MI22-12B
Service Bulletin/Repair Instructions
Air Tanks Draining Sequence. Revision: B - General Update
Vehicle report
2010 PREVOST WE
Service bulletins
52 bulletinsTechnical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
MI22-12A
Service Bulletin/Repair Instructions
Air Tanks Draining Sequence. Revision: A - Erroneous Secondary & Accessory tanks location.
MI22-12
Service Bulletin/Repair Instructions
Air Tanks Draining Sequence
IS-22902
Service Bulletin/Repair Instructions
TAG AXLE HUB FLANGE - ALTERNATE CAP SCREW
MI20-08C
Service Bulletin/Repair Instructions
STORAGE AND STARTUP GUIDELINES : part number updates
IS21-072A
Service Bulletin/Repair Instructions
STEERING GATEWAY Revision A Cancel watch dog removal from EFD part of the instruction
IS21-901
Service Bulletin/Repair Instructions
X3 SERIES ENVIROCARE - IONS AIR SANITIZER
IS20-925A
Service Bulletin/Repair Instructions
CENTRAL HVAC MERV FILTERS INSTALLATION
MI18-16B
Service Bulletin/Repair Instructions
BOSCH HD10 ALTERNATOR DIAGNOSTIC GUIDE Revision B To avoid replacement of alternators that are in fact in good working order, perform the steps which follow to help you perform a more precise diagnosis.
MI21-06
Service Bulletin/Repair Instructions
Diesel Exhaust Fluid ( DEF ) Contamination In Fuel System, Inspection And Repair â From US10 to newer engine generation
Mi21-07A
Service Bulletin/Repair Instructions
RONT & TAG AXLE â UNITIZED HUB BEARING END PLAY VERIFICATION AND REPLACEMENT
MI20-19A
Service Bulletin/Repair Instructions
Rev A: Mention added concerning DDC Series 60 engine SCA requirement
MI20-19
Service Bulletin/Repair Instructions
INTRODUCING A NEW ENGINE COOLANT INTO SERVICE
MI20-12
Service Bulletin/Repair Instructions
JERKY, NOISY OR HARD TO TURN STEERING GEARBOX. HYDRAULIC END LIMITER ADJUSTMENT. All models â equipped with RB Bosch/ZF Servocom or Servocomtronic steering gearbox
MI20-08A
Service Bulletin/Repair Instructions
STORAGE AND STARTUP GUIDELINES: Rev A: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed 611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
MI20-09
Service Bulletin/Repair Instructions
PREVOST VEHICLE DISINFECTION PROCEDURE
MI20-08
Service Bulletin/Repair Instructions
STORAGE AND STARTUP GUIDELINES - ALL PREVOST VEHICLES & VOLVO 9700
MI15-24
Service Bulletin/Repair Instructions
Added: Power cables for L.H. side alternator & fan drive breaker box
IS-17905A
Service Bulletin/Repair Instructions
This instruction sheet explains how to install an ELD interface kit on Pre-OBD Prevost Vehicles equipped with Volvo D13 Engines
IS-11003G
Service Bulletin/Repair Instructions
This Instruction sheet explains how to replace the ?MASTER ID? WITH ?MCM? Module
IS-13009D
Service Bulletin/Repair Instructions
This instruction sheet explains how to install and adjust drag link # 660699
IS-11003F
Service Bulletin/Repair Instructions
This Instruction sheet explains how to replace the "MASTER ID WITH MCM" Module
IS-13009C
Service Bulletin/Repair Instructions
This instruction sheet explains how to install and adjust drag link # 660699
IS-17910
Service Bulletin/Repair Instructions
This instruction sheet explains how to replace the message center display (MCD)
IS12010
Service Bulletin/Repair Instructions
This instruction sheet explains how to replace the left bell crank using kit 161349
IS-15003E
Service Bulletin/Repair Instructions
This insruction Sheet explains how to insall the Bosch HD10 24v-150a Alternator Conversion Kit ? Twin Bosch Mounted On Volvo D13 Engine
MI16-17G
Service Bulletin/Repair Instructions
This Maintenance Information explains how to remove and install the Bosch HD10 (120A or 150A) alternators
MI18-16A
Service Bulletin/Repair Instructions
This Maintenance Information presents guidelines to help with the diagnosis of the Bosch HD10 alternators
MI16-17F
Service Bulletin/Repair Instructions
This Maintenance Information explains how to remove and install the Bosch HD10 (120A or 150A) alternators
IS-17905
Service Bulletin/Repair Instructions
This instruction sheet explains how to install an ELD interface kit on Pre-OBD Prevost Vehicles equipped with Volvo D13 Engines
IS-13009B
Service Bulletin/Repair Instructions
This instruction sheet explains how to install and adjust drag link # 660699
SCI17-35
Service Bulletin/Repair Instructions
This internal instruction explains how to bench program the FMS gateway module used in the ELD (Electronic Logging Device) interface kit for pre-OBD13 vehicles.
