251030 Battery email
Other
A consumer notification indicating one of New Flyer's battery suppliers is exiting the market.
Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
251030 Battery email
A consumer notification indicating one of New Flyer's battery suppliers is exiting the market.
TSIB 25-07
This Bulletin is being issued due to New Flyer & MCI have received reports that customers are re-torquing high-voltage (HV) connections during preventative maintenance inspections as outlined in the Preventive Maintenance section of the Service or Maintenance manual. This Bulletin reminds operators that the inspection procedure is visual only and does not require retorque unless the witness marks indicate the fasteners have loosened.
TSIB 25-04
This Technical Service Information Bulletin has been issued to remind customers that fill pressure must not exceed 25 psi to avoid injury or damage components during filling and deaeration of the ESS Battery Thermal Management System.
ITS61250
Instruction to Service for updating ESS drains, remove internal mechanism, re-install and add duckbill. Remove the ESS breather, extract the internal mechanism, remove the three desiccant bags and reinstall the breather. 6 string buses.
ITS61089
Service instruction to verify welds on PEM mounts.
IST-60523
ITS was issued to correct the orientation of HV contactors. Incorrect orientation can lead to premature failure
TSIB 22-08
New Flyer has issued Technical Service Information Bulletin (TSIB) 22-08, providing for the application of silicone paste onto overhead charging rails to inhibit water from collecting on the rails
ITS60312
The Instruction to Service describes the rework procedure for the high voltage charging receptical assembly power cable lugs on specifically equpped buses.
ITS60373
This Instruction to Service describes how to remove and repalce the circuit breaker for the Valeo coolant pump installed on specifically equipped buses.
ITS59239
This instruction to service describes how to inspect specifically equipped vehicles for SDS Window components and function, and how to rework these components if required. The "SDS Window" is a maintenance access panel designed to look like a side window.
ITS59216
This technical service instruction describes how to remove and replace SDS Window strike pins and remove additional seals if present. The "SDS Window" is a maintenance access panel designed to look like a side window.
ITS59120
This is a technical service instruction describing how to replace the incorrect EPA placard installed during production. Because these placards are a controlled item, these actions were conducted by New Flyer field personnel only at the customer locations.
ITS59014
Technical Instruction describing how to replace the master service disconnect (MSD) on specific electrical systems
ITS58961
Technical Instruction on how to replace the secondary cover on the DC charge rail box.
ITS58926
Technical Instruction describing the DC charge rail and COM box lid replacement and inspection requirement
ITS58940
Technical Instruction describing how to check the polarity on the auxiliary electric heater HV cable assembly
190524-115466
Programmable Logic Controller (PLC) program change - to correct the requirement to manually cycle the rear doors open and closed before operating the bus.
ITS58932
Technical Instruction describing how to reprogram the CM0711 gateway module
ITS58912
Technical Instruction describing the DC charge rail box power cable replacement.
ITS58910
Technical Instruction describing how to retrofit new shock absorber dust covers, height sensor and harness assembly for optional leveling system on 40 foot buses.
ITS58884
Technical Instruction to Rework Front Forward Mud Flap, to reduce exterior airflow through the front door ramp assembly.
ITS58874
Technical Instruction describing the inspection procedures for the high voltage systems on a battery electric bus.
SMB189
Service Manual Bulletin - Update to high voltage safety procedures, specifically Lockout/Tagout, de-energizing and re-energizing procedures for both battery electric and fuel cell buses.
SMB186
Service Manual Bulletin providing revised, corrected or additional information for the Preventive Maintenance on buses specifically equipped with a Powerex direct drive air compressor.
SMB188
Service Manual Bulletin provides revised information for the Preventive Maintenance on specifically equipped vehicles with the Powerex belt driven air compressor.
SMB187
Service Manual Bulletin which stresses the need for safety when performing maintenance on the high voltage systems on your New Flyer vehicle.
SMB185
Service Manual Bulletin describing a modification to the lubrication procedure for the Energy Storage System (ESS) battery coolant filter replacement, during normal preventative maintenance schedule.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.