Vehicle report

1997 NISSAN QUEST

Compare every NISSAN QUEST yearNHTSA and EPA records

Service bulletins

54 bulletins

Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.

NTB08-097L

Service Bulletin/Repair Instructions

DIAGNOSIS OF VEHICLE PULL (DRIFT) AND/OR STEERING WHEEL OFF-CENTER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

NTB23-049

Service Bulletin/Repair Instructions

12 VOLT BATTERY TESTING FOR IN-SERVICE VEHICLES SERVICE INFORMATION The following Service Information lists NNA procedural recommendations for establishing good connections while performing 12V battery testing. These recommendations are expected to promote uniformity during the connection process, therefore reducing the number of incorrect “Test with DCA” and “Replace” results. HINT: If 12 volt batteries are allowed to discharge for a prolonged period of time, battery life may be drastically reduced. This condition may lead to premature battery replacement and customer dissatisfaction. IMPORTANT:  CPX-900 is now an accepted testing tool to use along with or in place of the DSS-5000  CPX-900 operating instructions are found at: https://nissancpx900.midtronics.com/  DSS-5000 operating instructions are found at: https://nissandss5000.midtronics.com/  DCA-8000 is now a required testing tool to be used for all warranty replacement decisions. The DCA-8000 is also a more efficient charger than previously available, and will charge any available 12 volt lead acid battery safely and accurately as long as all precautions and inputs are made correctly. The DCA-8000 operating instructions are found at: https://nissandca8000.midtronics.com/

NTB23-053

Service Bulletin/Repair Instructions

SILICONE-BASED LUBRICANT OR GREASE CAN DAMAGE ELECTRICAL COMPONENTS SERVICE INFORMATION Do not apply Silicone-based lubricants or grease to, or around, any interior electrical components. To avoid the risk of death or severe personal injury, do not directly spray Silicone-based lubricant or grease, or inadvertently overspray Silicone-based lubricant or grease onto any interior electrical components. These types of lubricants can be detrimental to the proper operation of electrical components.

NTB13-107F

Service Bulletin/Repair Instructions

VEHICLE KEY NOT DETECTED / AUTHENTICATED, ENGINE WILL NOT START This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

NTB16-003C

Service Bulletin/Repair Instructions

INTELLIGENT KEY REPLACEMENT OR SWAPPING BETWEEN VEHICLES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Discard all previous versions of this bulletin.

NTB09-081J

Service Bulletin/Repair Instructions

WINDSHIELD CRACKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

NTB13-028H

Service Bulletin/Repair Instructions

REMOVING FOREIGN MATERIAL FROM THE WINDOW GLASS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

NTB08-097K

Service Bulletin/Repair Instructions

DIAGNOSIS OF VEHICLE PULL (DRIFT) AND/OR STEERING WHEEL OFF-CENTER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

NTB10-126C

Service Bulletin/Repair Instructions

WHEEL BEARING COLLISION DAMAGE This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

NTB99-001F

Service Bulletin/Repair Instructions

STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

NTB99-001e

Service Bulletin/Repair Instructions

STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

NTB-08-055-A

Service Bulletin/Repair Instructions

NISSAN: SRS PRECAUTIONS DURING SERVICE;IMPROPER MAINTENANCE, INCLUDING INCORRECT REMOVAL AND INSTALLATION OF THE SRS, CAN LEAD TO A SERIOUS INJURY OR DEATH CAUSED BY UNINTENTIONAL ACTIVATION OF THE SRS ON ALL NISSAN MODELS WITH THE SRS SYSTEMS. *PE UPDATED 2/21/14. *PE

NTB08055C

Service Bulletin/Repair Instructions

SERVICE INFORMATION Information necessary to service the Supplemental Restraint System (SRS) safely is included in the "RESTRAINTS" section of the Electronic Service Manual (ESM) for each vehicle. IMPORTANT: Turn the ignition switch OFF, disconnect both battery terminals, and wait at least 3 minutes before performing any service on the SRS. See this bulletin for further detail.

NTB92123D

Service Bulletin/Repair Instructions

Nissan Original Equipment or Genuine Accessory Alloy wheels, along with their finish coating (clear, chrome, titanium, etc.), are specifically developed to achieve Nissan design and performance standards. These Original Equipment or Genuine Accessory wheels are subjected to testing to ensure they meet Nissan's standards. Nissan Original Equipment Alloy or Genuine Accessory wheels subjected to aftermarket chroming may no longer continue to meet these standards and may be seriously damaged. Therefore, Nissan most strongly discourages, and recommends that these wheels NEVER be subjected to, aftermarket chroming. See this bulletinfor further detail.

NTB00033E

Service Bulletin/Repair Instructions

SERVICE INFORMATION - This bulletin is to assist you in responding to customer questions about brake operation, and provides diagnostic and repair information for each item listed, if any should occur. - Most brake incidents fall into the following categories: a. Brake Noise: A squeak, squeal, clunk, or groan that occurs when the brakes are applied or released. b. Brake Judder: A vibration that can be felt in the vehicle, steering wheel or brake pedal when the brakes are applied. c. Pedal Feel: The effort needed to operate the brakes is too high or too low. SERVICE PROCEDURE 1. Verify the condition by road testing the vehicle with the customer. 2. Determine the specific brake incident based on the description in the Service Information above. 3. Follow the appropriate repair procedure(s), listed on the following pages, for your specific incident. See this bulletin for further details.