IS-11003E
Service Bulletin/Repair Instructions
This Instruction sheet explains how to remplace MASTER ID? WITH ?MCM? Module
IS-17901
Service Bulletin/Repair Instructions
This instructions sheet explains how to program a Wabco Smart Trac ABS ECU.
IS-15003D
Service Bulletin/Repair Instructions
This insruction Sheet explains how to insall the Bosch HD10 24v-150a Alternator Conversion Kit ? Twin Bosch Mounted On Volvo D13 Engine
MI16-17E
Service Bulletin/Repair Instructions
This Maintenance Information explains how to remove and install the Bosch HD10 (120A or 150A) alternator.
IS-15003B
Service Bulletin/Repair Instructions
This instruction sheet explains how to use the Bosch HD10 24V-150A Alternator Conversion Kit
MI16-15B
Service Bulletin/Repair Instructions
The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
IS-11003D
Service Bulletin/Repair Instructions
This Instruction sheet explains how to remplace MASTER ID? WITH ?MCM? MODULE
MI16-22
Service Bulletin/Repair Instructions
Use this maintenance information procedure to resolve an undesired behaviour on 2008-2012 vehicles. In sleep mode, certain marker lights may remain illuminated.
MI16-15A
Service Bulletin/Repair Instructions
The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
Mi16-15
Service Bulletin/Repair Instructions
The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
MI16-16
Service Bulletin/Repair Instructions
This procedure explains how to perform a STARTER REMOVAL AND INSTALLATION, and does apply to Melco 105P70 starter part number #21212425.
IS-11003A
Service Bulletin/Repair Instructions
This Instruction sheet explains how to replace MASTER ID? WITH ?MCM? MODULE
MI15-18
Service Bulletin/Repair Instructions
This Maintenance Information does explain how five year old vehicles and older should be subjected to a thorough structural inspection.
IS-15003A
Service Bulletin/Repair Instructions
This instruction sheet explains how to use the Bosch HD10 24V-150A Altenrator Conversion Kit
SP13-44
Service Bulletin/Repair Instructions
The light switch may operate incorrectly when doors are closed for vehicles affected by this bulletin. Corrective action is presented.
MI13-33
Service Bulletin/Repair Instructions
This Maintenance Information explains that polyester reinforced silicone hoses and elbowscan be repalced by aramid reinforced hoses and elbows for improved long term durability, and that constant torque hose clamps for silicone hoses with 5/8po, 3/4po, 7/8po, 1 1/8po and 1 3/8po inside diameter (I.D) can be replaced by new WAVE SEAL type constant torque hose clamps.
MI13-06
Service Bulletin/Repair Instructions
This Maintenance Information explains that hose clamps with a smaller diameter are available to increase the adjustment range at the upper and lower radiator flexible connections and at the oil cooler connections located under the turbocharger.
SCI12-46A
Service Bulletin/Repair Instructions
This procedure will guide you through the steps required to relocate the evaporator filters on Le Mirage XL-II Entertainers. The heating coil in the evaporator compartment should be drained from coolant and some work and assembly is required on the filter box prior to carrying out the actual modification on the vehicle.
WB12-31B
Service Bulletin/Repair Instructions
On the vehicles affected by this bulletin, a new and improved dipstick is available for installation.
IS11015B
Service Bulletin/Repair Instructions
This Instruction Sheet explains how to replace power relay p/n 561991 with improved power relay p/n 564218 and relay base p/n 564210
Reading this report
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.