ITS61267
Service Bulletin/Repair Instructions
Instructions to replace current k-member with an upgraded casting design.
Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
ITS61267
Instructions to replace current k-member with an upgraded casting design.
TSIB 25-01
Thermo-King has issued a Service Bulletin (SB866-1) related to the clutch bearing maintenance on their QS616 HVAC screw compressor. New Flyer is issuing this Technical Service Information Bulletin to notify New Flyer XD60, XN60 and XDE60 bus operators about this Thermo-King Service Bulletin.
TSIB 22-13 Rev B
Service bulletin increasing the torque value of a joint in a double-tilt steering column spline shaft.
ITS60288
This Instruction to Service (ITS) decribes the inspection procedure required to inspect the upper bulkhead brakets for cracks, on the articulation joint of a sixty foot bus.
ITS59266
Technical Instruction describing how to mechanically fasten the Engergy Guide System (EGS) support brackets to the existing upper bulkhead structure at the articulation joint.
ITS59105
Technical instruction describing how to re-mark existing BAE HS300 ACTM dipsticks.
ITS59005
Technical Instruction issued to document and track BAE Systems HDS300 hybrid drive traction motor program update.
ITS58838
Technical Instruction describing how to repair cracks in DEF tank bracket welds, and add reinforced support bracket to DEF tank area.
SMB186
Service Manual Bulletin providing revised, corrected or additional information for the Preventive Maintenance on buses specifically equipped with a Powerex direct drive air compressor.
SMB188
Service Manual Bulletin provides revised information for the Preventive Maintenance on specifically equipped vehicles with the Powerex belt driven air compressor.
SMB187
Service Manual Bulletin which stresses the need for safety when performing maintenance on the high voltage systems on your New Flyer vehicle.
SMB-182
This Service Manual Bulletin Identifies a New Requirement for Bolt Replacement in the Artic Joint Support Frame Installed on your New Flyer Vehicle.
SMB180
This Service Manual Bulletin Provides Updated Preventive Maintenace Interval for the Crankcase Breather Tube Element on Buses Equipped with a Cummins Diesel ISL 07 or ISL 09 Engine.
ITS6754
This Maintenance Instruction Decribes How to Update Battery Equalizer Programming.
ITS6724
This Maintenance Instruction Describes How to Replace the Air Compressor Filter.
PMB049
This Parts Manual Bulletin provides new part number information for the moveable arm kit for the Kongsberg brake and accelerator assembly on specifically equipped vehicles.
SMB178
This Service Manual Bulletin provides new OEM (Kongsberg) PM inspection requirements and new installation procedure for the adjustable floor pedal moveable arm on specifically equipped vehicles.
ITS6704
This Maintenance Instruction Describes How to Ensure Proper Clearance Between CAC Exhaust Support and Gen 5 Coolant Lines.
ITS6706
This Maintenance Instruction Describes How to Rewire the Engine Compartment Cooling Fill Mode Switch
SMB177
This Service Manual Bulletin provides new inspection and replacement requirements for the coolant hoses located above the SDS enclosure on specifically equipped buses.
SMB176
This Service Manual Bulletin provides new information on how to check for proper chain tension, as measured by the chain deflection, while performing the ramp mechanism initial adjustments. This bulletin only applies to vehicles with New Flyer designed ramps.
ITS6632
This Maintenance Instruction Describes How to Remove and Replace the Speedometer Module.
ITS6623
This Maintenance Instruction Describes How to Inspect Rear Axle Hub Spindle Nuts
PMB048
This Parts Manual bulletin provides information on the part numbers of the engine lift brackets
SMB173
This bulletin provides PM inspection requirements for the K-menber on the fuel tank support structure
ITS6572
This Maintenance Instruction describes an inspection of ZF center axle hub/rotor bolt torque.
SMB170
This Service Manual Bulletin provides a correction for the information regarding the replacement of the DEF tank suction filter.
SMB168
Service Manula Bulletin provides revised OEM information on the exhaust, after treatment System and DEF tank.
ITS6405
TECHNICAL INSTRUCTION TO REWORK HEAT EXCHANGER CABIN LOOP LINE AND ROUTING
ITS6420
TECHNICAL INSTRUCTION FOR AMEREX DISPLAY MODULE AND FIRMWARE VALIDATION
ITS6337
TECHNICAL INSTRUCTION TO RETROFIT NEW AIR COMPRESSOR MOUNTING BRACKETS.
ITS6402
TECHNICAL INSTRUCTION TO REWORK HEAT EXCHANGER COOLANT LINE AND LINE ROUTING.
ITS6406
TECHNICAL INSTRUCTION TO CORRECT INSTALLATION OF STEERING GEARBOX MOUNTING PLATE.
ITS6410
TECHNICAL INSTRUCTION TO INSTALL CLOSEOUT PLATE TO SEAL HOLE IN HV JUNCTION BOX
ITS6340
TECHNICAL INSTRUCTION OUTLINING PROCEDURE FOR CHECKING DIRECT DRIVE COMPRESSOR COUPLING BOLTS.
ITS6364
TECHNICAL INSTRUCTION TO REWORK HEAT EXCHANGER CABIN LOOP LINE AND ROUTING.
ITS6249
TECHNICAL INSTRUCTION TO RETROFIT THE EXISTING AIR COMPRESSOR AIR INTAKE FILTER MOUNTING BRACKET.
ITS6234
TECHNICAL INSTRUCTION TO INSPECT FRONT MASK SUPPORT BRACKET BOND AND REPAIR IF REQUIRED ON SPECIFICALLY EQUIPPED VEHICLES
ITS6182
Technical Instruction to Remove and Reinstall Driver's Barrier with Loctite.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.