NTB08-097L
Service Bulletin/Repair Instructions
DIAGNOSIS OF VEHICLE PULL (DRIFT) AND/OR STEERING WHEEL OFF-CENTER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
NTB08-097L
DIAGNOSIS OF VEHICLE PULL (DRIFT) AND/OR STEERING WHEEL OFF-CENTER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB23-049
12 VOLT BATTERY TESTING FOR IN-SERVICE VEHICLES SERVICE INFORMATION The following Service Information lists NNA procedural recommendations for establishing good connections while performing 12V battery testing. These recommendations are expected to promote uniformity during the connection process, therefore reducing the number of incorrect âTest with DCAâ and âReplaceâ results. HINT: If 12 volt batteries are allowed to discharge for a prolonged period of time, battery life may be drastically reduced. This condition may lead to premature battery replacement and customer dissatisfaction. IMPORTANT: ï· CPX-900 is now an accepted testing tool to use along with or in place of the DSS-5000 ï· CPX-900 operating instructions are found at: https://nissancpx900.midtronics.com/ ï· DSS-5000 operating instructions are found at: https://nissandss5000.midtronics.com/ ï· DCA-8000 is now a required testing tool to be used for all warranty replacement decisions. The DCA-8000 is also a more efficient charger than previously available, and will charge any available 12 volt lead acid battery safely and accurately as long as all precautions and inputs are made correctly. The DCA-8000 operating instructions are found at: https://nissandca8000.midtronics.com/
NTB23-053
SILICONE-BASED LUBRICANT OR GREASE CAN DAMAGE ELECTRICAL COMPONENTS SERVICE INFORMATION Do not apply Silicone-based lubricants or grease to, or around, any interior electrical components. To avoid the risk of death or severe personal injury, do not directly spray Silicone-based lubricant or grease, or inadvertently overspray Silicone-based lubricant or grease onto any interior electrical components. These types of lubricants can be detrimental to the proper operation of electrical components.
NTB13-107F
VEHICLE KEY NOT DETECTED / AUTHENTICATED, ENGINE WILL NOT START This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB16-003C
INTELLIGENT KEY REPLACEMENT OR SWAPPING BETWEEN VEHICLES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Discard all previous versions of this bulletin.
NTB09-081J
WINDSHIELD CRACKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB13-028H
REMOVING FOREIGN MATERIAL FROM THE WINDOW GLASS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB08-097K
DIAGNOSIS OF VEHICLE PULL (DRIFT) AND/OR STEERING WHEEL OFF-CENTER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB10-126C
WHEEL BEARING COLLISION DAMAGE This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB99-001F
STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB99-001e
STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB00042D
SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat-Mounted Side-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Nissan STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger seat cushion. See this bulletin for further detail.
NTB-08-055-A
NISSAN: SRS PRECAUTIONS DURING SERVICE;IMPROPER MAINTENANCE, INCLUDING INCORRECT REMOVAL AND INSTALLATION OF THE SRS, CAN LEAD TO A SERIOUS INJURY OR DEATH CAUSED BY UNINTENTIONAL ACTIVATION OF THE SRS ON ALL NISSAN MODELS WITH THE SRS SYSTEMS. *PE UPDATED 2/21/14. *PE
NTB08055C
SERVICE INFORMATION Information necessary to service the Supplemental Restraint System (SRS) safely is included in the "RESTRAINTS" section of the Electronic Service Manual (ESM) for each vehicle. IMPORTANT: Turn the ignition switch OFF, disconnect both battery terminals, and wait at least 3 minutes before performing any service on the SRS. See this bulletin for further detail.
NTB92123D
Nissan Original Equipment or Genuine Accessory Alloy wheels, along with their finish coating (clear, chrome, titanium, etc.), are specifically developed to achieve Nissan design and performance standards. These Original Equipment or Genuine Accessory wheels are subjected to testing to ensure they meet Nissan's standards. Nissan Original Equipment Alloy or Genuine Accessory wheels subjected to aftermarket chroming may no longer continue to meet these standards and may be seriously damaged. Therefore, Nissan most strongly discourages, and recommends that these wheels NEVER be subjected to, aftermarket chroming. See this bulletinfor further detail.
