MI22-12B
Service Bulletin/Repair Instructions
Air Tanks Draining Sequence. Revision: B - General Update
Vehicle report
2008 PREVOST WE
Service bulletins
32 bulletinsTechnical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
MI22-12A
Service Bulletin/Repair Instructions
Air Tanks Draining Sequence. Revision: A - Erroneous Secondary & Accessory tanks location.
MI22-12
Service Bulletin/Repair Instructions
Air Tanks Draining Sequence
MI20-08C
Service Bulletin/Repair Instructions
STORAGE AND STARTUP GUIDELINES : part number updates
IS20-925A
Service Bulletin/Repair Instructions
CENTRAL HVAC MERV FILTERS INSTALLATION
MI20-19A
Service Bulletin/Repair Instructions
Rev A: Mention added concerning DDC Series 60 engine SCA requirement
MI20-19
Service Bulletin/Repair Instructions
INTRODUCING A NEW ENGINE COOLANT INTO SERVICE
MI20-12
Service Bulletin/Repair Instructions
JERKY, NOISY OR HARD TO TURN STEERING GEARBOX. HYDRAULIC END LIMITER ADJUSTMENT. All models â equipped with RB Bosch/ZF Servocom or Servocomtronic steering gearbox
MI20-08A
Service Bulletin/Repair Instructions
STORAGE AND STARTUP GUIDELINES: Rev A: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed 611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
MI20-09
Service Bulletin/Repair Instructions
PREVOST VEHICLE DISINFECTION PROCEDURE
MI20-08
Service Bulletin/Repair Instructions
STORAGE AND STARTUP GUIDELINES - ALL PREVOST VEHICLES & VOLVO 9700
MI15-24
Service Bulletin/Repair Instructions
Added: Power cables for L.H. side alternator & fan drive breaker box
IS-11003G
Service Bulletin/Repair Instructions
This Instruction sheet explains how to replace the ?MASTER ID? WITH ?MCM? Module
IS-11003F
Service Bulletin/Repair Instructions
This Instruction sheet explains how to replace the "MASTER ID WITH MCM" Module
SCI17-35
Service Bulletin/Repair Instructions
This internal instruction explains how to bench program the FMS gateway module used in the ELD (Electronic Logging Device) interface kit for pre-OBD13 vehicles.
IS-11003E
Service Bulletin/Repair Instructions
This Instruction sheet explains how to remplace MASTER ID? WITH ?MCM? Module
IS-17901
Service Bulletin/Repair Instructions
This instructions sheet explains how to program a Wabco Smart Trac ABS ECU.
MI16-15B
Service Bulletin/Repair Instructions
The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
IS-11003D
Service Bulletin/Repair Instructions
This Instruction sheet explains how to remplace MASTER ID? WITH ?MCM? MODULE
MI16-22
Service Bulletin/Repair Instructions
Use this maintenance information procedure to resolve an undesired behaviour on 2008-2012 vehicles. In sleep mode, certain marker lights may remain illuminated.
MI16-15A
Service Bulletin/Repair Instructions
The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
Mi16-15
Service Bulletin/Repair Instructions
The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
WB15-44A
Service Bulletin/Repair Instructions
On the vehicles affected by this bulletin, the equipment used to tighten the wheel lugs in a visit to one of our Service Center between November 2014 and June 2015, was found to be out of specification, possibly delivering a torque value inferior to the specified 450 to 500 ft-lb (610 to 680 Nm). Please verify and correct as necessary the wheel lug torque on the concerned vehicles, or bring the vehicle at a Prevost Service Center for verification at your earliest convenience.
IS-11003A
Service Bulletin/Repair Instructions
This Instruction sheet explains how to replace MASTER ID? WITH ?MCM? MODULE
MI15-18
Service Bulletin/Repair Instructions
This Maintenance Information does explain how five year old vehicles and older should be subjected to a thorough structural inspection.
IS-14130
Service Bulletin/Repair Instructions
This Instruction Sheet explains how to use Retrofit kit for obsoleted small AC condensers (950018 & 950335)
IS-13158
Service Bulletin/Repair Instructions
This Instruction Sheet explains how to install Keyless Keypad using either kit 069140 or 069141
WB13-64B
Service Bulletin/Repair Instructions
On the vehicles affected by this bulletin, an inspection of the exhaust gas diffuser is necessary. Refer to Part 1 of this bulletin for the inspection procedure. If the inspection procedure reveals that the diffuser rain cap is not functioning properly, replace the diffuser assembly (see Part 2).
SP13-44
Service Bulletin/Repair Instructions
The light switch may operate incorrectly when doors are closed for vehicles affected by this bulletin. Corrective action is presented.
MI13-33
Service Bulletin/Repair Instructions
This Maintenance Information explains that polyester reinforced silicone hoses and elbowscan be repalced by aramid reinforced hoses and elbows for improved long term durability, and that constant torque hose clamps for silicone hoses with 5/8po, 3/4po, 7/8po, 1 1/8po and 1 3/8po inside diameter (I.D) can be replaced by new WAVE SEAL type constant torque hose clamps.
SCI12-46A
Service Bulletin/Repair Instructions
This procedure will guide you through the steps required to relocate the evaporator filters on Le Mirage XL-II Entertainers. The heating coil in the evaporator compartment should be drained from coolant and some work and assembly is required on the filter box prior to carrying out the actual modification on the vehicle.
MI1240
Service Bulletin/Repair Instructions
On the vehicles affected, the Delco 50DN alternator may generate a voltage variation when engine is shutting down. A new circuit and a time delay function can be added to the system to provide protection.
Reading this report
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.