Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
37868.1.0
This is a TJ - Text plus 1 Instruction AttachmentTJI-537279-2_1_3.pdf and 1 .mov- If a customer complains on a grinding noise from SWM area when using the indicator lever, follow advice under Service. If the noise is the same as the attached sound file TJ_37868_1.mov, follow the instruction according to the attachment VCC-537279_2_1_3.
37894.1.0
This is a TJ - Text Only - No attachments - If the software version displayed in the CSD is not aligned with the actual software version installed in the vehicle (this may occur after a failed software download), and no Total Upgrade is available in VIDA, follow the instructions under "Service". Note! Do not replace any parts. A software product is available to align the software version in the CSD with the actual software version installed in the vehicle. Use "manual order" as Software Product is not visible in VIDA.
37772.2.0
This is a TJ - text only - no attachments - If the vehicle cannot engage any gear, and both DTCs P0AA800 and P127900are present, Confirm that all criteria specified in the "Description" section are fulfilled. follow advice under "Service".
37724.1.0
This is a TJ, Text plus 1 attachment - If customer complains that there is a visible molding line on the rear roof cover, follow advice under "Service". See attachment. lease, do not replace any parts for the symptom described in this TJ. This is a molding line and not a damage.
SP1082
The concern with stabilizer is low torque on the bolts for the stabilizer bar link. This may cause noise from the front suspension. Polestar has decided that all cars, concerned by this QB, shall be modified in accordance with this QB, at first workshop visi
37246
This is a TJ Text plus 1 .jpg - Before replacing any parts, follow the instructions below. 1. Follow VIDA instructions on how to dismantle the tailgate lamp (VCC-527817-1). 2. Check the wiring. If the cable is damaged or the tailgate switch batch number is earlier than 250808 (see reference TJ37247_1.jpg), replace the part.
37247
This is a TJ Text - plus 1 attachment a .png file - If the tailgate is hard to open with the switch button from outside, follow advise under Service. 1.Follow VIDA instructions on how to dismantle the tailgate lamp (VCC-527817-1). 2. Check the tailgate switch according to attachment (TJ_37247_1.png), to see if there is a white cover inside. *3. Check the tailgate switch batch number according to attachment (TJ37247_2.jpg). If the switch is from a batch earlier than 250808 replaced the part.
37493
This is a TJ - Text only - No attachment - If there are any issues with downloading WAM (Wide-Angle Vision Module) during software download, Please follow the advice under “Service”
37542
This is a TJ - Text plus 1 PDF attachment TJI-533465-1_1_4 If a customer complains on a creaking / ticking noise from steering wheel module (SWM) area when turning the steering wheel, follow advice under Service. As described in the TJI attachment
37447
This is a TJ - Text Only - No attachment - If customer complains of vibration through steering in low speed follow advice under "Service".
37627
This is a TJ - text only no attachment - If the customer experiences unexpected dust accumulation inside the rear door, see information under service. When the door is opened, the lower pressure inside the cabin causes dust from outside the molding to flow into the cabin. This will not be solved by replacing parts.
35811
This is a Technical Journal: Polestar Bellow noise If a noise occurs from the front drive shaft bellows during slow driving and/or turning (e.g., parking maneuvers), follow the instructions under “Service”.
37113
This is a TJ + Text plus 2 attachments - If the Polestar emblem in the front bumper is not in the correct position and it has been established that the bracket inside the bumper holding the emblem is loose according to attachment "T_J37113_1.pdf", follow the attached repair method "TJI-530080-1_1_0_en-US.pdf".
37643
This is a TJ - Text + 1 Attachment If customer complains that there is a wavy surface on the bottom door molding in a specific area or/or angle follow advice under "Service".Please, Do not replace any parts for the symptom described in this TJ.
37644
This is a TJ - + 1 pptx attachment If customer complains that there is a visible on the rear roof cover Please, Do not replace any parts for the symptom described in this TJ. This is a molding line and not damage
37336
This is a Technical Journal: Wind noise front side window. Before replacing any parts, follow the checklist below. 1. Check the calibration of the window. If needed, recalibrate the window. follow the 4 additional steps as stated in the Tech Journal where necessary
37431
This is a Technical Journal: PS No Start After Failed OTA Installation. Do not replace any parts. To recover the CEM, download SP 80026889, "OTA RESTORE". After this has been installed, confirm that the car can now be started and driven. *Ensure that the car has the latest software by following TJ-35361
37280
This is a Technical Journal: Unable to Unlock the Car via Keyfob or NFC. . Remove and install the fuse of VGM to see if it solves the issue. If not, proceed to step 2. 2. Disconnect the 12V battery to see if this resolves the issue. If not, proceed to step 3. 3. Replace VGM.
37396
This is a Technical Journal: Window and Glass Claim Information Request. Submit a TIE report.
37064
This is a Technical Journal: Tow Bar Folding Issues. Check if terminal 1 and 6 cable color combination is correctly installed.
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.