SMB191
Service Bulletin/Repair Instructions
Service Manual Bulletin - Changes to Cummins ISLG and L9N engine oil specifications and oil change intervals.
Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
SMB191
Service Manual Bulletin - Changes to Cummins ISLG and L9N engine oil specifications and oil change intervals.
TSIB 20-01
Technical Service Information Bulletin describing changes to the Cummins ISLG, L9N, ISB6.7G and B6.7N engine oil specifications.
TSIB-18-01
This Technical Service Information Bulletin Decsribes How to Inspect and Reroute as Required the Cummins L9N Engine Crankcase Ventilation Hose.
ITS6745
This Maintenance Instruction Decribes How to Replace the Surge Tank Low Coolant Level Sensor.
PMB049
This Parts Manual Bulletin provides new part number information for the moveable arm kit for the Kongsberg brake and accelerator assembly on specifically equipped vehicles.
SMB178
This Service Manual Bulletin provides new OEM (Kongsberg) PM inspection requirements and new installation procedure for the adjustable floor pedal moveable arm on specifically equipped vehicles.
SMB177
This Service Manual Bulletin provides new inspection and replacement requirements for the coolant hoses located above the SDS enclosure on specifically equipped buses.
SMB176
This Service Manual Bulletin provides new information on how to check for proper chain tension, as measured by the chain deflection, while performing the ramp mechanism initial adjustments. This bulletin only applies to vehicles with New Flyer designed ramps.
PMB048
This Parts Manual bulletin provides information on the part numbers of the engine lift brackets
SMB173
This bulletin provides PM inspection requirements for the K-menber on the fuel tank support structure
SMB169
This Service Manual Bulletin provides a procedure for venting the tanks when the solenoid valve is stuck closed or not operating, and a procedure for the installation of the solenoid valve on the CNG tank.
ITS6420
TECHNICAL INSTRUCTION FOR AMEREX DISPLAY MODULE AND FIRMWARE VALIDATION
ITS6369
TECHNICAL INSTRUCTION TO REWIRE THE VOLTAGE REGULATOR POWER SUPPLY FROM THE BATTERY SIDE TO THE LOAD SIDE OF THE BATTERY DISCONNECT SWITCH.
ITS6364
TECHNICAL INSTRUCTION TO REWORK HEAT EXCHANGER CABIN LOOP LINE AND ROUTING.
ITS6254
TECHNICAL INSTRUCTION TO RECONFIGURE VOLTAGE SENSE CONNECTION WIRING ON SPECIFICALLY EQUIPPED VEHICLES
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.