IS-23019A
Service Bulletin/Repair Instructions
Sway bar collars improvement. Revision A : Add front sway bar support replacement and change bolts lenght.
Vehicle report
2006 PREVOST H3-45
Service bulletins
49 bulletinsTechnical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
IS-23019
Service Bulletin/Repair Instructions
SWAY BAR COLLARS IMPROVEMENT
IS-22106
Service Bulletin/Repair Instructions
H3 LAVATORY FAN RETROFIT KIT
IS-21072B
Service Bulletin/Repair Instructions
STEERING GATEWAY. Revision B - PIN 2 and 10 were inverted on connector A139
MI22-12B
Service Bulletin/Repair Instructions
Air Tanks Draining Sequence. Revision: B - General Update
MI22-12A
Service Bulletin/Repair Instructions
Air Tanks Draining Sequence. Revision: A - Erroneous Secondary & Accessory tanks location.
MI22-12
Service Bulletin/Repair Instructions
Air Tanks Draining Sequence
IS-17151C
Service Bulletin/Repair Instructions
Halogen to LED fog light replacement kit. Revision: C - Advanced kits canceled
IS20-925A
Service Bulletin/Repair Instructions
CENTRAL HVAC MERV FILTERS INSTALLATION
IS-20925A
Service Bulletin/Repair Instructions
CENTRAL HVAC MERV FILTERS INSTALLATION REVA
MI20-08C
Service Bulletin/Repair Instructions
STORAGE AND STARTUP GUIDELINES: Periodically, circumstances arise requiring operators to temporarily park a coach in storage. Whether it is a few weeks or several months, sporadic out of service times or a full stop, Prevost recommends following the guidelines in this document during times when: ⢠The coach can be operated on a regular/weekly basis while in storage. ⢠The coach will be in storage for an extended period without any operation. ⢠The coach will return to service following an extended period of downtime.
IS-18091A
Service Bulletin/Repair Instructions
TIE ROD 610052 FIRST INSTALLATION INSTRUCTIONS: Use these instructions when replacing the drop joint tie rod on S82, S84 / S84U I-beam axles. The new tie rod will be adjusted to the length of the original; however, a steering alignment needs to be performed after replacement.
MI20-19A
Service Bulletin/Repair Instructions
Rev A: Mention added concerning DDC Series 60 engine SCA requirement
MI20-19
Service Bulletin/Repair Instructions
INTRODUCING A NEW ENGINE COOLANT INTO SERVICE
MI02-17A
Service Bulletin/Repair Instructions
Revision : A Torque value reduced
IS-19165A
Service Bulletin/Repair Instructions
LAVATORY FAN RETROFIT KIT Applicable for H3 Series coaches from R-1012 (1994) Revision A: Added installation detail at step 8
SCi20-16
Service Bulletin/Repair Instructions
FAN CLUTCH PLATE BOLTS RE-TORQUING
IS-20923
Service Bulletin/Repair Instructions
H3 DRIVERâS PARTITION LITE INSTALLATION
IS-20922
Service Bulletin/Repair Instructions
SIGMA PASSENGER SEATS PARTITION KIT
MI20-08B
Service Bulletin/Repair Instructions
STORAGE AND STARTUP GUIDELINES Revision: B Parts added to Suggested Material 08-10-2020
P040200
Service Bulletin/Repair Instructions
Engine Exhaust Gas Recirculation Differential Pressure - Mechanical system not responding properly US13 â US20 Emissions
MI20-12
Service Bulletin/Repair Instructions
JERKY, NOISY OR HARD TO TURN STEERING GEARBOX. HYDRAULIC END LIMITER ADJUSTMENT. All models â equipped with RB Bosch/ZF Servocom or Servocomtronic steering gearbox
MI20-08A
Service Bulletin/Repair Instructions
STORAGE AND STARTUP GUIDELINES: Rev A: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed 611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
IS-20905
Service Bulletin/Repair Instructions
HAND SANITIZER DISPENSER INSTALLATION
MI20-09
Service Bulletin/Repair Instructions
PREVOST VEHICLE DISINFECTION PROCEDURE
MI20-08
Service Bulletin/Repair Instructions
STORAGE AND STARTUP GUIDELINES - ALL PREVOST VEHICLES & VOLVO 9700
MI15-24
Service Bulletin/Repair Instructions
Added: Power cables for L.H. side alternator & fan drive breaker box
IS-14076
Service Bulletin/Repair Instructions
This instruction sheets explains how to replace the fuel tank on H-series vehicles. (Replacing older series tanks by newer model)
MI19-32
Service Bulletin/Repair Instructions
This Maintenance Information explains how to install harness #7770134, designed to bypass the Engine Compartment Harness (Prevost part), connecting the DPF harness (10-pin connector) and the Engine Harness (31-pin connector).
