LI5179R1
Service Bulletin/Repair Instructions
installation of new pressure regulator for retarder interlock. Obsolete part replacement
Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
LI5179R1
installation of new pressure regulator for retarder interlock. Obsolete part replacement
LI5179
Installation of new pressure regulator for interlock retarder. Obsolete part replacement
LI5180
Installation of new pressure regulator for interlock retarder. Obsolete part replacement.
LI3978E
Information about the engine coolant. Coolant types should not be mixed in the engine.
LI5011E
Recommendations on the disinfection of vehicles as well as products and precautions to be taken.
APS4896E
Introduction of a new steering gearbox without the lubrication zerk.
LI4432ER1
TRW has eliminated from service procedure TAS-103 the greasing of the steering gearbox output shaft.
LI1911ER1
ZF wheel head suspension. ZF introduced an optimized axial roller bearing. Replace the axial roller bearing and lower seal ring with an optimized roller bearing.
LI3446ER5
INTRODUCING NEW HARDWARE AND INSTALLATION PROCEDURE FOR PITMAN ARM. (R5 UPDATED THE TORQUE VALUE IN PROCEDURE LINE 1.9)
li3446er5
Introducing new hardware and installation procedure for Pitman arm. (R5 updated the torque value in procedure line 1.9)
BS3419E
The wiper motor cannot be stopped by the driver.
LI3446ER4
INTRODUCING NEW HARDWARE AND INSTALLATION PROCEDURE FOR PITMAN ARM.
LI3446ER2
Introducing new hardware and installation procedure for Pitman arm. (R2 revision is for: Road number and VIN has been updated for L860 TTC)
LI1953E
Moisture may accumulate in the space under the driver's seat and cause corrosion of the power steering hydraulic fittings and piping.
LI3188
A new radius rod bolt torque is now in effect.
LI2116E
Diagnose a potentiel Bendix disk brake thermal overload.
LI1636AR2
The stainless steel structure of certain vehicles, with an offset engine, might have been subject to certain constraints which may cause cracking
LI1636AR1
The stainless steel structure of certain vehicles, with an offset engine, might have been subject to certain constraints which may cause cracking
LI1841ER3
Repair procedure of the front beam box
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.