENSE CONNECTION WIRING ON SPECIFICALLY EQUIPPED VEHICLES
1604 NHTSA
Sec. 579.5 - Notices, bulletins, custoimer satisf ac tion campaigns, consumer advisories, and other communications.
ITS6185
TECHNICAL INSTRUCTION TO INSPECT STREET SIDE DRIVER'S EXTERIOR MIRROR SNAP BUSHING.
ITS6216
TECHNICAL INSTRUCTION TO REMOVE AND REPLACE DEFROSTER HEATER BLOWER RESISTOR.
1603 NHTSA
Sec. 579.5 - Notices, bulletins, custoimer satisf ac tion campaigns, consumer advisories, and other communications.
ITS6167
Technical Instruction to Rotate Current Sensor.
SMB-145
NEW FLYER: INFORMATION REGARDING THE WHEEL FLANGE AND LOWER RADIUS ROAD TO AXLE INSTALLATION WHEREBY CONDITION OF BOLTS NEED CHECKING AND IF ANY DEFORMITY OR DAMAGE TO MOUNTING BOLTS, HAVE THEM REPLACED. NO YEARS OR MODEL LISTED. *PE
ITS5909
NEW FLYER: 2010 EPA OR NEWER ENGINES AND MINI-HYBRID COOLING SYSTEM BUSES WITH ISOLATED PIPE CLAMPS MAY EXPERIENCE RADIATOR CORROSION. *TA
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.