NTB04094A

Service Bulletin/Repair Instructions

If YOU CONFIRM: A vehicle needs to have the brake rotors resurfaced (front or rear). ACTION: Use the ProCut PFM Series on-car brake lathe to perform brake rotor resurfacing and follow the tips listed in this bulletin. - The ProCut PFM Series brake lathe has been chosen as the approved tool for rotor resurfacing. - The ProCut PFM Series brake lathe can be ordered from TECH-MATE at 1-800-662-2001. - ProCut technical support or service can be obtained by calling 1-800-543-6618. NOTE: Brake rotors may need to be resurfaced during routine brake repair or for brake "judder" incidents. - Brake judder: A brake pedal pulsation and/or steering wheel shimmy when braking that occurs when there is too much thickness variation of the brake rotors (see NTB00-033). See this bulletin for further detail.

NTB98018G

Service Bulletin/Repair Instructions

As part of an enhanced emissions test for Inspection & Maintenance (I/M), some States may require the System Readiness Test (SRT) status be checked. - The SRT is used to indicate whether the engine control module (ECM) has completed self diagnosis of major emissions systems and components. - In these instances the State may require completion of the SRT before permitting the emissions inspection to proceed. Refer to this Bulletin for further details.

NTB-13-038

Service Bulletin/Repair Instructions

NISSAN: LOCK/UNLOCK REQUEST BUTTON ON OUTSIDE HANDLE DOES NOT RESPOND. *JS

NTB99001A

Service Bulletin/Repair Instructions

SERVICE INFORMATION This bulletin provides information to identify: - A leaking strut or a shock absorber that qualifies for replacement under warranty. - A strut or shock absorber that has slight oil seepage, a condition which is considered normal, does not affect strut/shock absorber operation or performance, and does not require replacement. - A strut or shock absorber that should be replaced due to rod resistance/noise issues. See this bulletin for further detail.

NTB-09-101

Service Bulletin/Repair Instructions

NISSAN: TIRE PRESSURE MONITORING SYSTEM (TPMS) WARNING LIGHT ON/FLASHING. NO MODELS OR MODEL YEARS LISTED. *PE UPDATED ON 08-11-2011. *KB

NTB-09-129

Service Bulletin/Repair Instructions

NISSAN: VENT CONTROL VALVE REPLACEMENT. WHEN REPLACING THE EVAP CANISTER VENT CONTROL VALVE FOR REASON: USE THE ONE LISTED ON PAGE 2; FOR VENT CONTROL VALVE REPLACEMENT PROCEDURE, REFER TO THE APPROPRIATE SECTION OF THE ELECTRONIC SERVICE MANUALS (ESM; WHEN INSTALLING THE NEW VALVE, DO NOT ADD ANY LUBE TO ITS O RING; FOR FRONTIER (D40 SERIES) ONLY, INSTALL THE PROTECTOR LISTED IN PARTS INFORMATION. *PE INCLUDES 2005-09 FRONTIER. UPDATED 12/8/10. *PE

NTB-09-030

Service Bulletin/Repair Instructions

NISSAN: THE 12 VOLT BATTERY IS AN IMPORTANT PART OF THE VEHICLE ELECTRICAL SYSTEM AND IS REQUIRED TO STAY CONNECTED WHEN THE ENGINE IS RUNNING. TO PREVENT DAMAGE TO VEHICLE ELECTRONIC COMPONENTS FOLLOW THE INSTRUCTIONS/CAUTIONS. NO MODEL YEARS LISTED. *PE

99022

Service Bulletin/Repair Instructions

FRONT SEAT BELT LATCH PLATE RETAINING BUTTON MISSING. *TT

NTB99022C

Service Bulletin/Repair Instructions

FRONT SEAT BELT LATCH PLATE RETAINING BUTTON MISSING. *TT

NTB99053B

Service Bulletin/Repair Instructions

SUBJECT REGARDING REVISED THROTTLE POSITION SENSOR (TPS) ADJUSTMENT PROCEDURE. *TT

NTB01088

Service Bulletin/Repair Instructions

SOME VEHICLES MAY EXHIBIT A POP NOISE FROM THE SLIDING DOOR WHILE DRIVING. *TT

NTB01033A

Service Bulletin/Repair Instructions

SUBJECT REGARDING FUEL INJECTOR CLEANING FOR VEHICLES WITH ROUGH IDLE, HESITATION OR MALFUNCTION INDICATOR LAMP ON WITH DIAGNOSTIC TROUBLE CODE P0300 - P0306 STORED. *TT

