Vehicle report
Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
MI26-00
The gasket thickness was increased from 1.5 mm to 3 mm to prevent interference between the collar ends, which previously made it impossible to reach the specified tightening torque. Increasing the gasket thickness ensures sufficient clearance between the collar ends and thus guarantees optimal tightening.
IS-23019A
Sway bar collars improvement. Revision A : Add front sway bar support replacement and change bolts lenght.
IS-23019
SWAY BAR COLLARS IMPROVEMENT
IS-22050
Motion Sensor Relocation
EC0026_B
On the vehicles affected by this bulletin, the Vehicle Emission Control Information label must be replaced. Revision: B - Causal part changed, was 010352, becomes 85152363. No impact on procedure or parts involved.
SP22-314 CO 20
On the vehicles affected by this bulletin, install a driver seat orange belt in replacement of the black one.
SP23-301
On the vehicles affected by this bulletin, the steering dampers and related hardware must be inspected and may need to be replaced by new improved units.
IS-20051
Driver's barrier installation instructions
IS-21072B
STEERING GATEWAY. Revision B - PIN 2 and 10 were inverted on connector A139
MI22-12B
Air Tanks Draining Sequence. Revision: B - General Update
MI22-12A
Air Tanks Draining Sequence. Revision: A - Erroneous Secondary & Accessory tanks location.
MI22-12
Air Tanks Draining Sequence
SP22-303
On the vehicles affected by this bulletin, the positive terminal (main power cable) may not be fully tightened at the back some the alternators.
IS-22902
TAG AXLE HUB FLANGE - ALTERNATE CAP SCREW
SP22-304
TAG AXLE AIR SPRING RUBBING ISSUE â INSTALLATION OF NON-RETURN VALVE
SP22-306
Wheelchair lift system sliding door adjustment
MI20-08C
STORAGE AND STARTUP GUIDELINES : part number updates
WB22-07
TGW PROGRAMMING
IS21-072A
STEERING GATEWAY Revision A Cancel watch dog removal from EFD part of the instruction
IS21-901
X3 SERIES ENVIROCARE - IONS AIR SANITIZER
IS20-925A
CENTRAL HVAC MERV FILTERS INSTALLATION
IS22-040
BRAKE PEDAL SEAL PLATE INSTALLATION KIT
IS21-072
STEERING GATEWAY schematic
IS19-108
Surge tank pressure cap replacement
SP22-300B
DRIVER WINDOW BREAKING SOLUTION
SP21-313
WIPER INTERACTION WITH ENGINE SHUT DOWN On the vehicles affected by this bulletin, perform the following procedure. This will solve the following issue: when turned OFF, the engine keeps running if the wipers are ON
MI21-13A
An automated test is available to check the big HVAC superheat from the driver seat. This test is controlled by Multiplex, eliminating interventions and the need to take measures on the vehicle.
wb21-09
INTERFERENCE BETWEEN THE WIPER ARM AND THE WIPER BLADE
SP21-310
INTERFERENCE BETWEEN THE WIPER ARM AND THE WIPER BLADE
SP21-309
SNOW CHAIN SYSTEM â LOOSE FITTINGS
IS-20925A
CENTRAL HVAC MERV FILTERS INSTALLATION REVA
SP21-302
NYCT & MTA - LOOSE CEILING PANEL REWORK
MI20-19A
Rev A: Mention added concerning DDC Series 60 engine SCA requirement
MI21-01
VOLVO I-SHIFT TRANSMISSION REPLACEMENT - DIFFERENCE BETWEEN CONNECTIONS AT THE TOP OF THE OIL FILTER HOUSING
MI20-19
INTRODUCING A NEW ENGINE COOLANT INTO SERVICE
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.