ITS59303
Service Bulletin/Repair Instructions
Technical Instruction describing hos to remove, rework, and replace the stop request sign support bracket, to promote clearance for electrical wiring.
Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
ITS59303
Technical Instruction describing hos to remove, rework, and replace the stop request sign support bracket, to promote clearance for electrical wiring.
ITS58950
Technical Instruction describing how to remove and replace the front suspension air springs,
SMB191
Service Manual Bulletin - Changes to Cummins ISLG and L9N engine oil specifications and oil change intervals.
TSIB 20-01
Technical Service Information Bulletin describing changes to the Cummins ISLG, L9N, ISB6.7G and B6.7N engine oil specifications.
ITS58835
Technical Instruction describing how to download a program to the Vansco Programmable Logic Control (PLC) system on buses equipped with under-dash USB port.
ITS58810
Technical Instruction on how to remove and replace the left rear muffler access door, including paint instruction.
TSIB-18-01
This Technical Service Information Bulletin Decsribes How to Inspect and Reroute as Required the Cummins L9N Engine Crankcase Ventilation Hose.
ITS58416
This Maintenance Instruction Describes How to Inspect for Correct Installation of O2 Sensor Seals and Insulation.
ITS6914
This Maintenance Instruction Describes How to Remove and Install Streetside and Curbside Windshield Wiper Idler Arm Assemblies.
ITS6790
This Maintenance Instruction Describes How to Install CNG Diamond Decals on the Sides of the Vehicle. This is a new requirement of the NFPA 52 - April 2016 Edition which was missed due to a specification language interpretation. NFPA 52 - 15.2.11.1.5 "...In addition to the requirement in 15.2.11.1.2 for placement of the diamond-shaped label on the lower right rear of the vehicle, labels shall be affixed to each side of the power unit..." The "power unit" - is defined in the NFPA 52 as "the vehicle".
ITS6845
This Maintenance Instruction Describes How to Remove and Replace Exhaust Compartment Harness Heat Shield.
ITS6745
This Maintenance Instruction Decribes How to Replace the Surge Tank Low Coolant Level Sensor.
PMB049
This Parts Manual Bulletin provides new part number information for the moveable arm kit for the Kongsberg brake and accelerator assembly on specifically equipped vehicles.
SMB178
This Service Manual Bulletin provides new OEM (Kongsberg) PM inspection requirements and new installation procedure for the adjustable floor pedal moveable arm on specifically equipped vehicles.
ITS6703
This Maintenance Instruction Describes How to Update Voltage Equalizer Programming.
SMB176
This Service Manual Bulletin provides new information on how to check for proper chain tension, as measured by the chain deflection, while performing the ramp mechanism initial adjustments. This bulletin only applies to vehicles with New Flyer designed ramps.
SMB173
This bulletin provides PM inspection requirements for the K-menber on the fuel tank support structure
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.