SUZ_016008
Service Bulletin/Repair Instructions
Reminder of the importance to conduct safety inspections for rust damage to suspension and related parts that could be caused by road salt or other chemicals applied to the roadway.
Vehicle report
2007 SUZUKI RENO
Service bulletins
9 bulletinsTechnical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
N-Q-G-045
Service Bulletin/Repair Instructions
This Service Bulletin was sent by Suzuki Motor Corporation to its authorized Suzuki automobile distributors in the U.S., explaining the importance of proper inspection and maintenance of suspension lower arm ball joints to prevent the ball stud from becoming separated from the suspension lower arm.
SUZ_013175
Service Bulletin/Repair Instructions
THIS SERVICE BULLETIN UPDATES A BULLETIN ORIGINALLY ISSUED ON MAY 18, 2016, CONCERNING A SPECIAL WARRANTY EXTENSION (ZH) FOR 2005-2008 SUZUKI FORENZA AND SUZUKI RENO VEHICLES. THE UPDATES ARE: (1) THE EXISTENCE OF DIAGNOSTIC TROUBLE CODE (DTC) B1379 IS ADDED TO THE LIST OF DTCS THAT MAKE A VEHICLE ELIGIBLE FOR REPAIR UNDER SPECIAL WARRANTY EXTENSION ZH; AND (2) THE PROCEDURE FOR INSPECTING THE SEAT HEIGHT ADJUSTER FOR DAMAGE HAS BEEN CLARIFIED.
TS-30-06263
Service Bulletin/Repair Instructions
SUZUKI: SUZUKI HAS REPLACEMENT OIL PUMPS THAT HAVE A THREADED PLUG. THE THREADED PROVES TO BE DIFFICULT TO REMOVE WITHOUT CAUSING DAMAGE TO THE NEW OIL PUMP. THIS BULLETIN PROVIDES PROCEDURES WHEN REPLACING THE OLD OIL PUMP. *JS
TB-22-02041R
Service Bulletin/Repair Instructions
SUZUKI VEHICLE: COUNTER MEASURE PROCEDURE FOR DTC P2135. MIL LIGHT IS ON; DTC P2135 STORED WITHOUT FULLY CHECKING SYSTEM AND CIRCUITS AFTER REPAIRS AND/OR REPLACEMENT TO THROTTLE BODY. *PE
TSB-23-06110
Service Bulletin/Repair Instructions
SUZUKI VEHICLES: COUNTER MEASURE PROCEDURE FOR DTC P2138. MIL LIGHT IS ON, DTC P2138 STORED. FAILURE OF THE CONNECTOR AND/OR WIRING CIRCUITS BETWEEN THE ECM AND THE ACCELERATOR PEDAL POSITION SENSOR. MODELS FORENZA, FORENZA WAGON AND RENO (RQ420). *PE
TS0601238
Service Bulletin/Repair Instructions
REQUIRED AUTOMATIC TRANSMISSION CONTROL MODULE INITIALIZATION PROCEDURE. MY 2004-2008 FORENZ SEDAN/WAGON, RENO (RQ420). *NJ
0812177
Service Bulletin/Repair Instructions
P0441 OR P0496 (EVAPORATIVE EMISSION SYSTEM CONTINUOUS PURGE FLOW). *NJ
0508157
Service Bulletin/Repair Instructions
MANUAL TRANSMISSION SHIFT LINKAGE ADJUSTMENT. *NJ
Reading this report
Complaint counts are reports filed with NHTSA, not failure rates. A common model collects more of them than a rare one that breaks more often.