Technical service bulletins are instructions a manufacturer sent its dealers about a known fault. They are not recalls and the work is usually not free, but they are the clearest signal of a problem the manufacturer already knows about.
SB2501
Service Bulletin/Repair Instructions
The control arms of the front and trailing axles are equipped with a flexible ball-joint at the chassis side. Van Hool has several suppliers for the repair kit of this flexible ball-joint. All of the repair kits contain a flexible ball-joint, a spacer and a snap ring. Due to not equal thickness of the spacer in the different kits, it is important to install all three the kit parts when replacing a flexible ball-joint. Do not mix parts of different repair kits!
SB2497
Service Bulletin/Repair Instructions
Mobile column lifts raise the vehicle under the wheels. This service bulletin is a reminder about the usage of mobile column lifts when lifting a complete vehicle.
SB2262B
Service Bulletin/Repair Instructions
TO CHECK EMERGENCY SIDE WINDOW OPERATION To ensure trouble-free operation, the emergency side windows must be checked on a regular basis. This will allow you to confirm the proper operation of the emergency exit handle and unlatching mechanism, as well as the proper installation and function of the window seals
SB2494
Service Bulletin/Repair Instructions
INTRODUCTION The purpose of this service bulletin is to inform you about the removal and installation of Raufoss line fittings
SB2468
Service Bulletin/Repair Instructions
Van Hool recently changed-over in production to a “longer” articulation shaft (VH11717611) to fasten the wheel-suspension arms to the steering knuckle carrier/hub carrier. Field experience has shown that this change-over has a positive impact on the lifespan of the rubber bushings. The “longer” articulation shaft may be used with the M18 as well as with the M20 fastening system (refer to figures 2 and 3).
SB2372B
Service Bulletin/Repair Instructions
This service bulletin provides you with information about the location of emergency side window decals so that the vehicle meets the National Highway Traffic Safety Administration’s (NHTSA) Federal Motor Vehicle Safety Standards (FMVSS) in the U.S and the Canadian Motor Vehicle Safety Standards (CMVSS) in Canada about this subject.
SB2372a
Service Bulletin/Repair Instructions
This service bulletin provides you with information about the location of emergency side window decals so that the vehicle meets the National Highway Traffic Safety Administration’s (NHTSA) Federal Motor Vehicle Safety Standards (FMVSS) in the U.S and the Canadian Motor Vehicle Safety Standards (CMVSS) in Canada about this subject.
SB2372
Service Bulletin/Repair Instructions
This service bulletin provides you with information about the location of emergency side window decals so that the vehicle meets the National Highway Traffic Safety Administrationâs (NHTSA) Federal Motor Vehicle Safety Standards (FMVSS) in the U.S and the Canadian Motor Vehicle Safety Standards (CMVSS) in Canada about this subject.
SB2386
Service Bulletin/Repair Instructions
Van Hool has received a letter from Ventura, manufacturer of door systems, stating that they have recently received complaints on a regular basis about the door panel not being secured to the lower door shaft lever. A situation that can involve serious risks to passengers if they lean against the door panel while driving. Investigation has shown that all these complaints are the result of an incorrectly installed or missing blocking piece (1, figure 1) at the level of the lower door shaft lever in combination with poor maintenance and/or incorrect adjustment of the door system, and sometimes even the use of non-original replacement parts. For this reason, Ventura would like to draw attention to the already âhighlightedâ chapters in their manuals that describe the operation and importance of this blocking piece in the door system. It also states that these parts must be checked every 3 months.
SB2401
Service Bulletin/Repair Instructions
Van Hool has received a letter from Ventura, manufacturer of door systems, stating that they have recently received complaints on a regular basis about the door panel not being secured to the lower door shaft lever. A situation that can involve serious risks to passengers if they lean against the door panel while driving. Investigation has shown that all these complaints are the result of an incorrectly installed or missing blocking piece (1, figure 1) at the level of the lower door shaft lever in combination with poor maintenance and/or incorrect adjustment of the door system, and sometimes even the use of non-original replacement parts. For this reason, Ventura would like to draw attention to the already âhighlightedâ chapters in their manuals that describe the operation and importance of this blocking piece in the door system. It also states that these parts must be checked every 3 months.
SB2255
Service Bulletin/Repair Instructions
Service Information: In its production process, Bock, manufacturer of refrigerant compressors, has switched to a new type of motor protection switch for the electric motor of the refrigerant compressor. As the MP10 motor protection switch (VH11472802) is no longer made available as a spare part, as of now you will receive the new INT69G motor protection switch (VH11691810) when ordering. The MP10 and the INT69G are interchangeable, but fastening and electric connection are different.
