EA05012 · EA
SEATS:MID/REAR ASSEMBLY Investigation
THE SEAT ADJUSTMENT MECHANISM CONTAINS EXPOSED MOVING COMPONENTS, LOCATED AT THE REAR EDGE OF THE SECOND ROW SEAT.WHEN THE OPERATOR ATTEMPTS TO ADJUST THE SEAT, A FINGER MAY BE PINCHED IN THE MOVING SEAT ADJUSTMENT MECHANISM.NISSAN WILL CONDUCT A SAFETY RECALL ON AN EXPANDED SCOPE OF NISSAN QUEST VEHICLES.ON VEHICLES PRODUCED FROM MARCH 26, 2003 THROUGH SEPTEMBER 26, 2005, NISSAN WILL RIVET A PLASTIC REINFORCEMENT TO THE BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL THREE TIE-DOWNS AND INSTALL A FLANGE TO THE INBOARD SIDE SHIELD.ON VEHICLES PRODUCED FROM MARCH 26, 2003 THROUGH JUNE 28, 2004, IN ADDITION TO THE ABOVE CORRECTIVE ACTIONS, NISSAN WILL REPLACE THE INBOARD SECOND ROW SEAT ADJUSTMENT HANDLE WITH THE CURRENT PRODUCTION SEAT LEVER. NISSAN NORTH AMERICA, INC. WILL RECALL 109,437 MY 2004-2005 NISSAN QUEST VEHICLES PRODUCED FROM MARCH 26, 2003 THROUGH SEPTEMBER 26, 2005.ODI IS AWARE OF A TOTAL OF 11 COMPLAINTS, FIELD REPORTS AND WARRANTY CLAIMS REPORTING 11 FINGER INJURIES.THE RECALL IS IDENTIFIED BY NHTSA NUMBER 05V474.
PE05019 · PE
SEATS:MID/REAR ASSEMBLY Investigation
ODI HAS RECEIVED FIVE REPORTS ALLEGING THAT THE CONSUMER WAS INJURED USING THE VEHICLE'S SECOND-ROW SEAT RELEASE LEVER TO FOLD THE SECOND ROW SEAT.NISSAN STATES, ...THE CUSTOMER OPERATION OF THE LEVER IN SOME CASES AND SUBSEQUENT ORIENTATION OF THEIR FINGERS IS DIFFERENT THAN EXPECTED.NISSAN ALSO REPORTED ADDITIONAL COMPLAINTS FOR A TOTAL OF 11 INJURIES.NISSAN MODIFIED THE LEVER FOR PRODUCTION TWICE.THE LATEST (SECOND MODIFICATION) DESIGN PROVIDES A LARGER SIZED HANDLE THAT CONTAINS A CUP INTO WHICH THE SEAT OCCUPANT CAN PLACE THEIR FINGERS TO OPERATE THE ADJUSTMENT LEVER.NISSAN REPORTS NO INJURIES ASSOCIATED WITH THE CUP DESIGN LEVER.BEGINNING JUNE 2004, NISSAN INITIATED A CUSTOMER SATISFACTION INITIATIVE THAT INCLUDED REPLACING THE ORIGINAL DESIGN HANDLE WITH THE FIRST MODIFICATION HANDLE (THIS IS NOT THE CUP DESIGN HANDLE MENTIONED ABOVE).THE INVESTIGATION HAS BEEN UPGRADED TO AN ENGINEERING ANALYSIS (EA05-012) TO ALLOW FURTHER ANALYSIS OF THE ISSUE.
PE04027 · PE
LATCHES/LOCKS/LINKAGES:DOORS:LATCH Investigation
IN JANUARY 2004, NISSAN RECEIVED REPORTS OF POWER SLIDING DOORS COMING OPEN WHILE DRIVING.NISSAN DETERMINED THAT AT TEMPERATURES BELOW 40 DEGREE F, AN OUT-OF-SPEC DOOR ACTUATOR COULD BIND AND PREVENT THE DOOR LATCHES FROM FULLY ENGAGING.THIS CAN LEAD TO THE DOOR COMING OPEN UNEXPECTEDLY.NISSAN NOTIFIED NHTSA BY LETTER DATED APRIL 1, 2004, THAT IT IS CONDUCTING A SAFETY RECALL CAMPAIGN (NHTSA NO. 04V186) ON MY 2004 NISSAN QUEST VEHICLES WITH POWER-SLIDING DOORS PRODUCED FROM MARCH 26, 2003 TO DECEMBER 17, 2003.NISSAN MODIFIED THE ACUTATOR DOOR MOTOR ON VEHICLES BUILT AFTER DECEMBER 17, 2003 FOR REASONS NOT RELATED TO THE INADVERTENT DOOR OPENING ISSUE.NISSAN REPORTS THAT VEHICLES BUILT AFTER DECEMBER 17, 2003 ARE NOT SUBJECT TO THE FAILURE MODE THAT CAUSES INADVERTENT OPENING.ODI'S REVIEW OF THE ODI OWNER REPORTS WITH KNOWN BUILD DATES (7 OF 9 REPORTS, PLUS ONE REPORT RECEIVED PRIOR TO DEC 17 BUT WITH UNKNOWN BUILD DATE) INDICATES THAT COMPLAINT VEHICLES WERE MANUFACTURED BEFORE THE DOOR ACTUATOR IMPROVEMENT DATE (DEC 17).ALSO, NISSAN REPORTS NO COMPLAINT VEHICLES WITH BUILD DATES AFTER DECEMBER 17.NISSAN'S ACTION ADDRESSES THE CONCERNS OF ODI.THEREFORE, THIS INVESTIGATION IS CLOSED.