IS-18091
Service Bulletin/Repair Instructions
This Instruction Sheet explains how to perform the first installation of Tie Rod 610052 on Prevost vehicles equipped with Dana S82, S84 / S84U I-beam axles, 1994- today
IS-19915
Service Bulletin/Repair Instructions
MP-1000 MULTIMEDIA PLAYER INSTALLATION
MI18-45A
Service Bulletin/Repair Instructions
Vehicles identified below are compatible with a new tie rod design. This new tie rod 610052 has updated ball joints and a fine adjuster sleeve. It replaces former drop type ball joint tie rods. Refer to IS-18091 for installation instructions. This document details maintenance inspection and toe-in adjustment with the new design tie rod.
IS-17910A
Service Bulletin/Repair Instructions
MESSAGE CENTER DISPLAY (MCD) REPLACEMENT
IS-19916
Service Bulletin/Repair Instructions
This instruction sheet explains how to install the Audio Converter 405842
IS-08006A
Service Bulletin/Repair Instructions
This instruction sheet explains how to relocate engine door gas spring.
IS-08006
Service Bulletin/Repair Instructions
This instruction sheet explains how to relocate engine door gas spring.
SCI17-35
Service Bulletin/Repair Instructions
This internal instruction explains how to bench program the FMS gateway module used in the ELD (Electronic Logging Device) interface kit for pre-OBD13 vehicles.
IS-16903
Service Bulletin/Repair Instructions
This instruction sheet explains how to replace the two older generation (brush type) condenser fans by four newer style (brushless) fans.
IS-11003D
Service Bulletin/Repair Instructions
This Instruction sheet explains how to remplace MASTER ID? WITH ?MCM? MODULE
SCI09-28
Service Bulletin/Repair Instructions
PREVOST: INSTALLING THREE-POINT PASSENGER SEAT RESTRAINT SYSTEM. THE PURPOSE OF THE FOLLOWING PROCEDURE IS TO FACILITATE THE JOB AND TO HELP IDENTIFY THE DIFFICULT AREAS. ALSO INCLUDED MODELS HE-41 AND HE-45 COACHES MODEL YEARS 1998-2008; MODEL XLII AND X3-45 COACHES MODEL YEARS 1998-2008. *JS
MI08-04
Service Bulletin/Repair Instructions
FRONT AND TAG AXLE HUB BEARING AND KING PIN PERIODIC MAINTENANCE. BEARINGS MUST BE INSPECTED AT INTERVALS OF 30,000 MILES (48 000KM). KING PINS SHOULD BE SERVICED EVERY 6, 250 MILES (10,000 KM) OR TWICE A YEAR. ALSO INCLUDED MODEL VIP-45 MTH MODEL YEARS 2004-2008. MODEL XLII MTH MODEL YEARS 2004-2008. *JS
WB08-02A
Service Bulletin/Repair Instructions
POWER WINDOW HARNESS- REMOVAL OF ZENER SUPPRESSOR DIODES. A FAULTY DIODE WILL CAUSE THE BURNING OF THE FUSE PROTECTING THE CIRCUIT. ALSO INCLUDED MODEL XLII-40, XLII-45 MOTORHOMES & ENTERTAINER XLII-45. MODEL YEARS 2007-2008. MODEL VIP MOTORHOMES. MODEL YEARS 2006-2007. *JS
WB08-07
Service Bulletin/Repair Instructions
IMPROVED AIR CIRCULATION ON H3 COACHES EQUIPPED WITH WCL AND SLIDING DOOR. IN ORDER TO IMPROVE THE PASSENGERS COMFORT IT IS NECESSARY TO INCREASE THE AIR CIRCULATION IN THE OVERHEAD COMPARTMENT AS WELL AS BEHIND THE WHEELCHAIR LIFT DOOR. *JS
0708
Service Bulletin/Repair Instructions
DECAL REPLACEMENT IN THE MAIN POWER COMPARTMENT. *KB
WB07-08
Service Bulletin/Repair Instructions
PREVOST: REPLACE DECAL IN THE MAIN POWER COMPARTMENT. CB11 WAS CHANGED FROM 35A TO 50A. *JS
0705
Service Bulletin/Repair Instructions
REMOVAL OF ZF TRANSMISSION NEUTRAL POSITION RELAY ON H3 MULTIPLEX VEHICLES. *KB
WB07-05
Service Bulletin/Repair Instructions
PREVOST: REMOVE ZF TRANSMISSION NEUTRAL POSITION RELAY ON H3 MULTIPLEX VEHICLES. RELAY INDICATING THAT ZF TRANSMISSION IS IN NEUTRAL POSITION MUST BE REMOVED TO AVOID FUSE BURNING AND TO BE STANDARDIZED WITH OTHER VEHICLES. *JS
0703
Service Bulletin/Repair Instructions
PREVOST - INSTALLING DECAL WARNING AGAINST PERFORMING ANY WELDING WORK. *NJ
MI07-06
Service Bulletin/Repair Instructions
PREVOST: NEW FIXING HARDWARE FOR THE REAR HEIGHT CONTROL VALVE LINK ROD. THERE IS A POSSIBILTY THAT THE LINK ROD THAT CONNECTS THE HEIGHT CONTROL VALVE TO THE DRIVE AXELS SUPPORT FRAME COMES APART WHEN THE VEHICLE IS MOVING. MODEL VIP-45MTH MODEL YEAR 2004 ALSO INCLUDED. *JS
Reading this report
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.