NTB00033E
SERVICE INFORMATION - This bulletin is to assist you in responding to customer questions about brake operation, and provides diagnostic and repair information for each item listed, if any should occur. - Most brake incidents fall into the following categories: a. Brake Noise: A squeak, squeal, clunk, or groan that occurs when the brakes are applied or released. b. Brake Judder: A vibration that can be felt in the vehicle, steering wheel or brake pedal when the brakes are applied. c. Pedal Feel: The effort needed to operate the brakes is too high or too low. SERVICE PROCEDURE 1. Verify the condition by road testing the vehicle with the customer. 2. Determine the specific brake incident based on the description in the Service Information above. 3. Follow the appropriate repair procedure(s), listed on the following pages, for your specific incident. See this bulletin for further details.
NTB04094A
If YOU CONFIRM: A vehicle needs to have the brake rotors resurfaced (front or rear). ACTION: Use the ProCut PFM Series on-car brake lathe to perform brake rotor resurfacing and follow the tips listed in this bulletin. - The ProCut PFM Series brake lathe has been chosen as the approved tool for rotor resurfacing. - The ProCut PFM Series brake lathe can be ordered from TECH-MATE at 1-800-662-2001. - ProCut technical support or service can be obtained by calling 1-800-543-6618. NOTE: Brake rotors may need to be resurfaced during routine brake repair or for brake "judder" incidents. - Brake judder: A brake pedal pulsation and/or steering wheel shimmy when braking that occurs when there is too much thickness variation of the brake rotors (see NTB00-033). See this bulletin for further detail.
NTB98018G
As part of an enhanced emissions test for Inspection & Maintenance (I/M), some States may require the System Readiness Test (SRT) status be checked. - The SRT is used to indicate whether the engine control module (ECM) has completed self diagnosis of major emissions systems and components. - In these instances the State may require completion of the SRT before permitting the emissions inspection to proceed. Refer to this Bulletin for further details.
NTB-13-038
NISSAN: LOCK/UNLOCK REQUEST BUTTON ON OUTSIDE HANDLE DOES NOT RESPOND. *JS
NTB99001A
SERVICE INFORMATION This bulletin provides information to identify: - A leaking strut or a shock absorber that qualifies for replacement under warranty. - A strut or shock absorber that has slight oil seepage, a condition which is considered normal, does not affect strut/shock absorber operation or performance, and does not require replacement. - A strut or shock absorber that should be replaced due to rod resistance/noise issues. See this bulletin for further detail.
NTB-09-101
NISSAN: TIRE PRESSURE MONITORING SYSTEM (TPMS) WARNING LIGHT ON/FLASHING. NO MODELS OR MODEL YEARS LISTED. *PE UPDATED ON 08-11-2011. *KB
NTB-09-129
NISSAN: VENT CONTROL VALVE REPLACEMENT. WHEN REPLACING THE EVAP CANISTER VENT CONTROL VALVE FOR REASON: USE THE ONE LISTED ON PAGE 2; FOR VENT CONTROL VALVE REPLACEMENT PROCEDURE, REFER TO THE APPROPRIATE SECTION OF THE ELECTRONIC SERVICE MANUALS (ESM; WHEN INSTALLING THE NEW VALVE, DO NOT ADD ANY LUBE TO ITS O RING; FOR FRONTIER (D40 SERIES) ONLY, INSTALL THE PROTECTOR LISTED IN PARTS INFORMATION. *PE INCLUDES 2005-09 FRONTIER. UPDATED 12/8/10. *PE
NTB-09-030