NTB01033

Service Bulletin/Repair Instructions

INFORMATION ON FUEL INJECTOR CLEANING FOR VEHICLES WITH ROUGH IDLE.*JB

NTB01044

Service Bulletin/Repair Instructions

SERVICE INFORMATION REGARDING INNER TIE ROD WRENCHES. *SB

NTB99022B

Service Bulletin/Repair Instructions

SEAT BELT LATCH PLATE RETAINING BUTTON MISSING. *TT

NTB01023

Service Bulletin/Repair Instructions

INFORMATION REGARDING ESSENTIAL TOOL: THROTTLE POSITION SENSOR TEST CONNECTOR. *SLC

NTB00046

Service Bulletin/Repair Instructions

SERVICE INFORMATION USED IF THE DOOR LOCK / UNLOCK OR THE ALARM SOUNDS BY THEMSELVES INTERMITTENTLY ON AN APPLIED VEHICLE. *TT

NTB99022A

Service Bulletin/Repair Instructions

CONCERNS WITH THE FRONT SEAT BELT LATCH PLATE STOPPER BUTTON MISSING. *TT

NTB99030A

Service Bulletin/Repair Instructions

INFORMATION REGARDING AUTOMATIC TRANSAXLE OUTPUT GEAR WHINE (60 - 70 MPH). *TT

NTB99005A

Service Bulletin/Repair Instructions

KEY VALUE BRAKE PAD SERVICE INFORMATION. *TT

NTB99039

Service Bulletin/Repair Instructions

CONCERNS WITH AIR CONDITIONER COMPRESSOR SHUTTING OFF AT AMBIENT TEMPERATURES ABOVE 115 DEGREES F. *TT

NTB99029

Service Bulletin/Repair Instructions

CONCERNS WITH FUEL PUMP WHINING NOISE. *TT

NTB99030

Service Bulletin/Repair Instructions

SOME VEHICLES MAY EXHIBIT A WHINE NOISE WHEN THE VEHICLE IS DRIVEN BETWEEN 60 AND 70 MPH, IN THIRD AND FOURTH GEAR. *TT

NTB99005

Service Bulletin/Repair Instructions

SERVICE INFORMATION ON KEY VALUE BRAKE PADS. *TT

NTB98087

Service Bulletin/Repair Instructions

SOME VEHICLES ARE EXHIBITING EXCESSIVE GEAR WHINE NOISE COMING FROM THE TRANSAXLE. *YC

NTB98018

Service Bulletin/Repair Instructions

INFORMATION REGARDING COUNTERMEASURE ENGINE CONTROL MODULE. *YC

NTB98024A

Service Bulletin/Repair Instructions

VEHICLES MAY EXHIBIT A MALFUNCTION INDICATOR LIGHT ON WITH DTCS P0120, P0510, P0731, P0732 OR P0733 WITH NO DRIVEABILITY INCIDENTS. *YC

NTB98065

Service Bulletin/Repair Instructions

EXHIBITING A CONDTION WHERE THE REAR DEDGE OF THE 2ND SIDE WINDOW IS NOT FLUCH WITH THE FORNT EDGE OF THE 3RD WINDOW AND / OR THE REAR EDGE OF THE 3RD WINDOW IS NOT FLUSH WITH THE VEHICLE BODY WHEN THE WINDOW IS FULLY CLOSED. *YC

NTB98068

Service Bulletin/Repair Instructions

CONDITIONS WITH DOOR LOCK/ UNLOCK AND/ OR ALARM SOUNDS INTERMITTENTLY. *YC

NTB98003

Service Bulletin/Repair Instructions

CONDITION WITH THE REAR MAIN SEAL RETAINER GASKET LEAKING OIL. *YC

NTB98047

Service Bulletin/Repair Instructions

SOME VEHICLES EXPERIENCE REAR MAIN SEAL RETAINER GASKET LEAKING OIL. *YC

NTB98007

Service Bulletin/Repair Instructions

CONDITIONS WITH HEADLINER HANGS DOWN BEHIND SUNROOF OPENING. *YC

NTB98011

Service Bulletin/Repair Instructions

SOME VEHICLES HAS AN EGR MALFUNCTION DUE TO CRACKED BPT VALVE BOTTOM HOSE. *YC

NTB98013

Service Bulletin/Repair Instructions

EXHIBITING AN AIR LEAK NOISE FROM THE UPPER REAR CORNE OF THE FRONT DOOR WINDOW GLASS(S). *YC

HA97-017

Service Bulletin/Repair Instructions

VEHICLE EXHIBITS AN ODOR COMING FROM THE A/C OR HEATER VENTS THAT SMELLS "MUSTY" OR LIKE "URINE" OR "DIRTY SOCKS. *YC

NTB97086

Service Bulletin/Repair Instructions

EXPERIENCE LEAKAGE FROM THE A/C EVAPORATOR CONDENSATION. *YC

NTB97081

Service Bulletin/Repair Instructions

DEACTIVATION OF RIGHT HAND SECOND ROW SEAT BELT. *YC

NTB97028

Service Bulletin/Repair Instructions

DIAGNOSTIC PROCEDURE FOR P0731, P0732 & P0733 (A/T SIGNALS) WITH NO DRIVEABILITY INCIDENTS. *JD

NTB97020

Service Bulletin/Repair Instructions

STEERING WHEEL RADIO CONTROL. *JD

Reading this report

Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.

1997 Nissan Quest Service Bulletins: 54 bulletins | CarFathom