SB1709
Service Bulletin/Repair Instructions
Product Improvement: ALL VEHICLES WITH LIGHT-ALLOY WHEELS - Introduction of wheel-end monitoring system (WEM). Van Hool has released a wheel-end monitoring system (WEM) which can be installed on all vehicles equipped with light-alloy wheels. The WEM is installed at the outboard side of the wheel and monitors vibrations produced by the wheel bearing. It warns in case of bearing raceway spalling by flashing a red LED on the unit. The WEM is delivered with a magnet which is used to change from "transport" to "standstill" mode.
SB1856
Service Bulletin/Repair Instructions
Service Information - Maintenance operations related to refrigerant compressor oil This service information bulletin is a reminder/update about refrigerant compressor oil maintenance. To ensure a reliable system, it is important to perform the maintenance on a regular base as mentioned further on.
SB2039A
Service Bulletin/Repair Instructions
Service Information - Introduction of new 4/2 solenoid valve in compressed-air circuit Van Hool has switched over into production to a new type of 4/2 solenoid valve in the compressed-air system. As the previous Knorr-Bremse (Bosch) solenoid valve (VH11102170) is no longer made available as spare part, customers will receive a Wabco solenoid valve (VH660526759) when ordering. Both valves are interchangeable, but some differences must be considered. Consult the information in this service bulletin for a proper installation.
SB2039
Service Bulletin/Repair Instructions
SERVICE INFORMATION BULLETIN: Van Hool has switched over into production to a new type of 4/2 solenoid valve in the compressed-air system. As the previous Knorr-Bremse (Bosch) solenoid valve (VH11102170) is no longer made available as spare part, you will receive a Wabco solenoid valve (VH660526759) when ordering. Both valves are interchangeable, but some differences must be considered. Consult the information in this service bulletin for a proper installation.
SB1961
Service Bulletin/Repair Instructions
Service Information Bulletin: What to do in case of prolonged vehicle standstill. This service bulletin provides an overview of works to be performed during prolonged vehicle standstill.
WP1319
Service Bulletin/Repair Instructions
Work Procedure: Optimization of DEF installation (corrective) This procedure has been released to assist in successfully optimizing the Diesel Exhaust Fluid (DEF) installation.
WP1328
Service Bulletin/Repair Instructions
Work Procedure: To charge parameters into controller of hydraulic fan-drive (informative) The purpose of this procedure is to provide information on how to charge parameters into controller of hydraulic fan-drive.
WP1315
Service Bulletin/Repair Instructions
Work Procedure: This procedure has been released to assist successfully optimizing the engine air intake installation between the turbocharger and the charge-air-cooler (corrective).
MIC-VANH-090820
Service Bulletin/Repair Instructions
Van Hool N.V. and ABC Companies did not release any new service bulletins during the month of August 2020.
SB1702
Service Bulletin/Repair Instructions
Service information Bulletin: Stress-free installation of flex pipe This service bulletin gives step-by-step instructions on how to install the flex pipe properly. The flexible part of the flex pipe handles thermal expansion and engine vibration, and is prone to premature breakdown in case of incorrect installation.
SB1777
Service Bulletin/Repair Instructions
Service Information: This bulletin is being released as a reminder of the importance of wheel bearing preventive maintenance. Check the wheel bearing end-play every 50,000 miles*, and when having any work done on the brakes or any other component on the axle end.
SB1796
Service Bulletin/Repair Instructions
Service Information: he purpose of this service bulletin is to inform you about the innocent traces of lubricant at the bottom of the transmission bell housing on new vehicles. They are caused by the protective anti-corrosion coating at the inside of the bell housing which becomes liquid at transmission operating temperature. This phenomenon is temporarily and no indication that there is a sealing problem! The lubricant can easily be removed with ordinary cleaning product.
SB1634
Service Bulletin/Repair Instructions
Product Improvement. Introduction of new single check valves in cooling-circuits deaeration lines.Van Hool have recently switched over into production a new type of single check valve. Contrary to the previous type equipped with a plastic housing, the new type comprises an aluminium housing. Because of this, they are better suited to resist higher coolant temperatures. As the new type can also be used on previoulsy sold vehicles, only the new type will be available as a spare part. This service bulletin applies to All Van Hool Vehicles.
SB1645
Service Bulletin/Repair Instructions
To remove/install wheel-nut caps. Some vehicles have plastic chrome-coloured wheel-nut caps on top of the wheel nuts. This service bulletin gives instructions on how to remove/install these wheel-nut caps correctly.