Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
TSIB 25-01
Thermo-King has issued a Service Bulletin (SB866-1) related to the clutch bearing maintenance on their QS616 HVAC screw compressor. New Flyer is issuing this Technical Service Information Bulletin to notify New Flyer XD60, XN60 and XDE60 bus operators about this Thermo-King Service Bulletin.
ITS60288
This Instruction to Service (ITS) decribes the inspection procedure required to inspect the upper bulkhead brakets for cracks, on the articulation joint of a sixty foot bus.
SMB186
Service Manual Bulletin providing revised, corrected or additional information for the Preventive Maintenance on buses specifically equipped with a Powerex direct drive air compressor.
SMB188
Service Manual Bulletin provides revised information for the Preventive Maintenance on specifically equipped vehicles with the Powerex belt driven air compressor.
SMB187
Service Manual Bulletin which stresses the need for safety when performing maintenance on the high voltage systems on your New Flyer vehicle.
SMB-182
This Service Manual Bulletin Identifies a New Requirement for Bolt Replacement in the Artic Joint Support Frame Installed on your New Flyer Vehicle.
SMB180
This Service Manual Bulletin Provides Updated Preventive Maintenace Interval for the Crankcase Breather Tube Element on Buses Equipped with a Cummins Diesel ISL 07 or ISL 09 Engine.
PMB049
This Parts Manual Bulletin provides new part number information for the moveable arm kit for the Kongsberg brake and accelerator assembly on specifically equipped vehicles.
SMB178
This Service Manual Bulletin provides new OEM (Kongsberg) PM inspection requirements and new installation procedure for the adjustable floor pedal moveable arm on specifically equipped vehicles.
SMB177
This Service Manual Bulletin provides new inspection and replacement requirements for the coolant hoses located above the SDS enclosure on specifically equipped buses.
SMB176
This Service Manual Bulletin provides new information on how to check for proper chain tension, as measured by the chain deflection, while performing the ramp mechanism initial adjustments. This bulletin only applies to vehicles with New Flyer designed ramps.
PMB048
This Parts Manual bulletin provides information on the part numbers of the engine lift brackets
SMB173
This bulletin provides PM inspection requirements for the K-menber on the fuel tank support structure
SMB170
This Service Manual Bulletin provides a correction for the information regarding the replacement of the DEF tank suction filter.
ITS6522
Technical Instruction to inspect and repair support brackets on an accessory air system reservoir
SMB168
Service Manula Bulletin provides revised OEM information on the exhaust, after treatment System and DEF tank.
ITS5930
NEW FLYER: 2010 EPA XCELSIOR DIESEL NON-HYBRIDS WITH ISOLATED PIPE CLAMPS OR WITH NEWER ENGINES AND MINI-HYBRID COOLING SYSTEMS MAY EXPERIENCE RADIATOR CORROSION. *TA
ITS5909
NEW FLYER: 2010 EPA OR NEWER ENGINES AND MINI-HYBRID COOLING SYSTEM BUSES WITH ISOLATED PIPE CLAMPS MAY EXPERIENCE RADIATOR CORROSION. *TA
ITS5711
TECHNICAL INSTRUCTION TO REMOVE AND REPLACE HARDWARE ON HIGH VOLTAGE CABLE SUPPORT BRACKET PIVOT SHAFT.
ITS-5322
NEW FLYER: INFORMATION PROVIDED ON THE REMOVAL OF THE ISE COOLING LOOP BYPASS. NO MODEL OR YEARS LISTED. *PE
ITS-5481
NEW FLYER: INFORMATION ON REWORKING TRANSMISSION COOLER WIRE HARNESS, DUE TO OVER EXPOSURE OF UV RADIATION, BY THE SUN, THE WIRE INSULATION AND RED WIRE IN HARNESS WILL BECOME BRITTLE AND CRACK CAUSING INOPERABLE FAN AND POSSIBLE FAN FAULT DASH LIGHT, OVER HEATING PROPULSION AND SHUTDOWN. NO MODEL OR YEARS LISTED. *PE
ITS5601
Technical Instruction to Correct Randon Shutdown of Instrument Panel.
ITS5514
Technical Instruction to Replace Engine Harness Loom.
ITS5487
Technical Instruction to Add Thermo-L-Wrap to Coolant Lines.
ITS5426
Technical Instruction to Modify Front Curbside Skid Plate Installation.
ITS5394
Technical Instruction to Install Exhaust Flex Connector Insulated Blanket.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.