NISSAN: THE 12 VOLT BATTERY IS AN IMPORTANT PART OF THE VEHICLE ELECTRICAL SYSTEM AND IS REQUIRED TO STAY CONNECTED WHEN THE ENGINE IS RUNNING. TO PREVENT DAMAGE TO VEHICLE ELECTRONIC COMPONENTS FOLLOW THE INSTRUCTIONS/CAUTIONS. NO MODEL YEARS LISTED. *PE
99022
FRONT SEAT BELT LATCH PLATE RETAINING BUTTON MISSING. *TT
04133
AUTO-DIMMING ELECTROCHROMIC (EC) MIRROR DIAGNOSIS. *TT
NTB99022C
FRONT SEAT BELT LATCH PLATE RETAINING BUTTON MISSING. *TT
NTB99053B
SUBJECT REGARDING REVISED THROTTLE POSITION SENSOR (TPS) ADJUSTMENT PROCEDURE. *TT
NTB01057
SUBJECT REGARDING REVISED MAINTENANCE PROCEDURES. *SLC
NTB01044
SERVICE INFORMATION REGARDING INNER TIE ROD WRENCHES. *SB
NTB99022B
SEAT BELT LATCH PLATE RETAINING BUTTON MISSING. *TT
NTB01023
INFORMATION REGARDING ESSENTIAL TOOL: THROTTLE POSITION SENSOR TEST CONNECTOR. *SLC
NTB00047
SOME VEHICLES MAY EXHIBIT STEERING WHEEL VIBRATION OR BRAKE PEDAL PULSATION WHEN BRAKING, CONSIDERED AS BRAKE JUDDER. *TT
NTB99-036A
INFORMATION REGARDING KEYLESS REMOTE ENTRY PROGRAMMING. *TT
NTB98013A
INFORMATION ON DIAGNOSTIC PROCEDURE FOR SLOW FUEL FILL. *TT
NTB99052
SERVICE INFORMATION TO REPAIR VEHICLES EXHIBITING SQUEAK AND RATTLE NOISE(S). *TT
NTB99022A
CONCERNS WITH THE FRONT SEAT BELT LATCH PLATE STOPPER BUTTON MISSING. *TT
NTB99047
THIS BULLETIN CONTAINS INFORMATION ON REPLACING A BROKEN CENTER CONSOLE LID LATCH. *TT
NTB99005A
KEY VALUE BRAKE PAD SERVICE INFORMATION. *TT
NTB99036
INFORMATION REGARDING KEYLESS REMOTE ENTRY PROGRAMMING. *TT
NTB99019
SERVICE MANUAL PROCEDURE CHANGE FOR REAR OXYGEN SENSOR DTC(S) P0137, P0138, P0139, P0140, P0141 AND THREE-WAY CATALYST DTC P0420. *TT
NTB99005
SERVICE INFORMATION ON KEY VALUE BRAKE PADS. *TT
NTB98021A
VEHICLE WITHIN VARIOUS VIN RANGES MAY EXHIBIT MISFIRE OR RUNNING ROUGHLY DUE TO SPARK PLUG WIRE(S). *TT
NTB98116
VEHICLE EXHIBITING FRONT DOOR WINDOW RATTLING NOISE OR WHEN THE VEHICLE IS DRIVEN OVER ROUGH ROADS DUE TO THE DOOR WINDOW GLASS NOT HELD FIRMLY IN PLACE BY THE GLASS RUN RUBBER. *TT
NTB97073
VEHICLE EXHIBITS A RATTLE NOISE IN THE RIGHT REAR AREA. *YC
NTB98055
SOME VEHICLES BUILT BEFORE 1N4DL01D0WC150648 MAY EXHIBIT EXCESSIVE TIMING CHAIN NOISE. *YC
NTB98056
VEHICLE EXPERIENCING A ROTATIONAL CLUNK NOISE FROM REAR. *YC
NTB98037
VEHICLES EXPERIENCING DOORS LOCK & ALARM SOUNDS FOR NO APPARENT REASON. *YC
NTB98033
EXPERIENCING A OIL LEAK AT FRONT OF ENGINE. *YC
NTB98013
DIAGNOSTIC PROCEDURE FOR SLOW FUEL FILL. *YC
NTB97097
PROCEDURE ON SUNVISOR CLIP REMOVAL. *YC
NTB97091
SERVICE PROCEDURE FOR A HIGH MOUNT STOP LAMP. *YC
NTB97095
VEHICLE EXHIBITS A FRONT OR REAR DOOR WINDOW RATTLE NOISE WHEN THE DOOR IS SLAMMED SHUT WITH THE WINDOW PARTIALLY DOWN. *YC
NTB97087
PROCEDURE FOR FUEL DOOR WHEN IT DOES NOT OPEN. *YC
NTB97088
DIAGNOSIS AND REPAIR PROCEDURE IF TRUNK DOES NOT OPEN WITH INSIDE LEVER. *YC
NTB97079
PROCEDURE FOR REMOVING THE INSTRUMENT CLUSTER LID. *YC
NTB97083
INFORMATION REGARDING NEW A/C O-RING SPECIFICATION. *YC
97102998002
CONCERNS OF FLAPPER VALVE DELETED FROM FUEL FILLER NECK. *YC
97101598023
INFORMATION AND PROCEDURE ON DRIP RAIL WEATHERSTRIP AT REAR DOOR. *YC
97101598029
SERVICE PROCEDURE ON WINDOW RUN RUBBER. *YC
97092498022
EXHIBITING A RATTLE NOISE IN THE REAR AREA WHEN THE SUNROOF IS FULLY OPEN. *YC
97071697007
VEHICLE SECURITY SYSTEM (VSS) REMOTE CONTROLLER IS DIFFICULT TO PROGRAM. *YC
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.